arXiv subjects

R. Hayes

Publications and source records attributed to R. Hayes.

4 recordsLinked to original sources

arXiv2025

Euclid Quick Data Release (Q1): VIS processing and data products

This paper describes the VIS Processing Function (VIS PF) of the Euclid ground segment pipeline, which processes and calibrates raw data from the VIS camera. We present the algorithms used in each processing element, along with a description of the on-orbit performance of VIS PF, based on Performance Verification (PV) and Q1 data. We demonstrate that the principal performance metrics (image quality, astrometric accuracy, photometric calibration) are within pre-launch specifications. The image-to-image photometric scatter is less than $0.8\%$, and absolute astrometric accuracy compared to Gaia is $5$ mas Image quality is stable over all Q1 images with a full width at half maximum (FWHM) of $0.\!^{\prime\prime}16$. The stacked images (combining four nominal and two short exposures) reach $I_\mathrm{E} = 25.6$ ($10\sigma$, measured as the variance of $1.\!^{\prime\prime}3$ diameter apertures). We also describe quality control metrics provided with each image, and an appendix provides a detailed description of the provided data products. The excellent quality of these images demonstrates the immense potential of Euclid VIS data for weak lensing. VIS data, covering most of the extragalactic sky, will provide a lasting high-resolution atlas of the Universe.

astro-ph.IM↗

arXiv2004

Magnetoelectric Effects in Ferromagnetic/Piezoelectric Multilayer Composites

The observation of strong magnetoelectric effects is reported in thick film bilayers and multilayers of ferrite-lead titanate zirconate (PZT) and lanthanum nanganite-PZT. The ferrites used in our studies included pure and zinc substituted cobalt-, nickel- and lithium ferrites. Samples were prepared by sintering 10-40 mm thick films obtained by tape-casting. Measurements of ME voltage coefficients at 10-1000 Hz indicated a giant ME effect in nickel ferrite-PZT, but a relatively weak coupling in other ferrite-PZT and manganite-PZT systems. Multilayers prepared by hot pressing was found to show a higher ME coefficient than sintered samples. Evidence was found for enhancement in ME coefficients when Zn was substituted in ferrites. The Zn-assisted increase was attributed to low anisotropy and high permeability that resulted in favorable magneto-mechanical coupling in the composites. We analyzed the data in terms of our recent comprehensive theory that takes into account actual interface conditions by introducing an interface coupling parameter. Theoretical longitudinal and transverse ME voltage coefficients for unclamped and clamped samples are in general agreement with data. From the analysis we inferred excellent interface coupling for nickel zinc ferrite-PZT and weak coupling for other layered systems.

cond-mat.mtrl-sci↗

arXiv2003

Low frequency and Microwave Magnetoelectric Effects in Thick Film Heterostructures of Lithium Zinc Ferrite and Lead Zirconate Titanate

Magnetoelectric (ME) coupling at low frequencies and at x-band have been investigated in layered samples containing zinc substituted lithium ferrite and lead zirconate titanate (PZT). Multilayers of Li0.5-x/2ZnxFe2.5-x/2O4 (LZFO) (x=0-0.4) and PZT were prepared by lamination and sintering of thick films. At low frequencies (10-1000 Hz), the ME voltage coefficient for transverse fields is higher than for longitudinal fields. With Zn substitution in the ferrite, transverse coupling increases to a maximum for x=0.3 and then decreases for higher x. Analysis based on our model for a bilayer implies an efficient magneto-mechanical coupling with Zn substitution, resulting in strong ME interactions. Microwave ME coupling is studied through measurements of shift in the ferromagnetic resonance field due to an applied electric field. Estimated ME constants from such data are in agreement with our model for a ferrite-PZT bilayer.

cond-mat.mtrl-sci↗

arXiv2003

Dynamic Magnetoelectric Effects in Bulk and Layered composites of Cobalt Zinc Ferrite and Lead Zirconate Titanate

Low frequency magnetoelectric (ME) coupling has been investigated in bulk and multilayers of cobalt zinc ferrite, Co1-xZnxFe2O4 (x=0-0.6), and lead zirconate titanate. In bulk samples, the transverse and longitudinal couplings are weak and are of equal magnitude. A substantial strengthening of ME interactions is evident in layered structures, with the ME voltage coefficient a factor of 10-30 higher than in bulk samples. Important findings of the studies in layered composites are as follows. (i) The transverse coupling is stronger than the longitudinal coupling. (ii) The strength of ME interactions is dependent on Zn substitution with a maximum for x=0.4. (iii) Analysis of volume and static magnetic field dependence of ME voltage coefficients reveal a weak coupling at the ferromagnetic-piezoelectric interface. (iv) The interface coupling k increases with Zn substitution and k versus x profile shows a maximum centered at x=0.4. (iv) The Zn-assisted enhancement is attributed to efficient magneto-mechanical coupling in the ferrite.

cond-mat.mtrl-sci↗