arXiv subjects

Reinhilde D'hulst

Publications and source records attributed to Reinhilde D'hulst.

7 recordsLinked to original sources

arXiv2026

Importance of Aggregated DER Installed Capacity in Distribution Networks

The increasing penetration of Distributed Energy Resources (DERs), particularly electric vehicles, heat pumps, and photovoltaic systems, is fundamentally changing power flows in Low-Voltage (LV) distribution networks. Despite this transition, Distribution System Operators (DSOs) often lack reliable and up-to-date knowledge of the DER capacity connected downstream of LV substations. Limited observability, incomplete topology information, and restricted access to customer-level data make it difficult to maintain accurate DER registries, creating uncertainty in both operational and planning processes. This paper presents aggregated DER installed capacity, estimated at LV aggregation points, as a practical and scalable approach to improving DER awareness without requiring customer-level monitoring. We define the problem of estimating DER installed capacities from commonly available substation and feeder measurements. By linking these estimates to operational and planning needs, we discuss how knowledge of aggregated DER installed capacity enhances DER-aware forecasting, congestion management, flexibility quantification, hosting capacity assessment, and monitoring of DER adoption.

eess.SY↗

arXiv2025

Low voltage user phase reconfiguration as a planning problem

Considerable levels of phase imbalance in low voltage (LV) distribution networks imply that grid assets are suboptimally utilized and can cause additional losses, equipment failure and degradation. With the ongoing energy transition, the installation of additional single-phase distributed energy resources may further increase the phase imbalance if no countermeasures are taken. Phase reconfiguration is a cost-effective solution to reduce imbalance. However, dynamic reconfiguration, through real-time phase swapping of loads using remotely controlled switches, is often impractical because these switches are too costly for widespread installation at LV users. Approaching phase reconfiguration as a planning problem, i.e. static reconfiguration, is an underaddressed but promising alternative. Effective static approaches that allow appropriate imbalance objectives are currently lacking. This paper presents reliable and expressive static phase reconfiguration methods that grid operators can easily integrate into routine maintenance for effective phase balancing. We present and compare three static methods, an exact mixed-integer nonlinear formulation (MINLP), a mixed-integer quadratic approximation (MIQP), and a genetic algorithm (GA), each supporting different imbalance objectives. The MIQP approach, despite using proxy objectives, efficiently mitigates the different types of imbalance considered, and outperforms both MINLP and GA in scalability and consistency.

eess.SY↗

arXiv2023

Phase Identification of Distribution System Users Through a MILP Extension of State Estimation

To address the challenges and exploit the opportunities that the decarbonization of the energy sector is bringing about, advanced distribution network management and operation strategies are being developed. Many of these require accurate network models to work effectively, including user phase connectivity. However, such information is often not available. This paper proposes a novel method to identify the phase connectivity of single- and three-phase distribution consumers using smart meter measurements. The method is based on state estimation and mixed-integer linear programming, and requires shorter measurement collection times compared to statistical and machine learning-based techniques, for the same level of accuracy. Consequently, the duration of measurement efforts/campaigns aimed at obtaining this type of information reduces, accelerating the system knowledge acquisition process and potentially reducing the campaigns' costs. A technique is illustrated that allows to solve large networks in acceptable time despite the considerable number of integer variables. Extensive computational results are presented for publicly available low voltage feeders.

eess.SY↗

arXiv2023

Combined Unbalanced Distribution System State and Line Impedance Matrix Estimation

To address the challenges that the decarbonization of the energy sector is bringing about, advanced distribution network management and operation strategies are being developed. Many of these strategies require accurate network models to work effectively. However, distribution network data are known to contain errors, and attention has been given to techniques that allow to derive improved network information. This paper presents a novel method to derive line impedance values from smart meter measurement time series, with realistic assumptions in terms of meter accuracy, resolution and penetration. The method is based on unbalanced state estimation and is cast as a non-convex quadratically constrained optimization problem. Both line lengths and impedance matrix models can be estimated based on an exact nonlinear formulation of the steady-state three-phase network physics. The method is evaluated on the IEEE European Low Voltage feeder (906 buses) and shows promising results.

eess.SY↗

arXiv2023

Exact Modeling of Non-Gaussian Measurement Uncertainty in Distribution System State Estimation

State estimation allows to monitor power networks, exploiting field measurements to derive the most likely grid state. In the literature, measurement errors are usually assumed to follow zero-mean Gaussian distributions; however, it has been shown that this assumption often does not hold. One such example is when considering pseudo-measurements. In distribution networks, a significant amount of pseudo-measurements might be necessary, due to the scarcity of real-time measurements. In this paper, a state estimator is presented which allows to model measurement uncertainty with any continuous distribution, without approximations. This becomes possible by writing state estimation as a general maximum-likelihood estimation-based constrained optimization problem. To realistically describe distribution networks, three-phase unbalanced power flow equations are used. Results are presented that illustrate the differences in accuracy and computational effort between different uncertainty modeling methods, for the IEEE European Low Voltage Test Feeder.

eess.SY↗

arXiv2022

Congestion Mitigation in Unbalanced Residential Networks with OPF-based Demand Management

This paper proposes a novel congestion mitigation strategy for low voltage residential feeders in which the rising power demand due to the electrification of the transport and heating systems leads to congestion problems. The strategy is based on requiring residential customers to limit their demand for a certain amount of time in exchange for economic benefits. The main novelty of the method consists of combining a thorough representation of the network physics with advanced constraints that ensure the comfort of residential users, in a scalable manner that suits real systems. The mitigation strategy is presented from a DSO perspective, and takes the form of contracts between users and system operator. The focus on user comfort aims to make the contracts appealing, encouraging users to voluntarily enroll in the proposed mitigation scheme. The presented solution is implemented as a mixed-integer multi-period optimal power flow problem which relies on a linearized three-phase power flow formulation. Calculations on 100 real-life distribution feeders are performed, to analyze the congestion-relieving potential of several possible system operator-user contracts. From a planning perspective, the results can help the system operator define contractual terms that make a specific congestion mitigation scheme effective and viable. From an operational perspective, the same calculations can be used to optimally schedule power reduction on a day-ahead basis.

eess.SY↗

arXiv2020

A framework for constrained static state estimation in unbalanced distribution networks

State estimation plays a key role in the transition from the passive to the active operation of distribution systems, as it allows to monitor these networks and, successively, to perform control actions. However, designing state estimators for distribution systems carries a significant amount of challenges. This is due to the physical complexity of the networks, e.g., phase unbalance, and limited measurements. Furthermore, the features of the distribution system present significant local variations, e.g., voltage level and number and type of customers, which makes it hard to design a "one-size-fits-all" state estimator. The present paper introduces a unifying framework that allows to easily implement and compare diverse unbalanced static state estimation models. This is achieved by formulating state estimation as a general constrained optimization problem. The advantages of this approach are described and supported by numerical illustration on a large set of distribution feeders. The framework is also implemented and made available open-source.

eess.SY↗