arXiv subjects

Rangga P. Budoyo

Publications and source records attributed to Rangga P. Budoyo.

6 recordsLinked to original sources

arXiv2026

Characterization of Josephson Junction Aging and Annealing Under Different Environments

Understanding the aging behavior of Josephson junctions and the effect of annealing on junction resistances is important in building large-scale superconducting quantum processors. Here we study the effects of aging of Al/AlOx/Al Josephson junctions under different storage conditions from immediately after fabrication up to 2 to 3 months. We find that the aging curve follows a logarithmic curve, with the aging amplitude mainly determined by fabrication conditions and the aging rate determined by both fabrication and storage conditions. Junctions stored at ambient laboratory conditions aged faster compared to junctions stored in a nitrogen atmosphere or vacuum, with the aging speed appreciably changes when the storage condition changed. We also compared the effect of thermal annealing under nitrogen environment with annealing under ambient conditions up to 250$^\circ$C. We find that under nitrogen environment, the resistances decreased at all temperatures tested, while under ambient environment the resistances increased at 200$^\circ$C and decreased at 250$^\circ$C instead. We were unable to decrease the resistance below the initial-time resistance, suggesting a lower limit on the range of resistance tuning.

quant-ph↗

arXiv2025

Characterizing Noise in Controlling Superconducting Qubits

Meaningful quantum computing is currently bottlenecked by the error rates of current generation Noisy Intermediate Scale Quantum (NISQ) devices. To improve the fidelity of the quantum logic gates, it is essential to recognize the contributions of various sources of errors, including background noise. In this work, we investigate the effects of noise when applied to superconducting qubit control pulses to observe the dependency of the gate fidelity with the signal-to-noise ratio (SNR). We propose a model on how the noise of the control electronics interacts with the qubit system and demonstrate a method for characterizing the noise environment of the qubit control.

quant-ph↗

arXiv2022

ICARUS-Q: Integrated Control and Readout Unit for Scalable Quantum Processors

We present a control and measurement setup for superconducting qubits based on Xilinx 16-channel radio-frequency system-on-chip (RFSoC) device. The proposed setup consists of four parts: multiple RFSoC boards, a setup to synchronise every digital to analog converter (DAC), and analog to digital converter (ADC) channel across multiple boards, a low-noise direct current (DC) supply for tuning the qubit frequency and cloud access for remotely performing experiments. We also design the setup to be free of physical mixers. The RFSoC boards directly generate microwave pulses using sixteen DAC channels up to the third Nyquist zone which are directly sampled by its eight ADC channels between the fifth and the ninth zones.

quant-ph↗

arXiv2021

Ghost factors in Gauss-sum factorization with transmon qubits

A challenge in the Gauss sums factorization scheme is the presence of ghost factors - non-factors that behave similarly to actual factors of an integer - which might lead to the misidentification of non-factors as factors or vice versa, especially in the presence of noise. We investigate Type II ghost factors, which are the class of ghost factors that cannot be suppressed with techniques previously laid out in the literature. The presence of Type II ghost factors and the coherence time of the qubit set an upper limit for the total experiment time, and hence the largest factorizable number with this scheme. Discernability is a figure of merit introduced to characterize this behavior. We introduce preprocessing as a strategy to increase the discernability of a system, and demonstrate the technique with a transmon qubit. This can bring the total experiment time of the system closer to its decoherence limit, and increase the largest factorizable number.

quant-ph↗

arXiv2020

Electron Spin Resonance with up to 20 Spin Sensitivity Measured using a Superconducting Flux Qubit

We report on electron spin resonance spectroscopy measurements using a superconducting flux qubit with a sensing volume of 6 fl. The qubit is read out using a frequency-tunable Josephson bifurcation amplifier, which leads to an inferred measurement sensitivity of about 20 spins in a 1 s measurement. This sensitivity represents an order of magnitude improvement when compared with flux-qubit schemes using a dc-SQUID switching readout. Furthermore, noise spectroscopy reveals that the sensitivity is limited by flicker ($1/f$) flux noise.

quant-ph↗

arXiv2017

Electron Paramagnetic Resonance Spectroscopy of Er$^{3+}$:Y$_2$SiO$_5$ Using Josephson Bifurcation Amplifier: Observation of Hyperfine and Quadrupole Structures

We performed magnetic field and frequency tunable electron paramagnetic resonance spectroscopy of an Er$^{3+}$ doped Y$_2$SiO$_5$ crystal by observing the change in flux induced on a direct current-superconducting quantum interference device (dc-SQUID) loop of a tunable Josephson bifurcation amplifer. The observed spectra show multiple transitions which agree well with the simulated energy levels, taking into account the hyperfine and quadrupole interactions of $^{167}$Er. The sensing volume is about 0.15 pl, and our inferred measurement sensitivity (limited by external flux noise) is approximately $1.5\times10^4$ electron spins for a 1 s measurement. The sensitivity value is two orders of magnitude better than similar schemes using dc-SQUID switching readout.

cond-mat.supr-con↗