arXiv subjects

Renke Huang

Publications and source records attributed to Renke Huang.

24 records · Page 2Linked to original sources

arXiv2019

Optimal Future Sub-Transmission Volt-Var Planning Tool to Enable High PV Penetration

This paper proposes a reactive power planning tool for sub-transmission systems to mitigate voltage violations and fluctuations caused by high photovoltaic (PV) penetration and intermittency with a minimum investment cost. The tool considers all existing volt-ampere reactive (var) assets in both sub-transmission and distribution systems to reduce the need of new equipment. The planning tool coordinates with an operational volt-var optimization tool to determine all scenarios with voltage violations and verify the planning results. The planning result of each scenario is the solution of a proposed optimal power-flow framework with efficient techniques to handle a high number of discrete variables. The final planning decision is obtained from the planning results of all selected violated scenarios by using two different approaches - direct combination of all single-step solutions and final investment decision based only on the scenarios that are representative for the power-flow voltage violations at most time steps. The final planning decision is verified using a realistic large-scale sub-transmission system and 5-minute PV and load data. The results show a significant voltage violation reduction with a less investment cost for additional var equipment compared to conventional approaches.

eess.SY↗

arXiv2019

Electric Load and Power Forecasting Using Ensemble Gaussian Process Regression

We propose a new forecasting method for predicting load demand and generation scheduling. Accurate week-long forecasting of load demand and optimal power generation is critical for efficient operation of power grid systems. In this work, we use a synthetic data set describing a power grid with 700 buses and 134 generators over a 365-days period with data synthetically generated at an hourly rate. The proposed approach for week-long forecasting is based on the Gaussian process regression (GPR) method, with prior covariance matrices of the quantities of interest (QoI) computed from ensembles formed by up to twenty preceding weeks of QoI observations. Then, we use these covariances within the GPR framework to forecast the QoIs for the following week. We demonstrate that the the proposed ensemble GPR (EGPR) method is capable of accurately forecasting weekly total load demand and power generation profiles. The EGPR method is shown to outperform traditional forecasting methods including the standard GPR and autoregressive integrated moving average (ARIMA) methods.

cs.LG↗

arXiv2019

Parameters Calibration for Power Grid Stability Models using Deep Learning Methods

This paper presents a novel parameter calibration approach for power system stability models using automatic data generation and advanced deep learning technology. A PMU-measurement-based event playback approach is used to identify potential inaccurate parameters and automatically generate extensive simulation data, which are used for training a convolutional neural network (CNN). The accurate parameters will be predicted by the well-trained CNN model and validated by original PMU measurements. The accuracy and effectiveness of the proposed deep learning approach have been validated through extensive simulation and field data.

eess.SP↗

arXiv2019

Adaptive Power System Emergency Control using Deep Reinforcement Learning

Power system emergency control is generally regarded as the last safety net for grid security and resiliency. Existing emergency control schemes are usually designed off-line based on either the conceived "worst" case scenario or a few typical operation scenarios. These schemes are facing significant adaptiveness and robustness issues as increasing uncertainties and variations occur in modern electrical grids. To address these challenges, for the first time, this paper developed novel adaptive emergency control schemes using deep reinforcement learning (DRL), by leveraging the high-dimensional feature extraction and non-linear generalization capabilities of DRL for complex power systems. Furthermore, an open-source platform named RLGC has been designed for the first time to assist the development and benchmarking of DRL algorithms for power system control. Details of the platform and DRL-based emergency control schemes for generator dynamic braking and under-voltage load shedding are presented. Extensive case studies performed in both two-area four-machine system and IEEE 39-Bus system have demonstrated the excellent performance and robustness of the proposed schemes.

cs.LG↗

arXiv2017

A Comparative Study of Interface Techniques for Transmission and Distribution Dynamic Co-Simulation

Transmission and distribution dynamic co-simulation is a practical and effective approach to leverage existing simulation tools for transmission and distribution systems to simulate dynamic stability and performance of transmission and distribution systems in a systematic manner. Given that these tools are developed as stand-alone programs and there are inherent differences between them, interface techniques become critical to bridge them. Two important unsolved questions are: 1) which interface technique is better and should be used, and 2) how the modeling and simulation capabilities in these tools that are available and can be exploited for co-simulation should be considered when selecting an interface technique. To address these questions, this paper presents a comparative study for different interface techniques that can be employed for T and D dynamic co-simulation. The study provides insights into the pros and cons of each interface technique, and helps researchers make informed decisions on choosing the interface techniques.

eess.SY↗

arXiv2017

A Reference Implementation of WECC Composite Load Model in Matlab and GridPACK

The composite load model (CLM) proposed by the Western Electricity Coordinating Council (WECC) is gaining increasing traction in industry, particularly in North America. At the same time, it has been recognized that further improvements in structure, initialization and aggregation methods are needed to enhance model accuracy. However, the lack of an open-source implementation of the WECC CLM has become a roadblock for many researchers for further improvement. To bridge this gap, this paper presents the first open reference implementation of the WECC CLM. Individual load components and the CLM are first developed and tested in Matlab, then translated to the high performance computing (HPC) based, parallel simulation framework - GridPACK. The main contributions of the paper include: 1) presenting important yet undocumented details of modeling and initializing the CLM, particularly for a parallel simulation frame-work like GridPACK; 2) implementation details of the load components such as the single-phase air conditioner motor; 3) implementing the CLM in a modular and extensible manner. The implementation has been tested at both the component as well as system levels and benchmarked against commercial simulation programs, with satisfactory accuracy.

eess.SY↗