arXiv subjects

Rohit Pratyush Behera

Publications and source records attributed to Rohit Pratyush Behera.

3 recordsLinked to original sources

arXiv2024

Ultrafast high-temperature sintering of dense and textured alumina

Crystallographic texture engineering in ceramics is essential to achieve direction-specific properties. Current texture engineering methods are time-consuming, energy extensive, or can lead to unnecessary diffusion of added dopants. Herein, we explore ultrafast high-temperature sintering (UHS) to prepare dense and textured alumina using templated grain growth (TGG). From a slurry containing alumina microplatelets coated with Fe3O4 nanoparticles dispersed in a matrix of alumina nanoparticles, green bodies with oriented microplatelets were prepared using magnetic assisted slip casting (MASC). The effects of the sintering temperature, time and heating rate on the density and microstructure of the obtained ceramics were then studied. We found that TGG occurs for a temperature range between 1640 and 1780 °C and 10 s sintering time. Sintering at 1700 °C for 10 s led to dense and textured alumina with anisotropic grains thanks to the Fe3O4 coating, which did not have the time to diffuse. The highest texture and relative density were obtained with a heating rate of ~5,500 °C/min, leading to texture-dependent anisotropic mechanical properties. This study opens new avenues for fabricating textured ceramics in ultra-short times.

cond-mat.mtrl-sci↗

arXiv2024

Effect of interfacial Fe3O4 nanoparticles on the microstructure and mechanical properties of textured alumina densified by ultrafast high-temperature sintering

Alumina microplatelets coated with a small amount of Fe3O4 can be oriented via a rotating magnetic field to create texture. After ultrafast high-temperature sintering (UHS), Fe atoms are found at the grain boundaries and within the grains, influencing the mechanical properties. Here, we compare the microstructure and mechanical properties of textured alumina prepared with and without Fe3O4 and sintered using UHS or conventional sintering (CS). Microstructural analysis using electron backscattering diffraction (EBSD) indicates that Fe3O4 induces crystallographic defects in the ceramic after UHS. Nanoindentation measurements enlighten that the presence of Fe3O4 leads to plastic flow that increases the energy dissipation, reaching ~122 % at a maximum load of 1900 mN compared to pristine samples. Overall, due to the concentrated effects of Fe3O4 after UHS, the flexural strength and fracture toughness values are higher than the other two samples, reaching values of ~287 MPa and 7 MPa.m0.5, respectively. These results could be leveraged to produce stronger and tougher ceramics.

cond-mat.mtrl-sci↗

arXiv2021

Porous textured ceramics with controlled grain size and orientation

Texture in dense or porous ceramics can enhance their functional and structural properties. Current methods for texturation employ anisotropic particles as starting powders and processes that drive their orientation into specific directions. Using ultra-low magnetic fields combined with slip casting, it is possible to purposely orient magnetically responsive particles in any direction. When those particles are suspended with nanoparticles, templated grain growth occurs during sintering to yield a textured ceramic. Yet, the final grains are usually micrometric, leading weak mechanical properties. Here, we explore how to tune the grain orientation size using magnetic slip casting and templated grain growth. Our strategy consists in changing the size of the anisotropic powders and ensuring that magnetic alignment and densification occurs. The obtained ceramics featured a large range of grain anisotropy, with submicrometric thickness and anisotropic properties. Textured ceramics with tunable grains dimensions and porosity are promising for filtering, biomedical or composite applications.

cond-mat.mtrl-sci↗