arXiv subjects

R. Walczak

Publications and source records attributed to R. Walczak.

14 recordsLinked to original sources

arXiv2024

All-optical GeV electron bunch generation in a laser-plasma accelerator via truncated-channel injection

We describe a simple scheme, truncated-channel injection, to inject electrons directly into the wakefield driven by a drive pulse guided by an all-optical plasma channel. We use this approach to generate dark-current-free 1.2 GeV, 4.5 % relative energy spread electron bunches with 120 TW laser pulses guided in a 110-mm-long hydrodynamic optical-field-ionized (HOFI) plasma channel. Our experiments and particle-in-cell simulations show that high-quality electron bunches were only obtained when the drive pulse was closely aligned with the channel axis, and was focused close to the density down-ramp formed at the channel entrance. Start-to-end simulations of the channel formation, and electron injection and acceleration show that increasing the channel length to 410 mm would yield 3.65 GeV bunches, with a slice energy spread $\sim 5 \times 10^{-4}$.

physics.acc-ph↗

arXiv2023

Measurement of the decay of laser-driven linear plasma wakefields

We present the first measurements of the temporal decay rate of one-dimensional, linear Langmuir waves excited by an ultra-short laser pulse. Langmuir waves with relative amplitudes of approximately $6\%$ were driven by $1.7$ J, $50$ fs laser pulses in hydrogen and deuterium plasmas of density $n_{e0} = 8.4 \times 10^{17}$ cm$^{-3}$. The wakefield lifetimes were measured to be $τ^\mathrm{H_2}_\mathrm{wf} = (9\pm2)$ ps and $τ^\mathrm{D_2}_\mathrm{wf} = (16\pm8)$ ps respectively for hydrogen and deuterium. The experimental results were found to be in good agreement with 2D particle-in-cell simulations. In addition to being of fundamental interest, these results are particularly relevant to the development of laser wakefield accelerators (LWFAs) and wakefield acceleration schemes using multiple pulses, such as multi-pulse laser wakefield accelerators (MP-LWFAs).

physics.plasm-ph↗

arXiv2023

Demonstration of tunability of HOFI waveguides via start-to-end simulations

In recent years, hydrodynamic optical-field-ionized (HOFI) channels have emerged as a promising technique to create laser waveguides suitable for guiding tightly-focused laser pulses in a plasma, as needed for laser-plasma accelerators. While experimental advances in HOFI channels continue to be made, the underlying mechanisms and the roles of the main parameters remain largely unexplored. In this work, we propose a start-to-end simulation pipeline of the HOFI channel formation and the resulting guiding properties, and use it to explore the underlying physics and the tunability of HOFI channels. This approach is benchmarked against experimental measurements. HOFI channels are shown to feature excellent guiding properties over a wide range of parameters, making them a promising and tunable waveguide option for laser-plasma accelerators.

physics.plasm-ph↗

arXiv2022

Demonstration of kilohertz operation of Hydrodynamic Optical-Field-Ionized Plasma Channels

We demonstrate experimentally that hydrodynamic optical-field-ionized (HOFI) plasma channels can be generated at kHz-scale pulse repetition rates, in a static gas cell and for an extended period. Using a pump-probe arrangement, we show via transverse interferometry that the properties of two HOFI channels generated \SI{1}{ms} apart are essentially the same. We demonstrate that HOFI channels can be generated at a mean repetition rate of \SI{0.4}{kHz} for a period of 6.5 hours without degradation of the channel properties, and we determine the fluctuations in the key optical parameters of the channels in this period. Our results suggest that HOFI and conditioned HOFI channels are well suited for future high-repetition rate, multi-GeV plasma accelerator stages.

physics.plasm-ph↗

arXiv2021

GeV-scale accelerators driven by plasma-modulated pulses from kilohertz lasers

We describe a new approach for driving GeV-scale plasma accelerators with long laser pulses. We show that the temporal phase of a long, high-energy driving laser pulse can be modulated periodically by co-propagating it with low-amplitude plasma wave driven by a short, low-energy seed pulse. Compression of the modulated driver by a dispersive optic generates a train of short pulses suitable for resonantly driving a plasma accelerator. Modulation of the driver occures via well-controlled linear process, as confirmed by good agreement between particle-in-cell (PIC) simulations and an analytic model. PIC simulations demonstrate that a 1.7 J, 1 ps driver and a 140 mJ, 40 fs seed pulse can accelerate electrons to energies of 0.65 GeV in a plasma channel with an axial density of 2.5 x 10$^{17}$ cm$^{-3}$. This work opens a route to high-repetition-rate, GeV-scale plasma accelerators driven by thin-disk lasers, which can provide joule-scale, picosecond-duration laser pulses at multi-kilohertz repetition rates and high wall-plug efficiencies.

physics.acc-ph↗

arXiv2020

Meter-Scale, Conditioned Hydrodynamic Optical-Field-Ionized Plasma Channels

We demonstrate through experiments and numerical simulations that low-density, low-loss, meter-scale plasma channels can be generated by employing a conditioning laser pulse to ionize the neutral gas collar surrounding a hydrodynamic optical-field-ionized (HOFI) plasma channel. We use particle-in-cell simulations to show that the leading edge of the conditioning pulse ionizes the neutral gas collar to generate a deep, low-loss plasma channel which guides the bulk of the conditioning pulse itself as well as any subsequently injected pulses. In proof-of-principle experiments we generate conditioned HOFI (CHOFI) waveguides with axial electron densities of $n_\mathrm{e0} \approx 1 \times 10^{17} \; \mathrm{cm^{-3}}$, and a matched spot size of $26 \; \mathrm{μm}$. The power attenuation length of these CHOFI channels is $L_\mathrm{att} = (21 \pm 3) \; \mathrm{m}$, more than two orders of magnitude longer than achieved by HOFI channels. Hydrodynamic and particle-in-cell simulations demonstrate that meter-scale CHOFI waveguides with attenuation lengths exceeding 1 m could be generated with a total laser pulse energy of only $1.2$ J per meter of channel. The properties of CHOFI channels are ideally suited to many applications in high-intensity light-matter interactions, including multi-GeV plasma accelerator stages operating at high pulse repetition rates.

physics.acc-ph↗

arXiv2020

Guiding of high-intensity laser pulses in 100mm-long hydrodynamic optical-field-ionized plasma channels

Hydrodynamic optically-field-ionized (HOFI) plasma channels up to 100mm long are investigated. Optical guiding is demonstrated of laser pulses with a peak input intensity of $6\times10^{17}$ W cm$^{-2}$ through 100mm long plasma channels with on-axis densities measured interferometrically to be as low as $n_{e0} = (1.0\pm0.3)\times10^{17}$cm$^{-3}$. Guiding is also observed at lower axial densities, which are inferred from magneto-hydrodynamic simulations to be approximately $7\times10^{16}$cm$^{-3}$. Measurements of the power attenuation lengths of the channels are shown to be in good agreement with those calculated from the measured transverse electron density profiles. To our knowledge, the plasma channels investigated in this work are the longest, and have the lowest on-axis density, of any free-standing waveguide demonstrated to guide laser pulses with intensities above $>10^{17}$ W cm$^{-2}$.

physics.acc-ph↗

arXiv2019

Low-Density Hydrodynamic Optical-Field-Ionized Plasma Channels Generated With An Axicon Lens

We demonstrate optical guiding of high-intensity laser pulses in long, low density hydrodynamic optical-field-ionized (HOFI) plasma channels. An axicon lens is used to generate HOFI plasma channels with on-axis electron densities as low as $n_e(0) = 1.5\times 10^{17}\, \mathrm{cm}^{-3}$ and matched spot sizes in the range $ 20 μ\mathrm{m} \lesssim W_M \lesssim 40 μ\mathrm{m}$. Control of these channel parameters via adjustment of the initial cell pressure and the delay after the arrival of the channel-forming pulse is demonstrated. For laser pulses with a peak axial intensity of $4 \times 10^{17}\, \mathrm{W\,cm}^{-2}$, highly reproducible, high-quality guiding over more than 14 Rayleigh ranges is achieved at a pulse repetition rate of 5 Hz, limited by the available channel-forming laser and vacuum pumping system. Plasma channels of this type would seem to be well suited to multi-GeV laser wakefield accelerators operating in the quasi-linear regime.

physics.plasm-ph↗

arXiv2018

Reconstructing nonlinear plasma wakefields using a generalized temporally encoded spectral shifting analysis

We generalize the temporally encoded spectral shifting (TESS) analysis for measuring plasma wakefields using spectral interferometry to dissimilar probe pulses of arbitrary spectral profile and to measuring nonlinear wakefields. We demonstrate that the Gaussian approximation used up until now results in a substantial miscalculation of the wakefield amplitude, by a factor of up to two. A method to accurately measure higher amplitude quasilinear and nonlinear wakefields is suggested, using an extension to the TESS procedure, and we place some limits on its accuracy in these regimes. These extensions and improvements to the analysis demonstrate its potential for rapid and accurate on-shot diagnosis of plasma wakefields, even at low plasma densities.

physics.acc-ph↗

arXiv2014

High Power Fibre Laser System for a High Repetition Rate Laserwire

We present the development of a high power fibre laser system to investigate its suitability for use in a transverse electron beam profile monitor i.e. a laserwire. A system capable of producing individual pulses up to $165.8 \pm 0.4 μ$J at 1036 nm with a full-width at half-maximum of $1.92 \pm 0.12$ps at 6.49 MHz is demonstrated using a master oscillator power amplifier design with a final amplification stage in a rod-type photonic crystal fibre. The pulses are produced in trains of 1 ms in a novel burst mode amplification scheme to match the bunch pattern of the charged particles in an accelerator. This method allows pulse energies up to an order of magnitude greater than the steady-state value of $17.0 \pm 0.6 μ$J to be achieved at the beginning of the burst with a demonstrated peak power of $25.8 \pm 1.7$ MW after compression. The system is also shown to demonstrate excellent spatial quality with an $M^{2} = 1.26 \pm 0.01$ in both dimensions which would allow nearly diffraction limited focussing to be achieved.

physics.acc-ph↗

arXiv2014

Laserwire at the Accelerator Test Facility 2 with Sub-Micrometre Resolution

A laserwire transverse electron beam size measurement system has been developed and operated at the Accelerator Test Facility 2 (ATF2) at KEK. Special electron beam optics were developed to create an approximately 1 x 100 μm (vertical x horizontal) electron beam at the laserwire location, which was profiled using a 150 mJ, 71 ps laser pulse with a wavelength of 532 nm. The precise characterisation of the laser propagation allows the non-Gaussian transverse profiles of the electron beam caused by the laser divergence to be deconvolved. A minimum vertical electron beam size of 1.07 ${\pm}$ 0.06 (stat.) ${\pm}$ 0.05 (sys.) μm was measured. A vertically focussing quadrupole just before the laserwire was varied whilst making laserwire measurements and the projected vertical emittance was measured to be 82.56 ${\pm}$ 3.04 pm rad.

physics.acc-ph↗

arXiv2014

Multi-Pulse Laser Wakefield Acceleration: A New Route to Efficient, High-Repetition-Rate Plasma Accelerators and High Flux Radiation Sources

Laser-driven plasma accelerators can generate accelerating gradients three orders of magnitude larger than radio-frequency accelerators and have achieved beam energies above 1 GeV in centimetre long stages. However, the pulse repetition rate and wall-plug efficiency of plasma accelerators is limited by the driving laser to less than approximately 1 Hz and 0.1% respectively. Here we investigate the prospects for exciting the plasma wave with trains of low-energy laser pulses rather than a single high-energy pulse. Resonantly exciting the wakefield in this way would enable the use of different technologies, such as fibre or thin-disc lasers, which are able to operate at multi-kilohertz pulse repetition rates and with wall-plug efficiencies two orders of magnitude higher than current laser systems. We outline the parameters of efficient, GeV-scale, 10-kHz plasma accelerators and show that they could drive compact X-ray sources with average photon fluxes comparable to those of third-generation light source but with significantly improved temporal resolution. Likewise FEL operation could be driven with comparable peak power but with significantly larger repetition rates than extant FELs.

physics.acc-ph↗

arXiv2008

The Optical Alignment System of the ZEUS MicroVertex Detector

The laser alignment system of the ZEUS microvertex detector is described. The detector was installed in 2001 as part of an upgrade programme in preparation for the second phase of electron-proton physics at the HERA collider. The alignment system monitors the position of the vertex detector support structure with respect to the central tracking detector using semi-transparent amorphous-silicon sensors and diode lasers. The system is fully integrated into the general environmental monitoring of the ZEUS detector and data has been collected over a period of 5 years. The primary aim of defining periods of stability for track-based alignment has been achieved and the system is able to measure movements of the support structure to a precision around $10 μ$m.

physics.ins-det↗

arXiv2007

The design and performance of the ZEUS Micro Vertex detector

In order to extend the tracking acceptance, to improve the primary and secondary vertex reconstruction and thus enhancing the tagging capabilities for short lived particles, the ZEUS experiment at the HERA Collider at DESY installed a silicon strip vertex detector. The barrel part of the detector is a 63 cm long cylinder with silicon sensors arranged around an elliptical beampipe. The forward part consists of four circular shaped disks. In total just over 200k channels are read out using $2.9 {\rm m^2}$ of silicon. In this report a detailed overview of the design and construction of the detector is given and the performance of the completed system is reviewed.

physics.ins-det↗