Searcharxiv⌕ Search

arXiv subjects

Petr Nikrityuk

Publications and source records attributed to Petr Nikrityuk.

4 recordsLinked to original sources

Numerical Investigations on Bitumen Liberation from Oil Sands Lump

The dynamic liberation and digestion of viscous oil-solid aggregates under turbulent flow is a critical transport phenomenon in multiphase chemical processes, including slurry transport, soil remediation, and industrial extraction. A primary industrial application of this phenomenon is oil sands hydrotransport, where pipelines are widely utilized to simultaneously transport and extract bitumen from lump ore. However, optimizing operating conditions requires a fundamental understanding of the localized hydrodynamic mechanisms governing detachment. To address this, a three-dimensional (3D) Eulerian-Eulerian (E-E) CFD approach coupled with k-omega SST turbulence model has been utilized to investigate bitumen detachment dynamics from complex solid matrices. Six numerical cases were analyzed across lump diameters (D) of 4 and 5 cm and particle Reynolds numbers (Re_p) between 2000 and 4000. The simulation results reveal that bitumen liberation is a shear-driven process, occurring only when the shear stresses exerted by the flow on the lump surface exceed a critical threshold value. The bitumen liberation rate increases with higher Re_p and smaller D, due to enhanced local shear forces and reduced particle shielding. Based on these mechanistic insights, a novel semi-empirical shear-driven model was formulated. The proposed model demonstrates excellent predictive accuracy when validated against experimental liberation data, with an error less than 8.3%. Overall, these findings clarify the fluid-particle interactions governing bitumen detachment and offer a robust, physics-based tool for predicting recovery efficiency in industrial hydrotransport operations.

physics.flu-dyn↗

Impacts of flow velocity and microbubbles on water flushing in a horizontal pipeline

Water flushing to remove particle sediment is essential for safe and continuous transport of many industrial slurries through pipelines. An efficient flushing strategy may reduce water consumption and the cost associated with water usage, and help water conservation for sustainability. In this study, a computational fluid dynamics (CFD) model coupled with the kinetic theory of granular flow for the flushing process is presented. The CFD models were validated against field data collected from a coal slurry pipeline of 128 $km$ in length, 0.575~$m$ in diameter, achieving an average error of less than 15\% for outlet solid concentration over time. A parametric study evaluated the effects of water velocity (1.88-5.88~$m/s$), bubble size (50~$μm$, 150~$μm$, and 1000~$μm$) and bubble volume fraction (0.05-0.2) on flushing performance including pipeline cleanness, cleanness efficiency, and water consumption. The obtained outcomes indicate that higher water velocity is preferred and an increase in water velocity from $1.88~m/s$ to $5.88~m/s$ reduces the water consumption by $28\%$. Large bubbles may hinder the flushing process and increase the water consumption by $23\%$. Remarkably, small bubbles facilitates the flushing process and lead to $35\%$ reduction in water consumption. These effects are attributed to the turbulent characteristics in the pipelines in presence of microbubbles.

physics.flu-dyn↗

Numerical investigation on solids settling in a non-Newtonian slurry inside a horizontal flume

Slurry transportation is always crucial for many industrial processes. This study numerically investigates the settling behavior of multisize solid particles in a non-newtonian slurry inside a semicircular open channel (flume). The non-newtonian slurry is modelled using a three-dimensional (3D) unsteady Eulerian-Eulerian (E-E) model coupled with the Hershel-Bulkley (HB) rheological model. A detailed sensitivity analysis of drag models is performed to establish the solid-fluid interaction in the slurry flow. The numerical model is validated with the experimental data from the literature and shows a fair agreement. The validated model is used to simulate the settling behavior of the slurry in the flume. The mean particle diameter of the solid particles in the slurry is in the range of 75-296 $μ$m with a median diameter of 188 $μ$m. The effect of particle size distributions (PSDs), flume inclination, bubble size and bubble volume fraction on the particle settling inside the flume is investigated in the parametric study. The analysis of our results revealed that the settling of solids is significantly affected by PSDs in the open channel system. In particular, the increase in flume inclination progresses the settling and dissipation of fine and coarse particles, respectively. Additional simulations showed that the inception of bubbles influences the settling velocity of solids, which changes the settling behavior of multisize solids inside the flume. The presented study can be used as a valuable guideline for the optimisation of intermediate exclusion of water from thickened slurry in order to ensure the stability of tailing storage facility.

physics.flu-dyn↗

Size distribution of primary submicron particles and larger aggregates in solvent induced asphaltene precipitation

Asphaltene precipitation is a crucial phase separation phenomenon in the oil industry, especially in paraffinic froth treatment to extract bitumen from oil sands ores. This work reveals the formation of particles at 0.2 to 0.4 um in radius, defined as a primary sub-micron particle (PSMP), which is ubiquitous from diffusive mixing between asphaltene solution and any of 23 types of precipitants examined in our experiments. The yield and quantity of asphaltene particles are affected not only by the Hildebrand solubility parameter of the precipitants but also by the diffusion coefficients of the asphaltene solution and the precipitant. The Population Balance Model (PBM) with the Hildebrand solubility parameter has been used to model particle size distribution. Good agreement has been achieved between numerical predictions and the experimental data. It indicates that the colloid theory can describe the size distribution of PSMP and larger aggregates. Therefore, this study provides new insight into the mechanism for the dependence of yield and size distribution of the precipitated asphaltene particles on the composition of precipitants and adding inhibitors. Controlling of asphaltene yield and size distribution may be applied to the process of hydrocarbon separation or asphaltene precipitation prevention.

cond-mat.soft↗