arXiv subjects

Robin Cantor

Publications and source records attributed to Robin Cantor.

12 recordsLinked to original sources

arXiv2026

Aluminum-Based Superconducting Tunnel Junction Sensors for Nuclear Recoil Spectroscopy

The BeEST experiment is searching for sub-MeV sterile neutrinos by measuring nuclear recoil energies from the decay of $^7$Be implanted into superconducting tunnel junction (STJ) sensors. The recoil spectra are affected by interactions between the radioactive implants and the sensor materials. We are therefore developing aluminum-based STJs (Al-STJs) as an alternative to existing tantalum devices (Ta-STJs) to investigate how to separate material effects in the recoil spectrum from potential signatures of physics beyond the Standard Model. Three iterations of Al-STJs were fabricated. The first had electrode thicknesses similar to existing Ta-STJs. They had low responsivity and reduced resolution, but were used successfully to measure $^7$Be nuclear recoil spectra. The second iteration had STJs suspended on thin SiN membranes by backside etching. These devices had low leakage current, but also low yield. The final iteration was not backside etched, and the Al-STJs had thinner electrodes and thinner tunnel barriers to increase signal amplitudes. These devices achieved 2.96 eV FWHM energy resolution at 50 eV using a pulsed 355 nm (~3.5 eV) laser. These results establish Al-STJs as viable detectors for systematic material studies in the BeEST experiment.

physics.ins-det↗

arXiv2026

Next Generation Ta-STJ Sensor Arrays for BSM Physics Searches

The Beryllium Electron capture in Superconducting Tunnel junctions (BeEST) experiment uses superconducting tunnel junction (STJ) sensors to search for physics beyond the standard model (BSM) with recoil spectroscopy of the $\mathbf{^7}$Be EC decay into $\mathbf{^7}$Li. A pulsed UV laser is used to calibrate the STJs throughout the experiment with $\sim$20 meV precision. Phase-III of the BeEST experiment revealed a systematic calibration discrepancy between STJs. We found these artifacts to be caused by resistive crosstalk and by intensity variations of the calibration laser. For phase-IV of the BeEST experiment, we have removed the crosstalk by designing the STJ array so that each pixel has its own ground wire. We now also use a more stable UV laser for calibration. The new STJ arrays were fabricated at STAR Cryoelectronics and tested at LLNL and FRIB. They have the same high energy resolution of $\sim$1-2~eV in the energy range of interest below 100~eV as before, and they no longer exhibit the earlier calibration artifacts. We discuss the design changes and the STJ array performance for the next phase of the BeEST experiment.

physics.ins-det↗

arXiv2026

Shake-up and shake-off spectra in the electron capture decay of atomic $^7$Be

The most stringent laboratory-based experimental limits on the existence of sub-MeV sterile neutrinos are currently set by decay spectroscopy of radioactive $^7$Be embedded into superconducting sensors. The systematic uncertainties are dominated by the modeling of the electron shake-up and shake-off spectra that are not based on state-of-the-art atomic theory and do not include electron correlations or relativistic effects. We have used the multiconfiguration Dirac-Fock formalism to obtain correlated wavefunctions ab initio and compute all single and double shake processes in the electron capture decay of atomic $^7$Be. The simulations can explain some but not all of the observed spectral features, likely because the wave functions are modified by the Ta sensor material that the $^7$Be is embedded into. The new models also show that the L/K electron capture ratio of $^7$Be in Ta has previously been slightly underestimated revising the previous value of 0.070(7) to a new value of 0.0756(20).

physics.atom-ph↗

arXiv2025

Precision measurement and modelling of the threshold-free 210Pb β spectrum

Beta decay is a fundamental process that governs nuclear stability and serves as a sensitive probe of the weak interaction and possible physics beyond the Standard Model of particle physics. However, precise measurements of complete $β$ decay spectra, particularly at low energies, remain experimentally and theoretically challenging. Here we report a high-precision, threshold-free measurement of the full $β$ decay spectrum of 210Pb to excited states of 210Bi, using a transition-edge sensor (TES)-based micro-calorimeter. This approach enables the detection of $β$ particle energies from 0 keV up to their endpoint by coincidence summing with subsequent de-excitation energy, thereby eliminating reconstruction artifacts near zero energy that have traditionally limited low-energy spectral accuracy. To our knowledge, this is the first complete, high-precision $β$ decay spectrum from 0 keV. The data resolve theoretical uncertainties associated with the atomic quantum exchange (AQE) effect. An accompanying ab initio theoretical framework, incorporating atomic, leptonic, and nuclear components, predicts a statistically significant (7.2 {$σ$}) enhancement in $β$ emission probability near zero energy, in agreement with the measurement and in contrast to models that omit AQE corrections. These results provide a new benchmark for $β$ decay theory at low energies, deepen our understanding of the weak interaction, and establish a critical foundation for searches for new physics, including dark matter interactions and precision studies of neutrinos.

nucl-ex↗

arXiv2025

Signal processing and spectral modeling for the BeEST experiment

The Beryllium Electron capture in Superconducting Tunnel junctions (BeEST) experiment searches for evidence of heavy neutrino mass eigenstates in the nuclear electron capture decay of $^7$Be by precisely measuring the recoil energy of the $^7$Li daughter. In Phase-III, the BeEST experiment has been scaled from a single superconducting tunnel junction (STJ) sensor to a 36-pixel array to increase sensitivity and mitigate gamma-induced backgrounds. Phase-III also uses a new continuous data acquisition system that greatly increases the flexibility for signal processing and data cleaning. We have developed procedures for signal processing and spectral fitting that are sufficiently robust to be automated for large data sets. This article presents the optimized procedures before unblinding the majority of the Phase-III data set to search for physics beyond the standard model.

physics.ins-det↗

arXiv2024

Effects of Strong Capacitive Coupling Between Meta-Atoms in rf SQUID Metamaterials

We consider, for the first time, the effects of strong capacitive and inductive coupling between radio frequency Superconducting Quantum Interference Devices (rf SQUIDs) in an overlapping metamaterial geometry when driven by rf flux at and near their self-resonant frequencies. The equations of motion for the gauge-invariant phases on the Josephson junctions in each SQUID are set up and solved. Our model accounts for the high-frequency displacement currents through capacitive overlap between the wiring of SQUID loops. We begin by modeling two overlapping SQUIDs and studying the response in both the linear and nonlinear high-frequency driving limits. By exploring a sequence of more and more complicated arrays, the formalism is eventually extended to the $N\times N \times 2$ overlapping metamaterial array, where we develop an understanding of the many ($8N^2-8N+3$) resulting resonant modes in terms of three classes of resonances. The capacitive coupling gives rise to qualitatively new self-resonant responses of rf SQUID metamaterials, and is demonstrated through analytical theory, numerical modeling, and experiment in the 10-30 GHz range on capacitively and inductively coupled rf SQUID metamaterials.

cond-mat.supr-con↗

arXiv2024

Direct Experimental Constraints on the Spatial Extent of a Neutrino Wavepacket

Despite their high relative abundance in our Universe, neutrinos are the least understood fundamental particles of nature. They also provide a unique system to study quantum coherence and the wavelike nature of particles in fundamental systems due to their extremely weak interaction probabilities. In fact, the quantum properties of neutrinos emitted in experimentally relevant sources are virtually unknown and the spatial extent of the neutrino wavepacket is only loosely constrained by reactor neutrino oscillation data with a spread of 13 orders of magnitude. Here, we present the first direct limits of this quantity through a new experimental concept to extract the energy width, $σ_{\textrm{N},E}$, of the recoil daughter nucleus emitted in the nuclear electron capture (EC) decay of $^7$Be. The final state in the EC decay process contains a recoiling $^7$Li nucleus and an electron neutrino ($ν_e$) which are entangled at their creation. The $^7$Li energy spectrum is measured to high precision by directly embedding $^7$Be radioisotopes into a high resolution superconducting tunnel junction that is operated as a cryogenic sensor. The lower limit on the spatial uncertainty of the recoil daughter was found to be $σ_{\textrm{N}, x} \geq 6.2$\,pm, which implies the final-state system is localized at a scale more than a thousand times larger than the nucleus itself. From this measurement, the first direct lower limits on the spatial extent of the neutrino wavepacket were extracted using two different theoretical methods. These results have wide-reaching implications in several areas including the nature of spatial localization at sub-atomic scales, interpretation of neutrino physics data, and the potential reach of future large-scale experiments.

nucl-ex↗

arXiv2023

Precise determination of $^{210}$Pb $β$ Decay Spectrum at 0 keV and its Implication to Theoretical Calculations

The atomic exchange effect will lead to a significant increase in the probability density of $β$ decays below a few keV. This effect is very important for scientific experiments that performed by low-energy electron spectroscopy measurements. However, the atomic exchange effect involves multi-electron interactions, especially for a system with 82 electrons such as lead. Different parameters will lead to different trends in the energy spectrum predicted by the theory, so it is urgent to carry out experimental measurements to provide parameter limits for the theory. The probability increase brought about by the atomic exchange effect is most obvious near 0keV, and the $β$ energy spectrum is accurately measured near this energy point, so as to provide constraints for the physical model of atomic exchange. However, it is extremely difficult to measure the $β$ energy spectrum at 0keV due to the limitations of electronic noise and internal conversion effects. The excited decay path of $^{210}$Pb was taken as the observation object,by measuring the total energy spectrum of $β$ rays and cascaded gamma rays, the precise measurement of the $β$ energy spectrum near 0keV has been completed. The analysis of the $β$ energy spectrum of $^{210}$Pb gives the following conclusions. The experimental results first verified the theory that the exchange effect causes the probability increase at the low energy end near 0keV. At the same time, the experimental results are higher than the existing predictions of the atomic exchange effect. At least for Pb element, all the electron shells have played a role in improving the probability density of the low end of the $β$ energy spectrum. This discovery will promote the theoretical calculation of the $β$ energy spectrum of $^{214}$Pb, at the same time, it also indicates that the reactor neutrinos have a higher probability density at the omnipotent end.

nucl-ex↗

arXiv2022

Transition edge sensor based detector: from X-ray to $γ$-ray

The Transition Edge Sensor is extremely sensitive to the change of temperature, combined with the high-Z metal of a certain thickness, it can realize the high energy resolution measurement of particles such as X-rays. X-rays with energies below 10 keV have very weak penetrating ability, so only a few microns thick of gold or bismuth can obtain quantum efficiency higher than 70\%. Therefore, the entire structure of the TES X-ray detector in this energy range can be realized in the microfabrication process. However, for X-rays or gamma rays from 10 keV to 200 keV, sub-millimeter absorber layers are required, which cannot be realized by microfabrication process. This paper first briefly introduces a set of TES X-ray detectors and their auxiliary systems built by ShanghaiTech University, then focus on the introduction of the TES $γ$-ray detector, with absorber based on an sub-millimeter lead-tin alloy sphere. The detector has a quantum efficiency above 70\% near 100 keV, and an energy resolution of about 161.5eV@59.5keV.

physics.ins-det↗

arXiv2017

Photon noise from chaotic and coherent millimeter-wave sources measured with horn-coupled, aluminum lumped-element kinetic inductance detectors

We report photon-noise limited performance of horn-coupled, aluminum lumped-element kinetic inductance detectors at millimeter wavelengths. The detectors are illuminated by a millimeter-wave source that uses an active multiplier chain to produce radiation between 140 and 160 GHz. We feed the multiplier with either amplified broadband noise or a continuous-wave tone from a microwave signal generator. We demonstrate that the detector response over a 40 dB range of source power is well-described by a simple model that considers the number of quasiparticles. The detector noise-equivalent power (NEP) is dominated by photon noise when the absorbed power is greater than approximately 1 pW, which corresponds to $\mathrm{NEP} \approx 2 \times 10^{-17} \, \mathrm{W} \, \mathrm{Hz}^{-1/2}$, referenced to absorbed power. At higher source power levels we observe the relationships between noise and power expected from the photon statistics of the source signal: $\mathrm{NEP} \propto P$ for broadband (chaotic) illumination and $\mathrm{NEP} \propto P^{1/2}$ for continuous-wave (coherent) illumination.

astro-ph.IM↗

arXiv2016

Magnetic field dependence of the internal quality factor and noise performance of lumped-element kinetic inductance detectors

We present a technique for increasing the internal quality factor of kinetic inductance detectors (KIDs) by nulling ambient magnetic fields with a properly applied magnetic field. The KIDs used in this study are made from thin-film aluminum, they are mounted inside a light-tight package made from bulk aluminum, and they are operated near $150 \, \mathrm{mK}$. Since the thin-film aluminum has a slightly elevated critical temperature ($T_\mathrm{c} = 1.4 \, \mathrm{K}$), it therefore transitions before the package ($T_\mathrm{c} = 1.2 \, \mathrm{K}$), which also serves as a magnetic shield. On cooldown, ambient magnetic fields as small as approximately $30 \, \mathrm{μT}$ can produce vortices in the thin-film aluminum as it transitions because the bulk aluminum package has not yet transitioned and therefore is not yet shielding. These vortices become trapped inside the aluminum package below $1.2 \, \mathrm{K}$ and ultimately produce low internal quality factors in the thin-film superconducting resonators. We show that by controlling the strength of the magnetic field present when the thin film transitions, we can control the internal quality factor of the resonators. We also compare the noise performance with and without vortices present, and find no evidence for excess noise beyond the increase in amplifier noise, which is expected with increasing loss.

astro-ph.IM↗

arXiv2010

Optical NEP in Hot-Electron Nanobolometers

For the first time, we have measured the optical noise equivalent power (NEP) in titanium (Ti) superconducting hot-electron nanobolometers (nano-HEBs). The bolometers were 2μmx1μmx20nm and 1μmx1μmx20nm planar antenna-coupled devices. The measurements were done at λ = 460 μm using a cryogenic black body radiation source delivering optical power from a fraction of a femtowatt to a few 100s of femtowatts. A record low NEP = 3x10^{-19} W/Hz^{1/2} at 50 mK has been achieved. This sensitivity meets the requirements for SAFARI instrument on the SPICA telescope. The ways for further improvement of the nano-HEB detector sensitivity are discussed.

astro-ph.IM↗