arXiv subjects

Rodolfo Ostilla Mónico

Publications and source records attributed to Rodolfo Ostilla Mónico.

8 recordsLinked to original sources

arXiv2022

The Effect of Modulated Driving on Non-rotating and Rotating Turbulent Plane Couette Flow

Direct numerical simulations of turbulent non-rotating and rotating Plane Couette Flow with a periodically modulated plate velocity are conducted to study the effect of modulated forcing on turbulent shear flows. The time averaged shear Reynolds number is fixed to $Re_S = 3 \cdot 10^4$, which results in a frictional Reynolds number of approximately $Re_τ\approx 400$. The modulating frequency is varied in the range $Wo\in(20,200)$, while the modulating amplitude is kept fixed at $10\%$ of the shear velocity except to demonstrate that varying this parameter changes little. The resulting shear at the plates are found to be independent of the forcing frequency, and equal to the non-modulated baseline. For the non-rotating simulations, two clear flow regions can be seen: a near wall region that follows Stokes' theoretical solution, and a bulk region that behaves similar to Stokes' solutions but with an increased effective viscosity. For high driving frequencies, the amplitude response follows the scaling laws for modulated turbulence of von der Heydt \emph{et al.} (Physical Review E 67, 046308 (2003)). Cyclonic rotation is not found to modify the system's behaviour in a substantial way, but anti-cyclonic rotation significantly changes the system's response to periodic forcing. We find that the persistent axial inhomogeneities introduced by mild anti-cyclonic rotation make it impossible to measure the propagation of the modulation adequately, while stronger anti-cyclonic rotation creates regions where the modulation travels instantaneously.

physics.flu-dyn↗

arXiv2017

Effects of the computational domain size on direct numerical simulations of Taylor-Couette turbulence with stationary outer cylinder

In search for the cheapest but still reliable numerical simulation, a systematic study on the effect of the computational domain ("box") size on direct numerical simulations of Taylor-Couette flow was performed. Four boxes, with varying azimuthal and axial extents were used. The radius ratio between the inner cylinder and the outer cylinder was fixed to $η=r_i/r_o=0.909$, and the outer was kept stationary, while the inner rotated at a Reynolds number $Re_i=10^5$. Profiles of mean and fluctuation velocities are compared, as well as autocorrelations and velocity spectra. The smallest box is found to accurately reproduce the torque and mean azimuthal velocity profiles of larger boxes, while having smaller values of the fluctuations than the larger boxes. The axial extent of the box directly reflects on the Taylor-rolls and plays a crucial role on the correlations and spectra. The azimuthal extent is also found to play a significant role, as larger boxes allow for azimuthal wave-like patterns in the Taylor rolls to develop, which affects the statistics in the bulk region. For all boxes studied, the spectra does not reach a box independent maximum.

physics.flu-dyn↗

arXiv2016

Direct numerical simulation of Taylor-Couette flow with grooved walls: torque scaling and flow structure

We present direct numerical simulations of Taylor-Couette flow with grooved walls at a fixed radius ratio $η=r_i/r_o=0.714$ with inner cylinder Reynolds number up to $Re_i=3.76\times10^4$, corresponding to Taylor number up to $Ta=2.15\times10^9$. The grooves are axisymmetric V-shaped obstacles attached to the wall with a tip angle of $90^\circ$. Results are compared to the smooth wall case in order to investigate the effects of grooves on Taylor-Couette flow. We focus on the effective scaling laws for the torque, flow structures, and boundary layers. It is found that, when the groove height is smaller than the boundary layer thickness, the torque is the same as that of the smooth wall cases. With increasing $Ta$, the boundary layer thickness becomes smaller than the groove height. Plumes are ejected from the tips of the grooves and secondary circulations between the latter are formed. This is associated to a sharp increase of the torque and thus the effective scaling law for the torque vs. $Ta$ becomes much steeper. Further increasing $Ta$ does not result in an additional slope increase. Instead, the effective scaling law saturates to the "ultimate" regime effective exponents seen for smooth walls. It is found that even though after saturation the slope is the same as for the smooth wall case, the absolute value of torque is increased, and the more the larger size of the grooves.

physics.flu-dyn↗

arXiv2015

The effect of velocity boundary conditions on the heat transfer and flow topology in two-dimensional Rayleigh-Bénard convection

The effect of various velocity boundary condition is studied in two-dimensional Rayleigh-Bénard convection. Combinations of no-slip, stress-free and periodic boundary conditions are used on both the sidewalls and the horizontal plates. For the studied Rayleigh numbers Ra between $10^8$ and $10^{11}$ the heat transport is lower for $Γ= 0.33$ than for $Γ= 1$ in case of no-slip sidewalls. This is surprisingly opposite for stress-free sidewalls, where the heat transport increases for lower aspect-ratio. In wider cells the aspect-ratio dependence is observed to disappear for $\text{Ra} \ge 10^{10}$. Two distinct flow types with very different dynamics can be seen, mostly dependent on the plate velocity boundary condition, namely roll-like flow and horizontal zonal flow, which have a substantial effect on the dynamics and heat transport in the system. The predominantly horizontal zonal flow suppresses heat flux and is observed for stress-free and asymmetric plates. Low aspect-ratio periodic sidewall simulations with a no-slip boundary condition on the plates also exhibit zonal flow. In all the other cases, the flow is roll-like. In two-dimensional Rayleigh-Bénard convection, the velocity boundary conditions thus have large implications on both roll-like and zonal flow that have to be taken into consideration before the boundary conditions are imposed.

physics.flu-dyn↗

arXiv2015

A pencil distributed finite difference code for strongly turbulent wall-bounded flows

We present a numerical scheme geared for high performance computation of wall-bounded turbulent flows. The number of all-to-all communications is decreased to only six instances by using a two-dimensional (pencil) domain decomposition and utilizing the favourable scaling of the CFL time-step constraint as compared to the diffusive time-step constraint. As the CFL condition is more restrictive at high driving, implicit time integration of the viscous terms in the wall-parallel directions is no longer required. This avoids the communication of non-local information to a process for the computation of implicit derivatives in these directions. We explain in detail the numerical scheme used for the integration of the equations, and the underlying parallelization. The code is shown to have very good strong and weak scaling to at least 64K cores.

physics.flu-dyn↗

arXiv2014

Exploring the phase diagram of fully turbulent Taylor-Couette flow

Direct numerical simulations of Taylor-Couette flow (TC). Shear Reynolds numbers of up to $3\cdot10^5$, corresponding to Taylor numbers of $Ta=4.6\cdot10^{10}$, were reached. Effective scaling laws for the torque are presented. The transition to the ultimate regime, in which asymptotic scaling laws (with logarithmic corrections) for the torque are expected to hold up to arbitrarily high driving, is analysed for different radius ratios $η$, different aspect ratios $Γ$ and different rotation ratios $Ro$. It is shown that the transition is approximately independent of $Ro$ and $Γ$, but depends significantly on $η$. We furthermore calculate the local angular velocity profiles and visualize different flow regimes that depend both on the shearing of the flow, and the Coriolis force originating from the outer cylinder rotation. Two main regimes are distinguished, based on the magnitude of the Coriolis force, namely the co-rotating and weakly counter-rotating regime dominated by Rayleigh-unstable regions, and the strongly counter-rotating regime where a mixture of stable and unstable regions exist. Furthermore, an analogy between $η$ and outer-cylinder rotation is revealed, namely that smaller gaps behave like a wider gap with co-rotating cylinders, and that wider gaps behave like smaller gaps with weakly counter-rotating cylinders. Finally, the effect of $Γ$ on the effective torque versus $Ta$ scaling is analysed and it is shown that different branches of the torque-versus-$Ta$ relationships associated to different aspect ratios are found to cross within $15%$ of the $Re$ associated to the transition to the ultimate regime. The paper culminates in phase diagram in the inner vs outer $Re$ number parameter space and in the $Ta$ vs $Ro$ parameter space, which can be seen as the extension of the Andereck \emph{et al.} phase diagram towards the ultimate regime.

physics.flu-dyn↗

arXiv2013

Turbulence decay towards the linearly-stable regime of Taylor-Couette flow

Taylor-Couette (TC) flow is used to probe the hydrodynamical stability of astrophysical accretion disks. Experimental data on the subcritical stability of TC are in conflict about the existence of turbulence (cf. Ji et al. Nature, 444, 343-346 (2006) and Paoletti et al., A$\&$A, 547, A64 (2012)), with discrepancies attributed to end-plate effects. In this paper we numerically simulate TC flow with axially periodic boundary conditions to explore the existence of sub-critical transitions to turbulence when no end-plates are present. We start the simulations with a fully turbulent state in the unstable regime and enter the linearly stable regime by suddenly starting a (stabilizing) outer cylinder rotation. The shear Reynolds number of the turbulent initial state is up to $Re_s \sim10^5$ and the radius ratio is $η=0.714$. The stabilization causes the system to behave as a damped oscillator and correspondingly the turbulence decays. The evolution of the torque and turbulent kinetic energy is analysed and the periodicity and damping of the oscillations are quantified and explained as a function of shear Reynolds number. Though the initially turbulent flow state decays, surprisingly, the system is found to absorb energy during this decay.

physics.flu-dyn↗

arXiv2012

Optimal Taylor-Couette flow: direct numerical simulations

We numerically simulate turbulent Taylor-Couette flow for independently rotating inner and outer cylinders, focusing on the analogy with turbulent Rayleigh-Bénard flow. Reynolds numbers of $Re_i=8\cdot10^3$ and $Re_o=\pm4\cdot10^3$ of the inner and outer cylinders, respectively, are reached, corresponding to Taylor numbers Ta up to $10^8$. Effective scaling laws for the torque and other system responses are found. Recent experiments with the Twente turbulent Taylor-Couette ($T^3C$) setup and with a similar facility in Maryland at very high Reynolds numbers have revealed an optimum transport at a certain non-zero rotation rate ratio $a = -ω_o / ω_i$ of about $a_{opt}=0.33-0.35$. For large enough $Ta$ in the numerically accessible range we also find such an optimum transport at non-zero counter-rotation. The position of this maximum is found to shift with the driving, reaching a maximum of $a_{opt}=0.15$ for $Ta=2.5\cdot10^7$. An explanation for this shift is elucidated, consistent with the experimental result that $a_{opt}$ becomes approximately independent of the driving strength for large enough Reynolds numbers. We furthermore numerically calculate the angular velocity profiles and visualize the different flow structures for the various regimes. By writing the equations in a frame co-rotating with the outer cylinder a link is found between the local angular velocity profiles and the global transport quantities.

physics.flu-dyn↗