arXiv subjects

R. N. Jabdaraghi

Publications and source records attributed to R. N. Jabdaraghi.

5 recordsLinked to original sources

arXiv2024

Cryogenic microwave link for quantum local area networks

Scalable quantum information processing with superconducting circuits is expected to advance from individual processors located in single dilution refrigerators to more powerful distributed quantum computing systems. The realization of hardware platforms for quantum local area networks (QLANs) compatible with superconducting technology is of high importance in order to achieve a practical quantum advantage. Here, we present a fundamental prototype platform for a microwave QLAN based on a cryogenic link connecting two separate dilution cryostats over a distance of $6.6$ m with a base temperature of $52$ mK in the center. Superconducting microwave coaxial cables are employed to form a quantum communication channel between the distributed network nodes. We demonstrate the continuous-variable entanglement distribution between the remote dilution refrigerators in the form of two-mode squeezed microwave states, reaching squeezing of $2.10 \pm 0.02$ dB and negativity of $0.501 \pm 0.011$. Furthermore, we show that quantum entanglement is preserved at channel center temperatures up to $1$ K, paving the way towards microwave quantum communication at elevated temperatures. Consequently, such a QLAN system can form the backbone for future distributed quantum computing with superconducting circuits.

quant-ph↗

arXiv2020

Spatial and energy resolution of electronic states by shot noise

Shot noise measurements are widely used for the characterization of nonequilibrium configurations in electronic conductors. The recently introduced quantum tomography approach was implemented for the studies of electronic wavefunctions of few-electron excitations created by periodic voltage pulses in phase-coherent ballistic conductors based on the high-quality GaAs two-dimensional electron gas. Still relying on the manifestation of Fermi correlations in noise, we focus on the simpler and more general approach beneficial for the local measurements of energy distribution (ED) in electronic systems with arbitrary excitations with well-defined energies and random phases. Using biased diffusive metallic wire as a testbed, we demonstrate the power of this approach and extract the well-known double-step ED from the shot noise of a weakly coupled tunnel junction. Our experiment paves the way for the local measurements of generic nonequilibrium configurations applicable to virtually any conductor.

cond-mat.mes-hall↗

arXiv2017

Magnetometry with low resistance proximity Josephson junction

We characterize a niobium-based superconducting quantum interference proximity transistor (Nb-SQUIPT) built upon a Nb-Cu-Nb SNS weak link. The Nb-SQUIPT and SNS devices are fabricated simultaneously in two separate lithography and deposition steps, relying on Ar ion cleaning of the Nb contact surfaces. The quality of the Nb-Cu interface is characterized by measuring the temperature-dependent equilibrium critical supercurrent of the SNS junction. In the Nb-SQUIPT device, we observe a maximum flux-to-current transfer function value of about 55 nA/Φ_0 in the sub-gap regime of bias voltages. This results in suppression of power dissipation down to a few fW. The device can implement a low-dissipation SQUIPT, improving by up to two orders of magnitude compared to a conventional device based on an Al-Cu-Al SNS junction and an Al tunnel probe (Al-SQUIPT).

cond-mat.supr-con↗

arXiv2017

Noise of a superconducting magnetic flux sensor based on a proximity Josephson junction

We demonstrate simultaneous measurements of DC transport properties and flux noise of a hybrid superconducting magnetometer based on the proximity effect (superconducting quantum interference proximity transistor, SQUIPT). The noise is probed by a cryogenic amplifier operating in the frequency range of a few MHz. In our non-optimized device, we achieve minimum flux noise $\sim 4\;μΦ_0/Hz^{1/2}$, set by the shot noise of the probe tunnel junction. The flux noise performance can be improved by further optimization of the SQUIPT parameters, primarily minimization of the proximity junction length and cross section. Furthermore, the experiment demonstrates that the setup can be used to investigate shot noise in other nonlinear devices with high impedance. This technique opens the opportunity to measure sensitive magnetometers including SQUIPT devices with very low dissipation.

cond-mat.mes-hall↗

arXiv2015

Low-temperature characterization of Nb-Cu-Nb weak links with Ar ion-cleaned interfaces

We characterize niobium-based lateral Superconductor (S) - Normal metal (N) - Superconductor weak links through low-temperature switching current measurements and tunnel spectroscopy. We fabricate the SNS devices in two separate lithography and deposition steps, combined with strong argon ion cleaning before the normal metal deposition in the last step. Our SNS weak link consists of high-quality sputtered Nb electrodes that are contacted with evaporated Cu. The two-step fabrication flow enables great flexibility in the choice of materials and pattern design. A comparison of the temperature-dependent equilibrium critical supercurrent with theoretical predictions indicates that the quality of the Nb-Cu interface is similar to that of evaporated Al-Cu weak links. Aiming at increased sensitivity, range of operation temperatures, and thermal isolation, we investigate how these SNS structures can be combined with shadow-evaporated aluminum tunnel junctions for sensor applications that utilize the superconducting proximity effect. To this end, we demonstrate a hybrid magnetic flux sensor based on a Nb-Cu-Nb SNS junction, where the phase-dependent normal metal density of states is probed with an Al tunnel junction.

cond-mat.mes-hall↗