arXiv subjects

Rory E. O'Neill

Publications and source records attributed to Rory E. O'Neill.

5 recordsLinked to original sources

arXiv2026

Cooking crystalline candies and the ductile to brittle transition in concentrated suspensions

The existence and origin of the ductile to brittle transition in non-Brownian suspensions and pastes is underexplored despite the ubiquity of such materials in practical applications. We demonstrate the phenomenon in candies of sugar crystals in a water-protein-fat matrix prepared by boiling a sugar-cream-butter mixture (known as 'fudge' in some countries). As cooking time or final cooking temperature increases, we observe a transition from a fluid to a ductile solid, then to a brittle solid that abruptly fractures in compression. We propose that this is driven by rising solid sugar crystal volume fraction, and indeed find the same sequence of behaviour in a suspension of non-Brownian calcite particles as the solid fraction moves from frictional jamming to random close packing. Particle-based simulations reveal the sensitivity of the observed phenomenon to boundary conditions.

cond-mat.soft↗

arXiv2024

Fresh Cement as a Frictional Non-Brownian Suspension

Cement is an essential construction material due to its ability to flow before later setting, however the rheological properties must be tightly controlled. Despite this, much understanding remains empirical. Using a combination of continuous and oscillatory shear flow, we compare fresh Portland cement suspensions to previous measurements on model non-Brownian suspensions to gain a micro-physical understanding. Comparing steady and small-amplitude oscillatory shear, we reveal two distinct jamming concentrations, $ϕ_μ$ and $ϕ_{\rm rcp}$, where the respective yield stresses diverge. As in model suspensions, the steady-shear jamming point is notably below the oscillatory jamming point, $ϕ_μ < ϕ_{\rm rcp}$, suggesting that it is tied to frictional particle contacts. These results indicate that recently established models for the rheology of frictional, adhesive non-Brownian suspensions can be applied to fresh cement pastes, offering a new framework to understand the role of additives and fillers. Such micro-physical understanding can guide formulation changes to improve performance and reduce environmental impact.

cond-mat.soft↗

arXiv2023

Optimising non-Newtonian fluids for impact protection of laminates

Non-Newtonian fluids can be used for the protection of flexible laminates. Understanding the coupling between the flow of the protecting fluid and the deformation of the protected solids is necessary in order to optimise this functionality. We present a scaling analysis of the problem based on a single coupling variable, the effective width of a squeeze flow between flat rigid plates, and predict that impact protection for laminates is optimised by using shear-thinning, and not shear-thickening, fluids. The prediction is verified experimentally by measuring the velocity and pressure in impact experiments. Our scaling analysis should be generically applicable for non-Newtonian fluid-solid interactions in diverse applications.

physics.flu-dyn↗

arXiv2020

Turning a yield-stress calcite suspension into a shear-thickening one by tuning inter-particle friction

We show that a suspension of non-Brownian calcite particles in glycerol-water mixtures can be tuned continuously from being a yield-stress suspension to a shear-thickening suspension--without a measurable yield stress--by the addition of various surfactants. We interpret our results within a recent theoretical framework that models the rheological effects of stress-dependent constraints on inter-particle motion. Bare calcite particle suspensions are found to have finite yield stresses. In these suspensions, frictional contacts that constrain inter-particle sliding form at an infinitesimal applied stress and remain thereafter, while adhesive bonds that constrain inter-particle rotation are broken as the applied stress increases. Adding surfactants reduces the yield stress of such suspensions. We show that, contrary to the case of surfactant added to colloidal suspensions, this effect in non-Brownian suspensions is attributable to the emergence of a finite onset stress for the formation of frictional contacts. Our data suggest that the magnitude of this onset stress is set by the strength of surfactant adsorption to the particle surfaces, which therefore constitutes a new design principle for using surfactants to tune the rheology of formulations consisting of suspensions of adhesive non-Brownian particulates.

cond-mat.soft↗

arXiv2019

Liquid migration in shear thickening suspensions flowing through constrictions

Dense particulate suspensions often become more dilute as they move downstream through a constriction. We find that as a shear-thickening suspension is extruded through a narrow die and undergoes such liquid migration, the extrudate maintains a steady concentration $ϕ_c$, independent of time or initial concentration. This concentration $ϕ_c$ varies with volumetric flow rate $Q$ and die radius $r_{\rm d}$, but at low $Q$ collapses onto a universal function of $Q/r_{\rm d}^3$, a characteristic shear rate in the die. We explain quantitatively the onset of liquid migration in extrusion by coupling a recent model for discontinuous shear thickening and the `suspension balance model' for solvent permeation through particles.

cond-mat.soft↗