SearcharxivSearch

arXiv subjects

Philipp M. Pelz

Publications and source records attributed to Philipp M. Pelz.

3 recordsLinked to original sources

Transverse quantum-state characterization of programmable electron optics

Programmable electron optics -- electronically controlled phase plates -- underpin proposals from dose-efficient phase imaging to shaped-electron X-ray sources, nearly all assuming a pure, fully coherent delivered wave whose purity has never been measured. Here we reconstruct the transverse density matrix of a microelectromechanical electrostatic spiral phase plate by mixed-state ptychography, from one four-dimensional STEM scan per state and without added hardware. The delivered beam is substantially mixed: its purity falls from approximately 0.47 to approximately 0.24 as the applied bias grows, inconsistent with a fixed lateral source-blur model, while the real-space coherence width stays near 1 nm. The same scans calibrate the device in situ, allow virtual orbital-angular-momentum sorting and, through a partial-coherence-aware transfer theory, indicate that purifying the output could improve dose efficiency roughly threefold. One acquisition thus becomes a quantum-state acceptance test for programmable electron optics, supplying the purity and coherence that emerging phase-plate and diffractive-imaging schemes assume but leave unquantified.

physics.optics

A single-projection three-dimensional reconstruction algorithm for scanning transmission electron microscopy data

Increasing interest in three-dimensional nanostructures adds impetus to electron microscopy techniques capable of imaging at or below the nanoscale in three dimensions. We present a reconstruction algorithm that takes as input a focal series of four-dimensional scanning transmission electron microscopy (4D-STEM) data. We apply the approach to a lead iridate, Pb$_2$Ir$_2$O$_7$, and yttrium-stabilized zirconia,Y$_{0.095}$Zr$_{0.905}$O$_2$ , heterostructure from data acquired with the specimen in a single plan-view orientation, with the epitaxial layers stacked along the beam direction. We demonstrate that Pb-Ir atomic columns are visible in the uppermost layers of the reconstructed volume. We compare this approach to the alternative techniques of depth sectioning using differential phase contrast scanning transmission electron microscopy (DPC-STEM) and multislice ptychographic reconstruction.

cond-mat.mtrl-sci

Real-time interactive 4D-STEM phase-contrast imaging from electron event representation data

The arrival of direct electron detectors (DED) with high frame-rates in the field of scanning transmission electron microscopy has enabled many experimental techniques that require collection of a full diffraction pattern at each scan position, a field which is subsumed under the name four dimensional-scanning transmission electron microscopy (4D-STEM). DED frame rates approaching 100 kHz require data transmission rates and data storage capabilities that exceed commonly available computing infrastructure. Current commercial DEDs allow the user to make compromises in pixel bit depth, detector binning or windowing to reduce the per-frame file size and allow higher frame rates. This change in detector specifications requires decisions to be made before data acquisition that may reduce or lose information that could have been advantageous during data analysis. The 4D Camera, a DED with 87 kHz frame-rate developed at Lawrence Berkeley National Laboratory, reduces the raw data to a linear-index encoded electron event representation (EER). Here we show with experimental data from the 4D Camera that linear-index encoded EER and its direct use in 4D-STEM phase contrast imaging methods enables real-time, interactive phase-contrast from large-area 4D-STEM datasets. We detail the computational complexity advantages of the EER and the necessary computational steps to achieve real-time interactive ptychography and center-of-mass differential phase contrast using commonly available hardware accelerators.

cond-mat.mtrl-sci