arXiv subjects

Peng Hu

Publications and source records attributed to Peng Hu.

137 records · Page 8Linked to original sources

arXiv2018

Designing topological interface states in phononic crystals based on the full phase diagrams

The topological invariants of a periodic system can be used to define the topological phase of each band and determine the existence of topological interface states within a certain bandgap. Here, we propose a scheme based on the full phase diagrams, and design the topological interface states within any specified bandgaps. As an example, here we propose a kind of one-dimensional phononic crystals. By connecting two semi-infinite structures with different topological phases, the interface states within any specific bandgap or their combinations can be achieved in a rational manner. The existence of interface states in a single bandgap, in all odd bandgaps, in all even bandgaps, or in all bandgaps, are verified in simulations and experiments. The scheme of full phase diagrams we introduce here can be extended to other kinds of periodic systems, such as photonic crystals and designer plasmonic crystals.

physics.app-ph↗

arXiv2017

Demonstration of Laser-produced Neutron Diagnostic by Radiative Capture Gamma-rays

We report a new scenario of time-of-flight (TOF) technique in which fast neutrons and delayed gamma-ray signals were both recorded in a millisecond time window in harsh environments induced by high-intensity lasers. The delayed gamma signals, arriving far later than the original fast neutron and often being ignored previously, were identified to be the results of radiative captures of thermalized neutrons. The linear correlation between gamma photon number and the fast neutron yield shows that these delayed gamma events can be employed for neutron diagnosis. This method can reduce the detecting efficiency dropping problem caused by prompt high-flux gamma radiation, and provides a new way for neutron diagnosing in high-intensity laser-target interaction experiments.

physics.ins-det↗

arXiv2016

Limitations of empirical sediment transport formulas for shallow water and their consequences for swash zone modelling

Volumetric sediment concentrations computed by phase-resolving swash morphodynamic models are shown to exceed unity minus porosity (i.e. the maximal physically possible concentration value) by up to factor of $10^5$ when using standard expressions to compute the sediment transport rate. An ad hoc limit of sediment concentration is introduced as a means to evaluate consequences of exceeding physically realistic concentration by standard expressions. We find that implementation of this ad hoc limit strongly changes the quantitative and qualitative predictions of phase-resolving swash morphodynamic models, suggesting that existing swash predictions are unreliable. This is because standard expressions inappropriately consider or ignore the fact that the shallow swash water depth limits the storage capacity of transported sediment.

physics.ao-ph↗

arXiv2016

Boundary feedback stabilization of Fisher's equation

The aim of this work is to design an explicit finite dimensional boundary feedback controller for locally exponentially stabilizing the equilibrium solutions to Fisher's equation in both $L^2(0,1)$ and $H^1(0,1)$. The feedback controller is expressed in terms of the eigenfunctions corresponding to unstable eigenvalues of the linearized equation. This stabilizing procedure is applicable for any level of instability, which extends the result of \cite{02} for nonlinear parabolic equations. The effectiveness of the approach is illustrated by a numerical simulation.

math.OC↗

arXiv2015

Modeling of Breaching Due to Overtopping Flow and Waves Based on Coupled Flow and Sediment Transport

Breaching of earthen or sandy dams/dunes by overtopping flow and waves is a complicated process with strong, unsteady flow, high sediment transport, and rapid bed changes in which the interactions between flow and morphology should not be ignored. This study presents a depth-averaged two-dimensional (2D) coupled flow and sediment transport model to investigate the flow and breaching processes with and without waves. Bed change and variable flow density are included in the flow continuity and momentum equations to consider the impacts of sediment transport. The model adopts the non-equilibrium approach for total-load sediment transport and specifies different repose angles to handle non-cohesive embankment slope avalanching. The equations are solved using an explicit finite volume method on a rectangular grid with the improved Godunov-type central upwind scheme and the nonnegative reconstruction of the water depth method to handle mixed-regime flows near the breach. The model has been tested against two sets of experimental data which show that it well simulates the flow characteristics, bed changes, and sediment transport. It is then applied to analyze flow and morphologic changes by overtopping flow with and without waves. The simulated bed change and breach cross-section shape show a significant difference if waves are considered. Erosion by flow without waves mainly occurs at the breach and is dominated by vertical erosion at the initial stage followed by the lateral erosion. With waves, the flow overtops the entire length of the dune to cause faster erosion along the entire length. Erosion mainly takes place at the upper layer at the initial stage and gradually accelerates as the height of the dune reduces and flow discharge increases, which indicates the simulated results with waves shall be further verified by physical experimental evidence.

physics.flu-dyn↗

arXiv2015

A System Architecture for Software-Defined Industrial Internet of Things

Wireless sensor networks have been a driving force of the Industrial Internet of Things (IIoT) advancement in the process control and manufacturing industry. The emergence of IIoT opens great potential for the ubiquitous field device connectivity and manageability with an integrated and standardized architecture from low-level device operations to high-level data-centric application interactions. This technological development requires software definability in the key architectural elements of IIoT, including wireless field devices, IIoT gateways, network infrastructure, and IIoT sensor cloud services. In this paper, a novel software-defined IIoT (SD-IIoT) is proposed in order to solve essential challenges in a holistic IIoT system, such as reliability, security, timeliness scalability, and quality of service (QoS). A new IIoT system architecture is proposed based on the latest networking technologies such as WirelessHART, WebSocket, IETF constrained application protocol (CoAP) and software-defined networking (SDN). A new scheme based on CoAP and SDN is proposed to solve the QoS issues. Computer experiments in a case study are implemented to show the effectiveness of the proposed system architecture.

cs.NI↗

arXiv2015

Is it appropriate to model turbidity currents with the three-equation model?

The three-equation model (TEM) was developed in the 1980s to model turbidity currents (TCs) and has been widely used ever since. However, its physical justification was questioned because self-accelerating TCs simulated with the steady TEM seemed to violate the turbulent kinetic energy balance. This violation was considered as a result of very strong sediment erosion that consumes more turbulent kinetic energy than is produced. To confine bed erosion and thus remedy this issue, the four-equation model (FEM) was introduced by assuming a proportionality between the bed shear stress and the turbulent kinetic energy. Here we analytically proof that self-accelerating TCs simulated with the original steady TEM actually never violate the turbulent kinetic energy balance, provided that the bed drag coefficient is not unrealistically low. We find that stronger bed erosion, surprisingly, leads to more production of turbulent kinetic energy due to conversion of potential energy of eroded material into kinetic energy of the current. Furthermore, we analytically show that, for asymptotically supercritical flow conditions, the original steady TEM always produces self-accelerating TCs if the upstream boundary conditions ("ignition" values) are chosen appropriately, while it never does so for asymptotically subcritical flow conditions. We numerically show that our novel method to obtain the ignition values even works for Richardson numbers very near to unity. Our study also includes a comparison of the TEM and FEM closures for the bed shear stress to simulation data of a coupled Large Eddy and Discrete Element Model of sediment transport in water, which suggests that the TEM closure might be more realistic than the FEM closure.

physics.geo-ph↗

arXiv2014

Well-balanced and flexible morphological modeling of swash hydrodynamics and sediment transport

Existing numerical models of the swash zone are relatively inflexible in dealing with sediment transport due to a high dependence of the deployed numerical schemes on empirical sediment transport relations. Moreover, these models are usually not well-balanced, meaning they are unable to correctly simulate quiescent flow. Here a well-balanced and flexible morphological model for the swash zone is presented. The nonlinear shallow water equations and the Exner equation are discretized by the shock-capturing finite volume method, in which the numerical flux and the bed slope source term are estimated by a well-balanced version of the SLIC (Slope LImited Centered) scheme that does not depend on empirical sediment transport relations. The satisfaction of the well-balanced property is demonstrated through simulating quiescent coastal flow. The quantitative accuracy of the model in reproducing key parameters (i.e., the notional shoreline position, the swash depth, the flow velocity, the overtopping flow volume, the beach change depth and the sediment transport rate) is shown to be satisfactory through comparisons against analytical solutions, experimental data as well as previous numerical solutions. This work facilitates an improved modeling framework for the swash hydrodynamics and sediment transport.

physics.ao-ph↗

arXiv2011

Prediction and optimization of the performance of parabolic solar dish concentrator with sphere receiver using analytical function

Parabolic solar dish concentrator with sphere receiver is less studied. We present an analytic function to calculate the intercept factor of the system with real sun bright distribution and Gaussian distribution, the results indicate that the intercept factor is related to the rim angle of reflector and the ratio of open angle of receiver at the top of reflector to optical error when the optical error is larger than or equal to 5 mrad, but is related to the rim angle, open angle and optical error in less than 5 mrad optical error. Furthermore we propose a quick process to optimize the system to provide the maximum solar energy to net heat efficiency for different optical error under typical condition. The results indicate that the parabolic solar dish concentrator with sphere receiver has rather high solar energy to net heat efficiency which is 20% more than solar trough and tower system including higher cosine factor and lower heat loss of the receiver.

physics.optics↗

arXiv2011

On the concentration properties of Interacting particle processes

These lecture notes present some new concentration inequalities for Feynman-Kac particle processes. We analyze different types of stochastic particle models, including particle profile occupation measures, genealogical tree based evolution models, particle free energies, as well as backward Markov chain particle models. We illustrate these results with a series of topics related to computational physics and biology, stochastic optimization, signal processing and bayesian statistics, and many other probabilistic machine learning algorithms. Special emphasis is given to the stochastic modeling and the quantitative performance analysis of a series of advanced Monte Carlo methods, including particle filters, genetic type island models, Markov bridge models, interacting particle Markov chain Monte Carlo methodologies.

math.NA↗

arXiv2010

Snell envelope with path dependent multiplicative optimality criteria

We analyze the Snell envelope with path dependent multiplicative optimality criteria. Especially for this case, we propose a variation of the Snell envelope backward recursion which allows to extend some classical approxima- tion schemes to the multiplicatively path dependent case. In this framework, we propose an importance sampling particle approximation scheme based on a specific change of measure, designed to concentrate the computational effort in regions pointed out by the criteria. This new algorithm is theoritically studied. We provide non asymptotic convergence estimates and prove that the resulting estimator is high biased.

math.NA↗