arXiv subjects

Patrick Winkel

Publications and source records attributed to Patrick Winkel.

22 records · Page 2Linked to original sources

arXiv2019

Onset of phase diffusion in high kinetic inductance granular aluminum micro-SQUIDs

Superconducting granular aluminum is attracting increasing interest due to its high kinetic inductance and low dissipation, favoring its use in kinetic inductance particle detectors, superconducting resonators or quantum bits. We perform switching current measurements on DC-SQUIDs, obtained by introducing two identical geometric constrictions in granular aluminum rings of various normal-state resistivities in the range from $ρ_\mathrm{n} = 250\,μΩ\mathrm{cm}$ to $5550\,μΩ\mathrm{cm}$. The relative high kinetic inductance of the SQUID loop, in the range of tens of nH, leads to a suppression of the modulation in the measured switching current versus magnetic flux, accompanied by a distortion towards a triangular shape. We observe a change in the temperature dependence of the switching current histograms with increasing normal-state film resistivity. This behavior suggests the onset of a diffusive motion of the superconducting phase across the constrictions in the two-dimensional washboard potential of the SQUIDs, which could be caused by a change of the local electromagnetic environment of films with increasing normal-state resistivities.

cond-mat.supr-con↗

arXiv2018

Interplay between kinetic inductance, non-linearity and quasiparticle dynamics in granular aluminum MKIDs

Microwave kinetic inductance detectors (MKIDs) are thin film, cryogenic, superconducting resonators. Incident Cooper pair-breaking radiation increases their kinetic inductance, thereby measurably lowering their resonant frequency. For a given resonant frequency, the highest MKID responsivity is obtained by maximizing the kinetic inductance fraction $α$. However, in circuits with $α$ close to unity, the low supercurrent density reduces the maximum number of readout photons before bifurcation due to self-Kerr non-linearity, therefore setting a bound for the maximum $α$ before the noise equivalent power (NEP) starts to increase. By fabricating granular aluminum MKIDs with different resistivities, we effectively sweep their kinetic inductance from tens to several hundreds of pH per square. We find a NEP minimum in the range of $25\; \text{aW}/\sqrt{\text{Hz}}$ at $α\approx 0.9$, which results from a tradeoff between the onset of non-linearity and a non-monotonic dependence of the noise spectral density vs. resistivity.

cond-mat.supr-con↗

arXiv2018

Granular aluminum: A superconducting material for high impedance quantum circuits

Superconducting quantum information processing machines are predominantly based on microwave circuits with relatively low characteristic impedance, of about 100 Ohm, and small anharmonicity, which can limit their coherence and logic gate fidelity. A promising alternative are circuits based on so-called superinductors, with characteristic impedances exceeding the resistance quantum $R_Q = 6.4$ k$Ω$. However, previous implementations of superinductors, consisting of mesoscopic Josephson junction arrays, can introduce unintended nonlinearity or parasitic resonant modes in the qubit vicinity, degrading its coherence. Here we present a fluxonium qubit design using a granular aluminum (grAl) superinductor strip. Granular aluminum is a particularly attractive material, as it self-assembles into an effective junction array with a remarkably high kinetic inductance, and its fabrication can be in-situ integrated with standard aluminum circuit processing. The measured qubit coherence time $T_2^R$ up to 30 $μ$s illustrates the potential of grAl for applications ranging from protected qubit designs to quantum limited amplifiers and detectors.

cond-mat.supr-con↗

arXiv2014

Magnetotransport in ferromagnetic Mn5Ge3, Mn5Ge3C0.8, and Mn5Si3C0.8 thin films

The electrical resistivity, anisotropic magnetoresistance (AMR), and anomalous Hall effect of ferromagnetic Mn5Ge3, Mn5Ge3C0.8, and Mn5Si3C0.8 thin films has been investigated. The data show a behavior characteristic for a ferromagnetic metal, with a linear increase of the anomalous Hall coefficient with Curie temperature. While for ferromagnetic Mn5Si3C0.8 the normal Hall coefficient R0 and the AMR ratio are independent of temperature, these parameters strongly increase with temperature for the germanide films. This difference is attributed to the different hybridization of electronic states in the materials due different lattice parameters and different atomic configurations (Ge vs. Si metalloid). The concomitant sign change of R0 and the AMR ratio with temperature observed for the germanide films is discussed in a two-current model indicating an electron-like minority-spin transport at low temperatures.

cond-mat.mes-hall↗