arXiv subjects

Richa Cutting

Publications and source records attributed to Richa Cutting.

3 recordsLinked to original sources

arXiv2025

Strong actuation and optomechanical application of mass loaded membranes

An increasing number of studies are moving towards the combination of quantum mechanics and gravity, where studying gravity from a very small source mass is a viable starting point. Preparing for such experiments, investigations of weak gravitational forces have employed mechanical resonators to detect time-dependent gravitational forces from actuated source masses. Here, we demonstrate a source mass approach which utilizes capacitive actuation of a 1 mg gold sphere embedded on a silicon nitride membrane, rather than piezoelectric or motorized actuation. The design simultaneously provides a method for microwave optomechanical implementation by coupling the membrane position to the electromagnetic mode of a 3D cavity. The cavity quality factor is not significantly compromised by electromagnetic leakage to the actuation electrode, allowing DC and kilohertz AC voltages to be introduced in the region where electric fields are strongly concentrated. We measure over 700 nm of driven oscillation amplitude and more than ten percent tunability in the mechanical resonance frequency of the loaded membrane, giving the potential to match the oscillations to the frequency range of a detector in future experiments. An optomechanical readout is demonstrated by measuring the cavity resonance at cryogenic temperatures, while room temperature measurements provide complimentary understanding of the mechanisms which influence the mechanical response, including repulsive contact due to collisions within the device.

physics.app-ph↗

arXiv2025

Amplitude Noise Cancellation of Microwave Tones

Carrier noise in coherent tones limits sensitivity and causes heating in many experimental systems, such as force sensors, time-keeping, and studies of macroscopic quantum phenomena. Much progress has been made to reduce carrier noise using phase noise cancellation techniques, however, in systems where amplitude noise dominates, these methods are ineffective. Here, we present a technique to reduce amplitude noise from microwave generators using feedback cancellation. The method uses a field-programmable gate array (FPGA) to reproduce noise with a tunable gain and time delay, resulting in destructive interference when combined with the original tone. The FPGA additionally allows for tuning of the frequency offset and bandwidth in which the noise is canceled. By employing the cancellation we observe 13 dB of noise power reduction at a 2 MHz offset from a 4 GHz microwave tone, lowering the total noise to the phase noise level. To verify its applicability we utilize the setup in a microwave optomechanics experiment to investigate the effect of generator noise on the sideband cooling of a 0.5 mm silicon nitride membrane resonator. We observe that with our technique the rate of externally induced cavity heating is reduced by a factor of 3.5 and the minimum oscillator occupation is lowered by a factor of 2. This method broadens the field of noise cancellation techniques, where amplitude noise is becoming an increasingly important consideration in microwave systems as phase noise performances improve over time.

physics.app-ph↗

arXiv2024

Near-ground state cooling in electromechanics using measurement-based feedback and Josephson parametric amplifier

Feedback-based control of nano- and micromechanical resonators can enable the study of macroscopic quantum phenomena and also sensitive force measurements. Here, we demonstrate the feedback cooling of a low-loss and high-stress macroscopic SiN membrane resonator close to its quantum ground state. We use the microwave optomechanical platform, where the resonator is coupled to a microwave cavity. The experiment utilizes a Josephson travelling wave parametric amplifier, which is nearly quantum-limited in added noise, and is important to mitigate resonator heating due to system noise in the feedback loop. We reach a thermal phonon number as low as 1.6, which is limited primarily by microwave-induced heating. We also discuss the sideband asymmetry observed when a weak microwave tone for independent readout is applied in addition to other tones used for the cooling. The asymmetry can be qualitatively attributed to the quantum-mechanical imbalance between emission and absorption. However, we find that the observed asymmetry is only partially due to this quantum effect. In specific situations, the asymmetry is fully dominated by a cavity Kerr effect under multitone irradiation.

quant-ph↗