arXiv subjects

Pujitha Perla

Publications and source records attributed to Pujitha Perla.

5 recordsLinked to original sources

arXiv2024

Fabrication and characterization of InAs nanowire-based quantum dot structures utilizing buried bottom gates

Semiconductor nanowires can be utilized to create quantum dot qubits. The formation of quantum dots is typically achieved by means of bottom gates created by a lift-off process. As an alternative, we fabricated flat buried bottom gate structures by filling etched trenches in a Si substrate with sputtered TiN, followed by mechanical polishing. This method achieved gate line pitches as small as 60 nm. The gate fingers have low gate leakage. As a proof of principle, we fabricated quantum dot devices using InAs nanowires placed on the gate fingers. These devices exhibit single electron tunneling and Coulomb blockade.

cond-mat.mes-hall↗

arXiv2021

Microwave spectroscopy of Andreev states in InAs nanowire-based hybrid junctions using a flip-chip layout

Josephson junctions based on semiconductor nanowires are potential building blocks for electrically tunable qubit structures, e.g. the gatemon or the Andreev qubit. However, an actual realization requires the thorough investigation of the intrinsic excitation spectrum. Here, we demonstrate the fabrication of low-loss superconducting microwave circuits that combine high quality factors with a well-controlled gate architecture by utilizing a flip-chip approach. This platform is then used to perform single-tone and two-tone experiments on Andreev states in in-situ grown InAs/Al core/half-shell nanowires with shadow mask defined Josephson junctions. In gate-controlled and flux-biased spectroscopic measurements we find clear signatures of single quasiparticle as well as quasiparticle pair transitions between discrete Andreev bound states mediated by photon-absorption. Our experimental findings are supported by simulations that show that the junction resides in the intermediate channel length regime.

cond-mat.mes-hall↗

arXiv2021

Te-doped selective-area grown InAs nanowires for superconducting hybrid devices

Semiconductor nanowires have emerged as versatile components in superconducting hybrid devices for Majorana physics and quantum computing. The transport properties of nanowires can be tuned either by field-effect or doping. We investigated a series of InAs nanowires which conductivity has been modified by n-type doping using tellurium. In addition to electron microscopy studies, the wires were also examined with atomic probe tomography to obtain information about the local incorporation of Te atoms. It was found that the Te atoms mainly accumulate in the core of the nanowire and at the corners of the {110} side facets. The efficiency of n-type doping was also confirmed by transport measurements. As a demonstrator hybrid device, a Josephson junction was fabricated using a nanowire as a weak link. The corresponding measurements showed a clear increase of the critical current with increase of the dopant concentration.

cond-mat.mes-hall↗

arXiv2020

Fully in-situ InAs nanowire Josephson junctions by selective-area growth and shadow evaporation

Josephson junctions based on InAs semiconducting nanowires and Nb superconducting electrodes are fabricated in-situ by a special shadow evaporation scheme for the superconductor electrode. Compared to other metallic superconductors such as Al, Nb has the advantage of a larger superconducting gap which allows operation at higher temperatures and magnetic fields. Our junctions are fabricated by shadow evaporation of Nb on pairs of InAs nanowires grown selectively on two adjacent tilted Si (111) facets and crossing each other at a small distance. The upper wire relative to the deposition source acts as a shadow mask determining the gap of the superconducting electrodes on the lower nanowire. Electron microscopy measurements show that the fully in-situ fabrication method gives a clean InAs/Nb interface. A clear Josephson supercurrent is observed in the current-voltage characteristics, which can be controlled by a bottom gate. The excess current of 0.68 indicates a high junction transparency. Under microwave radiation, pronounced integer Shapiro steps are observed suggesting a sinusoidal current-phase relation. Owing to the large critical field of Nb, the Josephson supercurrent can be maintained to magnetic fields exceeding 1 T. Our results show that in-situ prepared Nb/InAs nanowire contacts are very interesting candidates for superconducting quantum circuits requiring large magnetic fields.

cond-mat.supr-con↗

arXiv2020

Hard-gap spectroscopy in a self-defined mesoscopic InAs/Al nanowire Josephson junction

Superconductor/semiconductor-nanowire hybrid structures can serve as versatile building blocks to realize Majorana circuits or superconducting qubits based on quantized levels such as Andreev qubits. For all these applications it is essential that the superconductor-semiconductor interface is as clean as possible. Furthermore, the shape and dimensions of the superconducting electrodes needs to be precisely controlled. We fabricated self-defined InAs/Al core/shell nanowire junctions by a fully in-situ approach, which meet all these criteria. Transmission electron microscopy measurements confirm the sharp and clean interface between the nanowire and the in-situ deposited Al electrodes which were formed by means of shadow evaporation. Furthermore, we report on tunnel spectroscopy, gate and magnetic field-dependent transport measurements. The achievable short junction lengths,the observed hard-gap and the magnetic field robustness make this new hybrid structure very attractive for applications which rely on a precise control of the number of sub-gap states, like Andreev qubits or topological systems.

cond-mat.mes-hall↗