arXiv subjects

Phuc V. Trinh

Publications and source records attributed to Phuc V. Trinh.

12 recordsLinked to original sources

arXiv2026

Technical Report OFDM-Assisted Simultaneous Quantum and Classical THz Communications

The feasibility of cost-effective simultaneous quantum and classical communication (SQCC) transmitting both the quantum key and classical information via a superimposed coherent state is investigated both in optical and Terahertz (THz) bands. Since the existing THz SQCC schemes assume single-carrier (SC) transmission over flat fading channels, we embark on investigating SQCC in realistic frequency-selective multipath THz fading channels. We then propose an orthogonal frequency division multiplexing (OFDM) based SQCC system for time-invariant frequency-selective THz scenarios, supported by low-density parity-check coded (LDPC) multidimensional QKD reconciliation schemes. Our simulation results demonstrate that the OFDM-based SQCC scheme is capable of achieving a practical secret key rate (SKR) over a wide range of power sharing scenarios between the classical and quantum signals. By contrast its single-carrier counterpart requires the classical signal to be at least 100 times stronger than the quantum signal in THz SQCC.

quant-ph↗

arXiv2026

SLIPT-Enabled Ground-to-UAV FSO Systems with Optical Reconfigurable Intelligent Surfaces

This paper proposes an optical reconfigurable intelligent surface (ORIS)-assisted ground-to-unmanned aerial vehicle (UAV) free-space optical (FSO) communication system empowered by simultaneous lightwave information and power transfer (SLIPT). To overcome the line-of-sight (LoS) limitation of FSO-based SLIPT systems, we introduce an ORIS that reflects the laser beam towards a non-LoS UAV receiver. We model and analyze the combined channel characteristics, incorporating atmospheric loss, turbulence-induced fading, pointing error, and angle-of-arrival fluctuations due to UAV hovering. We derive closed-form expressions for harvested energy, outage probability, and symbol error rate (SER). Numerical results show that integrating ORIS improves EH efficiency while maintaining manageable outage and SER performance.

eess.SP↗

arXiv2026

Efficient Numerical Modeling of Near-Field Diffraction in ORIS-Assisted Free-Space Optical Links

This paper investigates near-field propagation in optical reconfigurable intelligent surface (ORIS)-assisted free-space optical (FSO) communication systems. Unlike conventional far-field scenarios, near-field propagation involves complex diffraction effects that hinder tractable closed-form analysis. To address this issue, a numerical framework for evaluating the optical field distribution of ORIS-assisted FSO links is proposed. Specifically, two numerical approaches are considered: direct Riemann-sum evaluation and a fast Fourier transform (FFT)-based method. Although the Riemann sum approach provides accurate field estimation, it incurs extremely high computational complexity due to the fine spatial discretization of the ORIS surface required at optical wavelengths. To improve computational efficiency, the optical-field calculation is reformulated as a convolution in the spatial-frequency domain, enabling efficient FFT-based propagation analysis. Simulation results demonstrate that the proposed FFT-based method achieves accuracy comparable to that of the Riemann-sum approach while significantly reducing computational complexity.

eess.SY↗

arXiv2025

Quantum Internet in the Sky: Vision, Challenges, Solutions, and Future Directions

This article envisions the concept of a ``Quantum Internet in the Sky", aiming to establish ubiquitous quantum communication links among distant nodes via free-space optical channels. Our key focus is on deploying quantum communication terminals on non-terrestrial platforms, specifically unmanned aerial vehicles and satellites, at various altitudes. By highlighting the unique characteristics of these platforms compared to terrestrial counterparts, we address inherent challenges and discuss potential solutions through meticulous system designs and analyses of typical non-terrestrial quantum communication scenarios. Finally, we illuminate the path forward by proposing essential future directions that underscore the integration of high-dimensional multipartite quantum communications with sensing, computing, and intelligence for multiple users en route to realizing a fully operational Quantum Internet.

quant-ph↗

arXiv2025

Simultaneous Classical and Quantum Communications: Recent Progress and Three Challenges

A critical aspect of next-generation wireless networks is the integration of quantum communications to guard against quantum computing threats to classical networks. Despite successful experimental demonstrations, integrating quantum communications into the classical infrastructure faces substantial challenges, including high costs, compatibility issues, and extra hardware deployment to accommodate both classical and quantum communication equipment. To mitigate these challenges, we explore novel protocols that enable simultaneous classical and quantum communications, relying on a single set of transceivers to jointly modulate and decode classical and quantum information onto the same signal. Additionally, we emphasize extending quantum communication capabilities beyond traditional optical bands into the terahertz, even possibly to millimeter-wave and microwave frequencies, thereby broadening the potential horizon of quantum-secure applications. Finally, we identify open problems that must be addressed to facilitate practical implementation.

quant-ph↗

arXiv2025

Towards Quantum SAGINs Harnessing Optical RISs: Applications, Advances, and the Road Ahead

The space-air-ground integrated network (SAGIN) concept is vital for the development of seamless next-generation (NG) wireless coverage, integrating satellites, unmanned aerial vehicles, and manned aircraft along with the terrestrial infrastructure to provide resilient ubiquitous communications. By incorporating quantum communications using optical wireless signals, SAGIN is expected to support a synergistic global quantum Internet alongside classical networks. However, long-distance optical beam propagation requires line-of-sight (LoS) connections in the face of beam broadening and LoS blockages. To overcome blockages among SAGIN nodes, we propose deploying optical reconfigurable intelligent surfaces (ORISs) on building rooftops. They can also adaptively control optical beam diameters for reducing losses. This article first introduces the applications of ORISs in SAGINs, then examines their advances in quantum communications for typical SAGIN scenarios. Finally, the road ahead towards the practical realization of ORIS-aided NG quantum SAGINs is outlined.

eess.SP↗

arXiv2024

Optical RISs Improve the Secret Key Rate of Free-Space QKD in HAP-to-UAV Scenarios

Large optical reconfigurable intelligent surfaces (ORISs) are proposed for employment on building rooftops to facilitate free-space quantum key distribution (QKD) between highaltitude platforms (HAPs) and low-altitude platforms (LAPs). Due to practical constraints, the communication terminals can only be positioned beneath the LAPs, preventing direct upward links to HAPs. By deploying ORISs on rooftops to reflect the beam arriving from HAPs towards LAPs from below, reliable HAP-to-LAP links can be established. To accurately characterize the optical beam propagation, we develop an analytical channel model based on extended Huygens-Fresnel principles for representing both the atmospheric turbulence effects and the hovering fluctuations of LAPs. This model facilitates adaptive ORIS beam-width control through linear, quadratic, and focusing phase shifts, which are capable of effectively mitigating the detrimental effects of beam broadening and pointing errors (PE). Consequently, the information-theoretic bound of the secret key rate and the security performance of a decoy-state QKD protocol are analyzed. Our findings demonstrate that quadratic phase shifts enhance the SKR at high HAP-ORIS zenith angles or mild PE conditions by narrowing the beam to optimal sizes. By contrast, linear phase shifts are advantageous at low HAP-ORIS zenith angles or moderate-to-high PE by diverging the beam to mitigate LAP fluctuations.

eess.SP↗

arXiv2022

Development and Space-Qualification of a Miniaturized CubeSat's 2-W EDFA for Space Laser Communications

The Japanese National Institute of Information and Communications Technology (NICT) is currently developing a high-performance laser-communication terminal for CubeSats aiming at providing a high-datarate communication solution for LEO satellites requiring to transmit large volumes of data from the orbit. A key part of the communication system is a high-power optical amplifier capable of providing enough gain to the transmitted signals to be able to close the link on its counterpart's receiver with the smallest impact in terms of energy and power on the CubeSat's platform. This manuscript describes the development of a miniaturized 2-W space-grade 2-stage Erbium-Doped Fiber Amplifier (EDFA) compatible with the CubeSat form factor, showing the best power-to-size ratio for a spaced-qualified EDFA to the best of the authors' knowledge. Performance results under realistic conditions as well as full space qualification and test are presented, proving that this module can support short-duration LEO-ground downlinks as well as long-duration inter-satellite links.

physics.ins-det↗

arXiv2022

NICT's versatile miniaturized lasercom terminals for moving platforms

With the goal of meeting the diverse requirements of many different types of platforms, ranging from small drones to big satellites, and being applied in a variety of diverse scenarios, ranging from fixed terrestrial links to moving platforms in general, and operating within a wide range of conditions and distances, the Japanese National Institute of Information and Communications Technology (NICT) is currently working towards the development of a series of versatile miniaturized free-space laser-communication terminals. By choosing the appropriate terminal configuration for any given scenario, the basic conditions of operations can be satisfied without the need of customization, and the adaptive design of the terminals can close the gap to achieve an optimum solution that meets the communication requirements. This paper presents NICT's current efforts regarding the development of this series of lasercom terminals and introduces the first prototypes developed for validation and test purposes.

cs.NI↗

arXiv2022

Prototype Development and Validation of a Beam-Divergence Control System for Free-Space Laser Communications

Being able to dynamically control the transmitted-beam divergence can bring important advantages in free-space optical communications. Specifically, this technique can help to optimize the overall communications performance when the optimum laser-beam divergence is not fixed or known. This is the case in most realistic space laser communication systems, since the optimum beam divergence depends on multiple factors that can vary with time, such as the link distance, or cannot be accurately known, such as the actual pointing accuracy. A dynamic beam-divergence control allows to optimize the link performance for every platform, scenario, and condition. NICT is currently working towards the development of a series of versatile lasercom terminals that can fit a variety of conditions, for which the adaptive element of the transmitted beam divergence is a key element. This manuscript presents a prototype of a beam-divergence control system designed and developed by NICT and Tamron to evaluate this technique and to be later integrated within the lasercom terminals. The basic design of the prototype is introduced as well as the first validation tests that demonstrate its performance.

eess.SY↗

arXiv2021

Development of a miniaturized laser-communication terminal for small satellites

Free-space optical communication is becoming a mature technology that has been demonstrated in space a number of times in the last few years. The Japanese National Institute of Information and Communications Technology (NICT) has carried out some of the most-significant in-orbit demonstrations over the last three decades. However, this technology has not reached a wide commercial adoption yet. For this reason, NICT is currently working towards the development of a miniaturized laser-communication terminal that can be installed in very-small satellites, while also compatible with a variety of other different platforms, meeting a wide span of bandwidth requirements. The strategy adopted in this design has been to create a versatile lasercom terminal that can operate in multiple scenarios and platforms without the need of extensive customization. This manuscript describes the current efforts in NICT towards the development of this terminal, and it shows the prototype that has been already developed for the preliminary tests, which are described as well. These tests will include the performance verification using drones first with the goal of installing the prototype on High-Altitude Platform Systems (HAPS) to carry out communication links between HAPS and ground, and later with the Geostationary (GEO) orbit, covering this way a wide range of operating conditions. For these tests, in the former case the counter terminal is a simple transmitter in the case of the drone, and a transportable ground station in the case of the HAPS; and in the latter case the counter terminal is the GEO satellite ETS-IX, foreseen to be launched by NICT in 2023.

eess.SP↗

arXiv2020

Intersatellite-link demonstration mission between CubeSOTA (LEO CubeSat) and ETS9-HICALI (GEO satellite)

LEO-to-GEO intersatellite links using laser communications bring important benefits to greatly enhance applications such as downloading big amounts of data from LEO satellites by using the GEO satellite as a relay. By using this strategy, the total availability of the LEO satellite increases from less than 1% if the data is downloaded directly to the ground up to about 60% if the data is relayed through GEO. The main drawback of using a GEO relay is that link budget is much more difficult to close due to the much larger distance. However, this can be partially compensated by transmitting at a lower data rate, and still benefiting from the much-higher link availability when compared to LEO-to-ground downlinks, which additionally are more limited by the clouds than the relay option. After carrying out a feasibility study, NICT and the University of Tokyo started preparing a mission to demonstrate the technologies needed to perform these challenging lasercom links. Furthermore, to demonstrate the feasibility of this technique, an extremely-small satellite, i.e. a 6U CubeSat, will be used to achieve data rates as high as 10 Gbit/s between LEO and GEO. Some of the biggest challenges of this mission are the extremely low size, weight and power available in the CubeSat, the accurate pointing precision required for the lasercom link, and the difficulties of closing the link at such a high speed as 10 Gbit/s.

physics.ins-det↗