arXiv subjects

Ranajit Ghose

Publications and source records attributed to Ranajit Ghose.

3 recordsLinked to original sources

arXiv2024

Recursive Interferometric Surface-wave Suppression For Improved Reflection Imaging

High-resolution seismic reflections are essential for imaging and monitoring applications. In seismic land surveys using sources and receivers at the surface, surface waves often dominate, masking the reflections. In this study, we demonstrate the efficacy of a two-step procedure to suppress surface waves in an active-source reflection seismic dataset. First, we apply seismic interferometry (SI) by cross-correlation, turning receivers into virtual sources to estimate the dominant surface waves. Then, we perform adaptive subtraction to minimise the difference between the surface waves in the original data and the result of SI. We propose a new approach where the initial suppression results are used for further iterations, followed by adaptive subtraction. This technique aims to enhance the efficacy of data-driven surface-wave suppression through an iterative process. We use a 2D seismic reflection dataset from Scheemda, situated in the Groningen province of the Netherlands, to illustrate the technique's efficiency. A comparison between the data after recursive interferometric surface-wave suppression and the original data across time and frequency-wavenumber domains shows significant suppression of the surface waves, enhancing visualization of the reflections for following subsurface imaging and monitoring studies.

physics.geo-ph↗

arXiv2023

Application of Marchenko-based isolation to a land S-wave seismic dataset

The overburden structures often can distort the responses of the target region in seismic data, especially in land datasets. Ideally, all effects of the overburden and underburden structures should be removed, leaving only the responses of the target region. This can be achieved using the Marchenko method. The Marchenko method is capable of estimating Green's functions between the surface of the Earth and arbitrary locations in the subsurface. These Green's functions can then be used to redatum wavefields to a level in the subsurface. As a result, the Marchenko method enables the isolation of the response of a specific layer or package of layers, free from the influence of the overburden and underburden. In this study, we apply the Marchenko-based isolation technique to land S-wave seismic data acquired in the Groningen province, the Netherlands. We apply the technique for combined removal of the overburden and underburden, which leaves the isolated response of the target region which is selected between 30 m and 270 m depth. Our results indicate that this approach enhances the resolution of reflection data. These enhanced reflections can be utilised for imaging and monitoring applications.

physics.geo-ph↗

arXiv2021

A new model for acoustic-poroelastic coupling of compressional body and Stoneley waves at a fault zone

In vertical seismic profiling (VSP), Stoneley (tube) waves are generated due to the coupling between the borehole fluid and the surrounding poroelastic formation. The tube waves have been exploited in the past to infer the in-situ hydraulic properties. In order to understand better the physical mechanisms underlying the generation of tube waves at a fault zone, we develop a new model that calculates the pressure responses in a borehole. The model incorporates simultaneous effects of elastic impedance boundaries, fluid infiltration from poroelastic formation, and irregularities in the borehole radius. The analytical tube-wave amplitudes are derived from the new model assuming a normally incident plane P wave, verified by complete numerical solutions for Biot's theory of dynamic poroelasticity. We find that the upgoing and downgoing tube waves due to an elastic impedance boundary have opposite polarities, and those excited by a thin poroelastic layer have different wave shapes. The model also enables the prediction of a VSP response at a major fault zone in Japan (Nojima fault). Our quantitative evaluation suggests that tube waves are generated by elastic impedance boundaries and borehole irregularities around the main shear zone of the fault, as well as due to the presence of several porous layers. We also find that the modeled amplitudes agree well with the observation, especially when assuming a heterogeneous permeability distribution. The developed model and the presented results will be crucial in quantitatively interpreting the VSP data in order to estimate the fault zone's hydraulic properties.

physics.geo-ph↗