arXiv subjects

Peter Richter

Publications and source records attributed to Peter Richter.

8 recordsLinked to original sources

arXiv2025

Influence of doping on non-equilibrium carrier dynamics in graphene

Controlling doping is key to optimizing graphene for high-speed electronic and optoelectronic devices. However, its impact on non-equilibrium carrier lifetimes remains debated. Here, we systematically tune the doping level of quasi-freestanding epitaxial graphene on SiC(0001) via potassium deposition and probe its ultrafast carrier dynamics directly in the band structure using time- and angle-resolved photoemission spectroscopy (trARPES). We find that increased doping lowers both the peak electronic temperature and the cooling rate of Dirac carriers, which we attribute to higher electronic heat capacity and reduced phonon emission phase space. Comparing quasi-freestanding graphene with graphene on a carbon buffer layer reveals faster relaxation in the latter, likely due to additional phonon modes being available for heat dissipation. These findings offer new insights for optimizing graphene in electronic and photonic technologies.

cond-mat.mes-hall↗

arXiv2025

Growth dynamics of graphene buffer layer formation on ultra-smooth SiC(0001) surfaces

In this study the growth process of epitaxial graphene on SiC was investigated systematically. The transition from the initial buffer layer growth to the formation of the first monolayer graphene domains was investigated by various techniques: atomic force microscopy, low energy electron diffraction, low energy electron microscopy, Raman spectroscopy, scanning tunneling spectroscopy and scanning electron microscopy. The data show that the buffer layer formation goes along with a simultaneous SiC decomposition which takes place as a rapid step retraction of one specific type of SiC bilayer in good agreement with the step retraction model. Once the buffer layer coverage is completed, the resulting characteristic regular repeating terrace and step height pattern of one and two SiC bilayers turned out to be very stable against further SiC decomposition. The following initial growth of monolayer graphene domains occurs, interestingly, only along the two bilayer high terrace edges. This behavior is explained by a preferential SiC decomposition at the higher step edges and it has some potential for spatial graphene growth control. The corresponding earlier graphene growth on one terrace type can explain the different scanning tunneling spectroscopy nanoscale resistivities on these terraces.

cond-mat.mtrl-sci↗

arXiv2025

Identifying Electronic Doorway States in the Secondary Electron Emission from Layered Materials

We investigate the secondary low-energy electron emission induced by inelastic electron scattering from graphene and layered materials thereof. By applying a coincidence detection of the primary scattered and the emitted secondary electron we unravel pronounced resonance features otherwise overshadowed by the largely structureless secondary electron energy distribution. Supported by density functional theory calculations we show that these structures are the signature of prominent Feshbach resonances above the vacuum threshold which originate from interlayer states acting as a doorway state for electron emission. Remarkably, some of these doorway states open up only for samples with more than five layers.

cond-mat.mes-hall↗

arXiv2023

The Disagreement Problem in Faithfulness Metrics

The field of explainable artificial intelligence (XAI) aims to explain how black-box machine learning models work. Much of the work centers around the holy grail of providing post-hoc feature attributions to any model architecture. While the pace of innovation around novel methods has slowed down, the question remains of how to choose a method, and how to make it fit for purpose. Recently, efforts around benchmarking XAI methods have suggested metrics for that purpose -- but there are many choices. That bounty of choice still leaves an end user unclear on how to proceed. This paper focuses on comparing metrics with the aim of measuring faithfulness of local explanations on tabular classification problems -- and shows that the current metrics don't agree; leaving users unsure how to choose the most faithful explanations.

cs.LG↗

arXiv2023

Determination of the Spacing Between Hydrogen-Intercalated Quasi-Free-Standing Monolayer Graphene and 6H-SiC(0001) Using Total-Reflection High-Energy Positron Diffraction

We have investigated the structure of hydrogen-intercalated quasi-free-standing monolayer graphene (QFMLG) grown on 6H-SiC(0001) by employing total-reflection high-energy positron diffraction (TRHEPD). At least nine diffraction spots of the zeroth order Laue zone were resolved along <11-20> and three along <1-100>, which are assigned to graphene, SiC and higher order spots from multiple diffraction on both lattices. We further performed rocking curve analysis based on the full dynamical diffraction theory to precisely determine the spacing between QFMLG and the SiC substrate. Our study yields a spacing of d = 4.18(6)\r{A} that is in excellent agreement with the results from density-functional theory (DFT) calculations published previously.

cond-mat.mtrl-sci↗

arXiv2023

magnetoARPES: Angle Resolved Photoemission Spectroscopy with Magnetic Field Control

Angle-Resolved Photoemission Spectroscopy (ARPES) is a premier technique for understanding the electronic excitations in conductive, crystalline matter, in which the induced photocurrent is collected and dispersed in energy and angle of emission to reveal the energy- and momentum-dependent single particle spectral function $A(\mathbf{k},\omega)$. So far, ARPES in a magnetic field has been precluded due to the need to preserve the electron paths between the sample and detector. In this paper we report progress towards "magnetoARPES", a variant of ARPES that can be conducted in a magnetic field. It is achieved by applying a microscopic probe beam ($\lesssim$ 10 $\mu$m ) to a thinned sample mounted upon a special sample holder that generates magnetic field confined to a thin layer near the sample surface. In this geometry we could produce ARPES in magnetic fields up to around $\pm$ 100 mT. The magnetic fields can be varied from purely in-plane to nearly purely out-of-plane, by scanning the probe beam across different parts of the device. We present experimental and simulated data for graphene to explore the aberrations induced by the magnetic field. These results demonstrate the viability of the magnetoARPES technique for exploring symmetry breaking effects in weak magnetic fields.

cond-mat.str-el↗

arXiv2022

Pump-induced terahertz anisotropy in bilayer graphene

We investigate the intraband nonlinear dynamics in doped bilayer graphene in the presence of strong, linearly-polarized, in-plane terahertz fields. We perform degenerate pump-probe experiments with 3.4 THz fields on doped bilayer graphene at low temperature (12 K) and find that when the pump is co-polarized with the probe beam, the differential pump-probe signal is almost double that found in the cross-polarized case. We show that the origin of this pump-induced anisotropy is the difference in the average electron effective mass in the probe direction when carriers are displaced in k-space by the pump either parallel or perpendicular to the direction of the probe polarization. We model the system using both a simple semiclassical model and a Boltzmann equation simulation of the electron dynamics with phenomenological scattering and find good qualitative agreement with experimental results.

cond-mat.mes-hall↗

arXiv2015

Comparative Study of Optical and Magneto-Optical Properties of Normal, Disordered and Inverse Spinel Type Oxides

Co$_3$O$_4$, ZnFe$_2$O$_4$, CoFe$_2$O$_4$, ZnCo$_2$O$_4$, and Fe$_3$O$_4$ thin films were fabricated by pulsed laser deposition at high and low temperatures resulting in crystalline single-phase normal, inverse, as well as disordered spinel oxide thin films with smooth surface morphology. The dielectric function, determined by spectroscopic ellipsometry in a wide spectral range from 0.5 eV to 8.5 eV, is compared with the magneto-optical response of the dielectric tensor, investigated by magneto-optical Kerr effect (MOKE) spectroscopy in the spectral range from 1.7 eV to 5.5 eV with an applied magnetic field of 1.7 T. Crystal field, inter-valence and inter-sublattice charge transfer transitions, and transitions from O$_{2p}$ to metal cation 3d or 4s bands are identified in both the principal diagonal elements and the magneto-optically active off-diagonal elements of the dielectric tensor. Depending on the degree of cation disorder, resulting in local symmetry distortion, the magneto-optical response is found to be strongest for high crystal quality inverse spinels and for disordered normal spinel structure, contrary to the first principle studies of CoFe$_2$O$_4$ and ZnFe$_2$O$_4$. The results presented provide a basis for deeper understanding of light-matter interaction in this material system that is of vital importance for device-related phenomena and engineering.

cond-mat.mtrl-sci↗