arXiv subjects

Régis André

Publications and source records attributed to Régis André.

14 recordsLinked to original sources

arXiv2020

Controlling the shape of a tapered nanowire: lessons from the Burton-Cabrera-Frank model

The propagation of sidewall steps during the growth of nanowires is calculated in the frame of the Burton-Cabrera-Frank model. The stable shape of the nanowire comprises a cylinder section on top of a cone section: their characteristics are obtained as a function of the radius of the catalyst-nanowire area, the desorption-limited diffusion length of adatoms on the terraces, and the sticking of adatoms at step edges. The comparison with experimental data allows us to evaluate these last two parameters for InP and ZnTe nanowires; it reveals a different behavior for the two materials, related to a difference by an order of magnitude of the desorption-limited diffusion length.

cond-mat.mtrl-sci↗

arXiv2019

Light / heavy hole switching with correlated characterization on a single quantum dot : Probing the light hole / heavy hole switching with correlated magneto-optical spectroscopy and chemical analysis on a single quantum dot

A whole series of complementary studies have been performed on the same, single nanowire containing a quantum dot: cathodoluminescence spectroscopy and imaging, micro-photoluminescence spectroscopy under magnetic field and as a function of temperature, and energy-dispersive X-ray spectrometry and imaging. The ZnTe nanowire was deposited on a Si 3 N 4 membrane with Ti/Al patterns. The complete set of data shows that the CdTe quantum dot features the heavy-hole state as a ground state, although the compressive mismatch strain promotes a light-hole ground state as soon as the aspect ratio is larger than unity (elongated dot). A numerical calculation of the whole structure shows that the transition from the heavy-hole to the light-hole configuration is pushed toward values of the aspect ratio much larger than unity by the presence of a (Zn,Mg)Te shell, and that the effect is further enhanced by a small valence band offset between the semiconductors in the dot and around it.

cond-mat.mes-hall↗

arXiv2018

Nanowire growth and sublimation: CdTe quantum dots in ZnTe nanowires

The role of the sublimation of the compound and of the evaporation of the constituents from the gold nanoparticle during the growth of semiconductor nanowires is exemplified with CdTe-ZnTe heterostructures. Operating close to the upper temperature limit strongly reduces the amount of Cd present in the gold nanoparticle and the density of adatoms on the nanowire sidewalls. As a result, the growth rate is small and strongly temperature dependent, but a good control of the growth conditions allows the incorporation of quantum dots in nanowires with sharp interfaces and adjustable shape, and it minimizes the radial growth and the subsequent formation of additional CdTe clusters on the nanowire sidewalls, as confirmed by photoluminescence. Uncapped CdTe segments dissolve into the gold nanoparticle when interrupting the flux, giving rise to a bulb-like (pendant-droplet) shape attributed to the Kirkendall effect.

cond-mat.mtrl-sci↗

arXiv2016

Light-hole Exciton in Nanowire Quantum Dot

Quantum dots inserted inside semiconductor nanowires are extremely promising candidates as building blocks for solid-state based quantum computation and communication. They provide very high crystalline and optical properties and offer a convenient geometry for electrical contacting. Having a complete determination and full control of their emission properties is one of the key goals of nanoscience researchers. Here we use strain as a tool to create in a single magnetic nanowire quantum dot a light-hole exciton, an optically active quasiparticle formed from a single electron bound to a single light hole. In this frame, we provide a general description of the mixing within the hole quadruplet induced by strain or confinement. A multi-instrumental combination of cathodoluminescence, polarisation-resolved Fourier imaging and magneto-optical spectroscopy, allow us to fully characterize the hole ground state, including its valence band mixing with heavy hole states.

cond-mat.mes-hall↗

arXiv2016

High-Fidelity and Ultrafast Initialization of a Hole Spin Bound to a Te Isoelectronic Center in ZnS

We demonstrate the optical initialization of a hole-spin qubit bound to an isoelectronic center (IC) formed by a pair of Te impurities in ZnSe, an impurity/host system providing high optical homogeneity, large electric dipole moments, and long coherence times. The initialization scheme is based on the spin-preserving tunneling of a resonantly excited donor-bound exciton to a positively charged Te IC, thus forming a positive trion. The radiative decay of the trion within less than 50 ps leaves a heavy hole in a well-defined polarization-controlled spin state. The initialization fidelity exceeds 98:5 % for an initialization time of less than 150 ps.

cond-mat.mes-hall↗

arXiv2015

Temporally resolved second-order photon correlations of exciton-polariton Bose-Einstein condensate formation

Second-order time correlation measurements with a temporal resolution better than 3 ps were performed on a CdTe microcavity where spontaneous Bose-Einstein condensation is observed. After the laser pulse, the nonresonantly excited thermal polariton population relaxes into a coherent polariton condensate. Photon statistics of the light emitted by the microcavity evidences a clear phase transition from the thermal state to a coherent state, which occurs within 3.2 ps after the onset of stimulated scattering. Following this very fast transition, we show that the emission possesses a very high coherence that persists for more than 100 ps after the build-up of the condensate.

cond-mat.quant-gas↗

arXiv2013

Optical properties of single ZnTe nanowires grown at low temperature

Optically active gold-catalyzed ZnTe nanowires have been grown by molecular beam epitaxy, on a ZnTe(111) buffer layer, at low temperature 350\degree under Te rich conditions, and at ultra-low density (from 1 to 5 nanowires per micrometer^{2}. The crystalline structure is zinc blende as identified by transmission electron microscopy. All nanowires are tapered and the majority of them are <111> oriented. Low temperature micro-photoluminescence and cathodoluminescence experiments have been performed on single nanowires. We observe a narrow emission line with a blue-shift of 2 or 3 meV with respect to the exciton energy in bulk ZnTe. This shift is attributed to the strain induced by a 5 nm-thick oxide layer covering the nanowires, and this assumption is supported by a quantitative estimation of the strain in the nanowires.

cond-mat.mtrl-sci↗

arXiv2012

Determination of the valence band offset at cubic CdSe/ZnTe type II heterojunctions: A combined experimental and theoretical approach

We present a combined experimental and theoretical approach for the determination of the low-temperature valence band offset (VBO) at CdSe/ZnTe heterojunctions with underlying zincblende crystal structure. On the experimental side, the optical transition of the type II interface allows for a precise measurement of the type II band gap. We show how the excitation-power dependent shift of this photoluminescence (PL) signal can be used for any type II system for a precise determination of the VBO. On the theoretical side, we use a refined empirical tight-binding parametrization in order to accurately reproduce the band structure and density of states around the band gap region of cubic CdSe and ZnTe and then calculate the branch point energy (also known as charge neutrality level) for both materials. Because of the cubic crystal structure and the small lattice mismatch across the interface, the VBO for the material system under consideration can then be obtained from a charge neutrality condition, in good agreement with the PL measurements.

cond-mat.mtrl-sci↗

arXiv2012

Insertion of CdSe quantumdots in ZnSe nanowires : MBE growth and microstructure analysis

ZnSe nanowire growth has been successfully achieved on ZnSe (100) and (111)B buffer layers deposited on GaAs substrates. Cubic [100] oriented ZnSe nanowires or [0001] oriented hexagonal NWs are obtained on (100) substrates while [111] oriented cubic mixed with [0001] oriented hexagonal regions are obtained on (111)B substrates. Most of the NWs are perpendicular to the surface in the last case. CdSe quantum dots were successfully incorporated in the ZnSe NWs as demonstrated by transmission electron microscopy, energy filtered TEM and high angle annular dark field scanning TEM measurements.

cond-mat.mtrl-sci↗

arXiv2012

Polarity determination in ZnSe nanowires by HAADF STEM

High angle annular dark field scanning transmission electron microscopy is used to analyze the polarity of ZnSe nanowires grown, by molecular beam epitaxy, on GaAs substrates. The experimental results are compared to simulated images in order to verify possible experimental artefacts. In this work we show that for this type of nano-objects, a residual tilt of the specimen below 15 mrad, away from the crystallographic zone axis does not impair the interpretation of the experimental images.

cond-mat.mtrl-sci↗

arXiv2012

Subnanosecond spectral diffusion measurement using photon correlation

Spectral diffusion is a result of random spectral jumps of a narrow line as a result of a fluctuating environment. It is an important issue in spectroscopy, because the observed spectral broadening prevents access to the intrinsic line properties. However, its characteristic parameters provide local information on the environment of a light emitter embedded in a solid matrix, or moving within a fluid, leading to numerous applications in physics and biology. We present a new experimental technique for measuring spectral diffusion based on photon correlations within a spectral line. Autocorrelation on half of the line and cross-correlation between the two halves give a quantitative value of the spectral diffusion time, with a resolution only limited by the correlation set-up. We have measured spectral diffusion of the photoluminescence of a single light emitter with a time resolution of 90 ps, exceeding by four orders of magnitude the best resolution reported to date.

physics.optics↗

arXiv2009

Photon correlation spectroscopy on a single quantum dot embedded in a nanowire

We have observed strong photoluminescence from a single CdSe quantum dot embedded in a ZnSe nanowire. Exciton, biexciton and charged exciton lines have been identified unambiguously using photon correlation spectroscopy. This technique has provided a detailed picture of the dynamics of this new system. This type of semi conducting quantum dot turns out to be a very efficient single photon source in the visible. Its particular growth technique opens new possibilities as compared to the usual self-asssembled quantum dots.

cond-mat.mtrl-sci↗

arXiv2009

Dark exciton optical spectroscopy of a semiconducting quantum dot embedded in a nanowire

Photoluminescence of a single CdSe quantum dot embedded in a ZnSe nanowire has been investigated. It has been found that the dark exciton has a strong influence on the optical properties. The most visible influence is the strongly reduced excitonic emission compared to the biexcitonic one. Temperature dependent lifetime measurements have allowed us to measure a large splitting of $ΔE = 6 $ meV between the dark and the bright exciton as well as the spin flip rates between these two states.

cond-mat.mtrl-sci↗

arXiv2008

CdSe quantum dots in ZnSe nanowires as efficient source for single photons up to 220 K

ZnSe nanowire heterostructures were grown by molecular beam epitaxy in the vapour-liquid-solid growth mode assisted by gold catalysts. Size, shape and crystal structure are found to strongly depend on the growth conditions. Both, zinc-blende and wurtzite crystal structures are observed using transmission electron microscopy. At low growth temperature, cone-shaped nano-needles are formed. For higher growth temperature, the nanowires are uniform and have a high aspect ratio with sizes of 1-2 $μ$m in length and 20-50 nm in width as observed by scanning electron microscopy. Growing a nanowire on top of a nano-needle allows us to obtain very narrow nanorods with a diameter less than 10 nm and a low density of stacking fault defects. These results allow us the insertion of CdSe quantum dots in a ZnSe nanowire. An effcient photon anti-bunching was observed up to 220 K, demonstrating a high-temperature single-photon source.

cond-mat.mes-hall↗