arXiv subjects

R. W. Whatmore

Publications and source records attributed to R. W. Whatmore.

6 recordsLinked to original sources

arXiv2021

Influence of charged walls and defects on DC resistivity and dielectric relaxation in Cu-Cl boracite

Charged domain walls form spontaneously in Cu-Cl boracite on cooling through the phase transition. These walls exhibit changed conductivity compared to the bulk and motion consistent with the existence of negative capacitance. Here, we present the dielectric permittivity and DC resistivity of bulk Cu-Cl boracite as a function of temperature (-140 °C to 150 °C) and frequency (1 mHz to 10 MHz). The thermal behaviour of the two observed dielectric relaxations and the DC resistivity is discussed. We propose that the relaxations can be explained by the existence of point defects, most likely local complexes created by a change of valence of Cu and accompanying oxygen vacancies. In addition, the sudden change in resistivity seen at the phase transition suggests that conductive domain walls contribute significantly to the conductivity in the ferroelectric phase.

cond-mat.mtrl-sci↗

arXiv2020

Quasi-indirect measurement of electrocaloric temperature change in PbSc0.5Ta0.5O3 via comparison of adiabatic and isothermal electrical polarization data

Electrically driven adiabatic changes of temperature are identified in the archetypal electrocaloric material PbSc0.5Ta0.5O3 by comparing isothermal changes of electrical polarization due to slow variation of electric field, and adiabatic changes of electrical polarization due to fast variation of electric field. By obtaining isothermal (adiabatic) electrical polarization data at measurement (starting) temperatures separated by <0.4 K, we identify a maximum temperature change of ~2 K due to a maximum field change of 26 kV cm-1, for starting temperatures in the range 300 - 315 K. These quasi indirect measurements combine with their direct, indirect and quasi-direct counterparts to complete the set, and could find routine use in future.

cond-mat.mtrl-sci↗

arXiv2020

Asymmetric electrocaloric effects in PbSc0.5Ta0.5O3 on field application and removal

Electrically driven thermal changes in PbSc0.5Ta0.5O3 bulk ceramics are investigated using temperature and electric-field dependent differential scanning calorimetry and infrared thermometry. On first application and removal of electric field, we find asymmetries in the magnitude of isothermal entropy change $Δ$ S and adiabatic temperature change $Δ$ T, due to hysteresis. On subsequent field cycling, we find further asymmetries in the magnitude of $Δ$ T due to non-linearity in the isofield legs of entropy-temperature plots.

cond-mat.mtrl-sci↗

arXiv2019

Electrocaloric cooling cycles in lead scandium tantalate with true regeneration via field variation

There is growing interest in heat pumps based on materials that show thermal changes when phase transitions are driven by changes of electric, magnetic or stress field. Importantly, regeneration permits sinks and loads to be thermally separated by many times the changes of temperature that can arise in the materials themselves. However, performance and parameterization are compromised by net heat transfer between caloric working bodies and heat transfer fluids. Here we show that this net transfer can be avoided-resulting in true, balanced regeneration-if one varies the applied electric field while an electrocaloric (EC) working body dumps heat on traversing a passive fluid regenerator. Our EC working body is represented by bulk PbSc0.5Ta0.5O3 (PST) near its first-order ferroelectric phase transition, where we record directly measured adiabatic temperature changes of up to 2.2 K. Indirectly measured adiabatic temperature changes of similar magnitude were identified, unlike normal, from adiabatic measurements of polarization, at nearby starting temperatures, without assuming a constant heat capacity. The resulting high-resolution field-temperature-entropy maps of our material, and a small clamped companion sample, were used to construct cooling cycles that assume the use of an ideal passive regenerator in order to span $\leq$20 K. These cooling cycles possess well defined coefficients of performance that are bounded by well defined Carnot limits, resulting in large ($>$50%) well defined efficiencies that are not unduly compromised by a small field hysteresis. Our approach permits the limiting performance of any caloric material in a passive regenerator to be established, optimized and compared; provides a recipe for true regeneration in prototype cooling devices; and could be extended to balance active regeneration.

cond-mat.mtrl-sci↗

arXiv2006

Giant electrocaloric effect in the thin film relaxor ferroelectric 0.9 PbMg_(1/3)Nb_(2/3)O_3 - 0.1 PbTiO_3 near room temperature

We have recently observed a giant electrocaloric effect (12 K in 25 V) in 350 nm sol-gel Pb Zr_0.95 Ti_0.05 O_3 films near the ferroelectric Curie temperature of 242oC. Here we demonstrate a giant electrocaloric effect (5 K in 25 V) in 260 nm sol-gel films of the relaxor ferroelectric 0.9 PbMg_(1/3)Nb_(2/3)O_3 - 0.1 PbTiO_3 near the Curie temperature of 60oC. This reduction in operating temperature widens the potential for applications in novel cooling systems.

cond-mat.mtrl-sci↗

arXiv2005

Giant electrocaloric effect in thin film Pb Zr_0.95 Ti_0.05 O_3

An applied electric field can reversibly change the temperature of an electrocaloric material under adiabatic conditions, and the effect is strongest near phase transitions. This phenomenon has been largely ignored because only small effects (0.003 K V^-1) have been seen in bulk samples such as Pb0.99Nb0.02(Zr0.75Sn0.20Ti0.05)0.98O3 and there is no consensus on macroscopic models. Here we demonstrate a giant electrocaloric effect (0.48 K V^-1) in 300 nm sol-gel PbZr0.95Ti0.05O3 films near the ferroelectric Curie temperature of 222oC. We also discuss a solid state device concept for electrical refrigeration that has the capacity to outperform Peltier or magnetocaloric coolers. Our results resolve the controversy surrounding macroscopic models of the electrocaloric effect and may inspire ab initio calculations of electrocaloric parameters and thus a targeted search for new materials.

cond-mat.mtrl-sci↗