arXiv subjects

Peng Sheng

Publications and source records attributed to Peng Sheng.

5 recordsLinked to original sources

arXiv2021

Thermal Contribution in the Electrical Switching Experiments with Heavy Metal / Antiferromagnet Structures

We examine the thermal origin of the detected "saw-tooth" shaped Hall resistance (Rxy) signals in the spin-orbit torque switching experiment for antiferromagnetic MnN. Compared with the results of the heavy metal / antiferromagnet bilayers (MnN/Ta), the qualitatively same "saw-tooth" shaped signals also appear in the samples with the heavy metal layer alone (either Ta or Pt) without MnN layer. In addition, The Rxy signal changes oppositely in the devices with Ta and Pt, due to the opposite temperature coefficient of resistivity (TCR) of the two materials. All those results are consistent with the "localized Joule heating" mechanism in devices with Hall crosses geometry. Moreover, by utilizing a structure with separated writing current paths and Hall cross area, the quadratic relationship between delta-Rxy and the writing current's amplitude is observed, which provides quantitative evidence of the thermal contribution. These results reveal the dominant thermal artifact in the widely used Hall crosses geometry for Neel vector probing, and also provide a strategy to semi-quantitatively evaluate the thermal effect, which can shed light on a more conclusive experiment design.

cond-mat.mes-hall↗

arXiv2021

Surface Acoustic Wave induced modulation of tunneling magnetoresistance in magnetic tunnel junctions

We show that a surface acoustic wave (SAW) applied across the terminals of a magnetic tunnel junction (MTJ) decreases both the (time-averaged) parallel and antiparallel resistances of the MTJ, with the latter decreasing much more than the former. This results in a decrease of the tunneling magnetoresistance (TMR) ratio. The coercivities of the free and fixed layer of the MTJ, however, are not affected significantly, suggesting that the SAW does not cause large-angle magnetization rotation in the magnetic layers through the inverse magnetostriction (Villari) effect at the power levels used. This study sheds light on the dynamical behavior of an MTJ under periodic compressive and tensile strain.

cond-mat.mes-hall↗

arXiv2017

Electric field modulation of the non-linear areal magnetic anisotropy energy

We study the ferromagnetic layer thickness dependence of the voltage-controlled magnetic anisotropy (VCMA) in gated CoFeB/MgO heterostructures with heavy metal underlayers. When the effective CoFeB thickness is below ~1 nm, the VCMA efficiency of Ta/CoFeB/MgO heterostructures considerably decreases with decreasing CoFeB thickness. We find that a high order phenomenological term used to describe the thickness dependence of the areal magnetic anisotropy energy can also account for the change in the areal VCMA efficiency. In this structure, the higher order term competes against the common interfacial VCMA, thereby reducing the efficiency at lower CoFeB thickness. The areal VCMA efficiency does not saturate even when the effective CoFeB thickness exceeds ~1 nm. We consider the higher order term is related to the strain that develops at the CoFeB/MgO interface: as the average strain of the CoFeB layer changes with its thickness, the electronic structure of the CoFeB/MgO interface varies leading to changes in areal magnetic anisotropy energy and VCMA efficiency.

cond-mat.mtrl-sci↗

arXiv2016

The Spin Nernst effect in Tungsten

The spin Hall effect allows generation of spin current when charge current is passed along materials with large spin orbit coupling. It has been recently predicted that heat current in a non-magnetic metal can be converted into spin current via a process referred to as the spin Nernst effect. Here we report the observation of the spin Nernst effect in W. In W/CoFeB/MgO heterostructures, we find changes in the longitudinal and transverse voltages with magnetic field when temperature gradient is applied across the film. The field-dependence of the voltage resembles that of the spin Hall magnetoresistance. A comparison of the temperature gradient induced voltage and the spin Hall magnetoresistance allows direct estimation of the spin Nernst angle. We find the spin Nernst angle of W to be similar in magnitude but opposite in sign with its spin Hall angle. Interestingly, under an open circuit condition, such sign difference results in spin current generation larger than otherwise. These results highlight the distinct characteristics of the spin Nernst and spin Hall effects, providing pathways to explore materials with unique band structures that may generate large spin current with high efficiency.

cond-mat.mes-hall↗

arXiv2015

Spin Hall magnetoresistance in metallic bilayers

Spin Hall magnetoresistance (SMR) is studied in metallic bilayers that consist of heavy metal (HM) layer and a ferromagnetic metal (FM) layer. We find nearly a ten-fold increase of SMR in W/CoFeB compared to previously studied HM/ferromagnetic insulator (FI) systems. The SMR increases with decreasing temperature despite the negligible change in the W layer resistivity with temperature. A model is developed to account for the absorption of the longitudinal spin current to the FM layer, one of the key characteristics of a metallic ferromagnet. We find that the model not only quantitatively describes the HM layer thickness dependence of SMR, allowing accurate estimation of the spin Hall angle and the spin diffusion length of the HM layer, but also can account for the temperature dependence of SMR by assuming a temperature dependent spin polarization of the FM layer. These results illustrate the unique role a metallic ferromagnetic layer plays in defining spin transmission across the HM/FM interface.

cond-mat.mes-hall↗