SearcharxivSearch

arXiv subjects

R. C. Fernow

Publications and source records attributed to R. C. Fernow.

7 recordsLinked to original sources

Pion Production by Protons on a Thin Beryllium Target at 6.4, 12.3, and 17.5 GeV/c Incident Proton Momenta

An analysis of inclusive pion production in proton-beryllium collisions at 6.4, 12.3, and 17.5 GeV/c proton beam momentum has been performed. The data were taken by Experiment 910 at the Alternating Gradient Synchrotron at the Brookhaven National Laboratory. The differential $π^+$ and $π^-$ production cross sections ($d^2σ/dpdΩ$) are measured up to 400 mRad in $θ_π$ and up to 6 GeV/c in $p_π$. The measured cross section is fit with a Sanford-Wang parameterization.

nucl-ex

Ab Initio Liquid Hydrogen Muon Cooling Simulations with ELMS in ICOOL

This paper presents new theoretical results on the passage of muons through liquid hydrogen which have been confirmed in a recent experiment. These are used to demonstrate that muon bunches may be compressed by ionisation cooling more effectively than suggested by previous calculations. Muon cooling depends on the differential cross section for energy loss and scattering of muons. We have calculated this cross section for liquid H2 from first principles and atomic data, avoiding traditional assumptions. Thence, 2-D probability maps of energy loss and scattering in mm-scale thicknesses are derived by folding, and stored in a database. Large first-order correlations between energy loss and scattering are found for H2, which are absent in other simulations. This code is named ELMS, Energy Loss & Multiple Scattering. Single particle trajectories may then be tracked by Monte Carlo sampling from this database on a scale of 1 mm or less. This processor has been inserted into the cooling code ICOOL. Significant improvements in 6-D muon cooling are predicted compared with previous predictions based on GEANT. This is examined in various geometries. The large correlation effect is found to have only a small effect on cooling. The experimental scattering observed for liquid H2 in the MUSCAT experiment has recently been reported to be in good agreement with the ELMS prediction, but in poor agreement with GEANT simulation.

physics.acc-ph

A Cost-Effective Design for a Neutrino Factory

There have been active efforts in the U.S., Europe, and Japan on the design of a Neutrino Factory. This type of facility produces intense beams of neutrinos from the decay of muons in a high energy storage ring. In the U.S., a second detailed Feasibility Study (FS2) for a Neutrino Factory was completed in 2001. Since that report was published, new ideas in bunching, cooling and acceleration of muon beams have been developed. We have incorporated these ideas into a new facility design, which we designate as Study 2B (ST2B), that should lead to significant cost savings over the FS2 design.

physics.acc-ph

The RFOFO Ionization Cooling Ring for Muons

Practical ionization cooling rings could lead to lower cost or improved performance in neutrino factory or muon collider designs. The ring modeled here uses realistic three-dimensional fields. The performance of the ring compares favorably with the linear cooling channel used in the second US Neutrino Factory Study. The normalized 6D emittance of an ideal ring is decreased by a factor of approximately 240, compared with a factor of only 15 for the linear channel. We also examine such \textit{real-world} effects as windows on the absorbers and rf cavities and leaving empty lattice cells for injection and extraction. For realistic conditions the ring decreases the normalized 6D emittance by a factor of 49.

physics.acc-ph

Inclusive Soft Pion Production from 12.3 and 17.5 GeV/c Protons on Be, Cu and Au

Differential cross-sections are presented for the inclusive production of charged pions in the momentum range 0.1 to 1.2 GeV/c in interactions of 12.3 and 17.5 GeV/c protons with Be, Cu, and Au targets. The measurements were made by Experiment 910 at the Alternating Gradient Synchrotron in Brookhaven National Laboratory. The cross-sections are presented as a function of pion total momentum and production polar angle $θ$ with respect to the beam.

nucl-ex

Beam Dynamics problems in a muon collider

We discuss the various beam dynamics problems in muon collider systems, starting from the proton accelerator needed to generate the muon beams and proceeding through the muon storage ring.

acc-phys

MONTE CARLO SIMULATIONS OF MUON PRODUCTION

Muon production requirements for a muon collider are presented. Production of muons from pion decay is studied. Lithium lenses and solenoids are considered for focussing pions from a target, and for matching the pions into a decay channel. Pion decay channels of alternating quadrupoles and long solenoids are compared. Monte Carlo simulations are presented for production of $π\rightarrow μ$ by protons over a wide energy range, and criteria for choosing the best proton energy are discussed.

acc-phys