arXiv subjects

Ryutaro Ohira

Publications and source records attributed to Ryutaro Ohira.

14 recordsLinked to original sources

arXiv2026

QuBE/Qubex: an integrated hardware-software system for superconducting qubit experiments with broadband control

Achieving high-fidelity operation in large-scale superconducting qubit systems requires not only control hardware with broad frequency coverage, low crosstalk, and tight synchronization but also software that coordinates system configuration, experiment execution, and data analysis. Here we present an integrated qubit-control system that combines broadband microwave hardware with a pulse-level software stack for scalable superconducting qubit experiments. The hardware provides broadband microwave coverage, including an instantaneous span of up to 1.6 GHz from a control output, while the software reduces setup and calibration overhead through automated configuration and built-in experiment workflows. We validate the system on a 64-qubit fixed-frequency transmon chip through full-chip frequency identification and representative demonstrations, including multi-unit far-detuned cross-resonance calibration and benchmarking that yields a measured two-qubit gate fidelity of 98.34%, and multilevel readout beyond the computational subspace. By disclosing the hardware architecture and releasing the software stack as open source, this work provides an inspectable hardware-software foundation for scalable superconducting qubit control experiments.

quant-ph↗

arXiv2026

Cryogenic Time-Division-Multiplexed Voltage Control for Scalable Trapped-Ion Quantum Processors

Trapped-ion quantum computers based on the quantum charge-coupled device architecture require on the order of ten trap electrodes per qubit, making the number of vacuum feedthroughs a bottleneck at the system scale. Time-division multiplexed (TDM)-based voltage control for trap electrodes provides a natural route to alleviate this constraint. However, previous studies have been limited to architectural proposals for static trap-potential compensation and room-temperature demonstrations of dynamic-electrode control, leaving cryogenic operation of TDM-based voltage control for static and dynamic electrodes experimentally unexplored. In this study, we develop and cryogenically validate TDM-based voltage control schemes for two distinct electrode classes. For static electrodes used in trap-potential compensation, we implement a 32-channel demultiplexed system operating at approximately 27~K, achieving an effective voltage update rate of 37.5~kHz with an output range of $\pm10~\mathrm{V}$ per channel. For dynamic electrodes used in ion operations, such as shuttling, we implement a four-channel demultiplexed system operating at approximately 14~K, achieving an effective voltage update rate of 1~MHz with a comparable output range. These results establish TDM-based voltage control as a practical approach for both electrode classes, providing a path for mitigating the vacuum feedthrough bottleneck in scalable trapped-ion quantum processors.

quant-ph↗

arXiv2026

Microwave Output Stabilization of a Qubit Controller via Device-Level Temperature Control

We present the design and performance of QuEL-1 SE, which is a multichannel qubit controller developed for superconducting qubits. The system incorporates the active thermal stabilization of critical analog integrated circuits, such as phase-locked loops, amplifiers, and mixers, to suppress the long-term amplitude and phase drift. To evaluate the amplitude and phase stability, we simultaneously monitor 15 microwave output channels over 24 h using a common analog-to-digital converter. Across the channels, the normalized amplitude exhibits standard deviations of 0.09\%--0.22\% (mean: 0.15\%), and the phase deviations are 0.35$^\circ$--0.44$^\circ$ (mean: 0.39$^\circ$). We further assess the impact of these deviations on quantum gate operations by estimating the average fidelity of an $X_{π/2}$ gate under the coherent errors corresponding to the deviations. The resulting gate infidelities are $2\times 10^{-6}$ for amplitude errors and $2\times 10^{-5}$ for phase errors, which are significantly lower than typical fault-tolerance thresholds such as those of the surface code. These results demonstrate that the amplitude and phase stability of QuEL-1 SE enables reliable long-duration quantum operations, thus highlighting its utility as a scalable control platform for superconducting and other qubit modalities.

quant-ph↗

arXiv2025

Trapping an Atomic Ion using Time-Division Multiplexed Digital-to-Analog Converters

Independent control of numerous electrodes in quantum charge-coupled device architectures presents a significant challenge for wiring and hardware scalability. To address this issue, we demonstrate a voltage control method based on time-division multiplexing (TDM). This approach utilizes a single high-update-rate digital-to-analog converter (DAC) to sequentially generate control signals for multiple electrodes, thereby reducing both the number of required DACs and associated wiring. We experimentally validate this concept by developing a 10-channel system that operates with only two DACs. The developed TDM-based voltage control system is applied to a surface-electrode trap, where we successfully trap a single $^{40}\mathrm{Ca}^+$ ion and demonstrate a simple ion transport primitive. This approach offers a resource-efficient and scalable solution for advanced quantum computing systems based on trapped ions.

quant-ph↗

arXiv2025

Selective Excitation of Superconducting Qubits with a Shared Control Line through Pulse Shaping

In conventional architectures of superconducting quantum computers, each qubit is connected to its own control line, leading to a commensurate increase in the number of microwave lines as the system scales. Frequency-multiplexed qubit control addresses this problem by enabling multiple qubits to share a single microwave line. However, it can cause unwanted excitation of non-target qubits, especially when the detuning between qubits is smaller than the pulse bandwidth. Here, we propose a selective-excitation-pulse (SEP) technique that suppresses unwanted excitations by shaping a drive pulse to create null points at non-target qubit frequencies. In a proof-of-concept experiment with three fixed-frequency transmon qubits, we demonstrate that the SEP technique achieves single-qubit gate fidelities comparable to those obtained with conventional Gaussian pulses while effectively suppressing unwanted excitations in non-target qubits. These results highlight the SEP technique as a promising tool for enhancing frequency-multiplexed qubit control.

quant-ph↗

arXiv2025

Multiplexed Control at Scale for Electrode Arrays in Trapped-Ion Quantum Processors

The scaling up of trapped-ion quantum processors based on the quantum charge-coupled device (QCCD) architecture is difficult owing to the extensive electronics and high-density wiring required to control numerous trap electrodes. In conventional QCCD architectures, each trap electrode is controlled via a dedicated digital-to-analog converter (DAC). The conventional approach places an overwhelming demand on electronic resources and wiring complexity. This is because the number of trap electrodes typically exceeds the number of trapped-ion qubits. This study proposes a method that leverages a high-speed DAC to generate time-division multiplexed signals to control a large-scale QCCD trapped-ion quantum processor. The proposed method replaces conventional DACs with a single high-speed DAC that generates the complete voltage waveforms required to control the trap electrodes, thereby significantly reducing the wiring complexity and overall resource requirements. Based on realistic parameters and commercially available electronics, our analysis demonstrates that a QCCD trapped-ion quantum computer with 10,000 trap electrodes can be controlled using only 13 field-programmable gate arrays and 104 high-speed DACs. This is in stark contrast to the 10,000 dedicated DACs required by conventional control methods. Consequently, employing this approach, we developed a proof-of-concept electronic system and evaluated its analog output performance.

quant-ph↗

arXiv2022

Error suppression by a virtual two-qubit gate

Sparse connectivity of a superconducting quantum computer results in the large experimental overheads of SWAP gates. In this study, we consider employing a virtual two-qubit gate (VTQG) as an error suppression technique. The VTQG enables a non-local operation between a pair of distant qubits using only single qubit gates and projective measurements. Here, we apply the VTQG to the digital quantum simulation of the transverse-field Ising model on an IBM quantum computer to suppress the errors due to the noisy two-qubit operations. We present an effective use of VTQG, where the reduction of multiple SWAP gates results in increasing the fidelity of the output states. The obtained results indicate that the VTQG can be useful for suppressing the errors due to the additional SWAP gates. Additionally, by combining a pulse-efficient transpilation method with the VTQG, further suppression of the errors is observed. In our experiments, we have observed one order of magnitude improvement in accuracy for the quantum simulation of the transverse-field Ising model with 8 qubits.

quant-ph↗

arXiv2022

A Gauss-Newton based Quantum Algorithm for Combinatorial Optimization

In this work, we present a Gauss-Newton based quantum algorithm (GNQA) for combinatorial optimization problems that, under optimal conditions, rapidly converges towards one of the optimal solutions without being trapped in local minima or plateaus. Quantum optimization algorithms have been explored for decades, but more recent investigations have been on variational quantum algorithms, which often suffer from the aforementioned problems. Our approach mitigates those by employing a tensor product state that accurately represents the optimal solution, and an appropriate function for the Hamiltonian, containing all the combinations of binary variables. Numerical experiments presented here demonstrate the effectiveness of our approach, and they show that GNQA outperforms other optimization methods in both convergence properties and accuracy for all problems considered here. Finally, we briefly discuss the potential impact of the approach to other problems, including those in quantum chemistry and higher order binary optimization.

quant-ph↗

arXiv2021

Coherent control of a local phonon in trapped ions using dynamical decoupling

In this paper, we present a dynamical decoupling (DD) technique to coherently control the dynamics of a single local phonon in trapped ions. A 2$π$ rotation at a motional sideband transition flips the sign of the relevant local phonon state, resulting in cancellation of the phonon dynamics. In this work, we implement DD using single and multiple blue-sideband pulses to control a single local phonon in two $^{40}{\rm Ca}^{+}$ ions in a linear Paul trap. Our proposed DD technique can be used to engineer coupling between local phonon modes.

quant-ph↗

arXiv2021

Evaluating states in trapped ions with local correlation between internal and motional degrees of freedom

We propose and demonstrate a scalable scheme for the simultaneous determination of internal and motional states in trapped ions with single-site resolution. The scheme is applied to the study of polaritonic excitations in the Jaynes- Cummings Hubbard model with trapped ions, in which the internal and motional states of the ions are strongly correlated. We observe quantum phase transitions of polaritonic excitations in two ions by directly evaluating their variances per ion site. Our work establishes an essential technological method for large-scale quantum simulations of polaritonic systems.

quant-ph↗

arXiv2021

Polariton blockade in the Jaynes-Cummings-Hubbard model with trapped ions

We have experimentally observed the dynamics of a single polariton and two polaritons in a two-ion chain. By driving two trapped ions at a motional blue-sideband transition, we realize the anti-Jaynes-Cummings-Hubbard model. When a single polariton exists in a trapped-ion chain, the polariton hops between the ion sites. On the other hand, when there are single polaritons at each ion site, the hopping of the polaritons is suppressed because of the polariton-polariton interaction induced by the nonlinearity of the anti-Jaynes-Cummings interaction, thereby realizing the blockade of polariton hopping in the anti-Jaynes-Cummings-Hubbard model with trapped ions. Our work is a step towards the development of a trapped-ion based quantum simulator for strongly interacting polaritonic systems.

quant-ph↗

arXiv2020

Blockade of phonon hopping in trapped ions in the presence of multiple local phonons

Driving an ion at a motional sideband transition induces the Jaynes--Cummings (JC) interaction. This JC interaction creates an anharmonic ladder of JC eigenstates, resulting in the suppression of phonon hopping due to energy conservation. Here, we realize phonon blockade in the presence of multiple local phonons in a trapped-ion chain. Our work establishes a key technological component for quantum simulation with multiple bosonic particles, which can simulate classically intractable problems.

quant-ph↗

arXiv2020

Breaking rotational symmetry in a trapped-ion quantum tunneling rotor

A trapped-ion quantum tunneling rotor (QTR) is in a quantum superposition of two different Wigner crystal orientations. In a QTR system, quantum tunneling drives the coherent transition between the two different Wigner crystal orientations. We theoretically study the quantum dynamics of a QTR, particularly when the spin state of one of the ions is flipped. We show that the quantum dynamics of an $\it{N}$-ion QTR can be described by continuous-time cyclic quantum walks. We also investigate the quantum dynamics of the QTR in a magnetic field. Flipping the spin state breaks the rotational symmetry of the QTR, making the quantum-tunneling-induced rotation distinguishable. This symmetry breaking creates coupling between the spin state of the ions and the rotational motion of the QTR, resulting in different quantum tunneling dynamics.

quant-ph↗

arXiv2019

Phonon-number-resolving Detection of Multiple Local Phonon Modes in Trapped Ions

We propose and demonstrate phonon-number-resolving detection of the multiple local phonon modes in a trapped-ion chain. To mitigate the effect of phonon hopping during the detection process, the probability amplitude of each local phonon mode is mapped to the auxiliary long-lived motional ground states. Sequential state-dependent fluorescence detection is then performed. In the experiment, we have successfully observed the time evolution of two local phonon modes in two ions, including the phonon-number correlation between the two modes.

quant-ph↗