SearcharxivSearch

arXiv subjects

S. Costa

Publications and source records attributed to S. Costa.

7 recordsLinked to original sources

Optimization of the JUNO liquid scintillator composition using a Daya Bay antineutrino detector

To maximize the light yield of the liquid scintillator (LS) for the Jiangmen Underground Neutrino Observatory (JUNO), a 20 t LS sample was produced in a pilot plant at Daya Bay. The optical properties of the new LS in various compositions were studied by replacing the gadolinium-loaded LS in one antineutrino detector. The concentrations of the fluor, PPO, and the wavelength shifter, bis-MSB, were increased in 12 steps from 0.5 g/L and <0.01 mg/L to 4 g/L and 13 mg/L, respectively. The numbers of total detected photoelectrons suggest that, with the optically purified solvent, the bis-MSB concentration does not need to be more than 4 mg/L. To bridge the one order of magnitude in the detector size difference between Daya Bay and JUNO, the Daya Bay data were used to tune the parameters of a newly developed optical model. Then, the model and tuned parameters were used in the JUNO simulation. This enabled to determine the optimal composition for the JUNO LS: purified solvent LAB with 2.5 g/L PPO, and 1 to 4 mg/L bis-MSB.

physics.ins-det

Embedded Readout Electronics R&D for the Large PMTs in the JUNO Experiment

Jiangmen Underground neutrino Observatory (JUNO) is a next generation liquid scintillator neutrino experiment under construction phase in South China. Thanks to the anti-neutrinos produced by the nearby nuclear power plants, JUNO will primarily study the neutrino mass hierarchy, one of the open key questions in neutrino physics. One key ingredient for the success of the measurement is to use high speed, high resolution sampling electronics located very close to the detector signal. Linearity in the response of the electronics in another important ingredient for the success of the experiment. During the initial design phase of the electronics, a custom design, with the Front-End and Read-Out electronics located very close to the detector analog signal has been developed and successfully tested. The present paper describes the electronics structure and the first tests performed on the prototypes. The electronics prototypes have been tested and they show good linearity response, with a maximum deviation of 1.3% over the full dynamic range (1-1000 p.e.), fulfilling the JUNO experiment requirements.

physics.ins-det

$^{222}$Rn contamination mechanisms on acrylic surfaces

In this work, the $^{222}$Rn contamination mechanisms on acrylic surfaces have been investigated. $^{222}$Rn can represent a significant background source for low-background experiments, and acrylic is a suitable material for detector design thanks to its purity and transparency. Four acrylic samples have been exposed to a $^{222}$Rn rich environment for different time periods, being contaminated by $^{222}$Rn and its progenies. Subsequently, the time evolution of radiocontaminants activity on the samples has been evaluated with $α$ and $γ$ measurements, highlighting the role of different decay modes in the contamination process. A detailed analysis of the alpha spectra allowed to quantify the implantation depth of the contaminants. Moreover, a study of both $α$ and $γ$ measurements pointed out the $^{222}$Rn diffusion inside the samples.

physics.ins-det

Collins and Sivers asymmetries for pions and kaons in muon-deuteron DIS

The measurements of the Collins and Sivers asymmetries of identified hadrons produced in deep-inelastic scattering of 160 GeV/c muons on a transversely polarised 6LiD target at COMPASS are presented. The results for charged pions and charged and neutral kaons correspond to all data available, which were collected from 2002 to 2004. For all final state particles both the Collins and Sivers asymmetries turn out to be small, compatible with zero within the statistical errors, in line with the previously published results for not identified charged hadrons, and with the expected cancellation between the u- and d-quark contributions.

hep-ex

Lambda Hyperons in 2 A*GeV Ni + Cu Collisions

A sample of Lambda's produced in 2 A*GeV Ni + Cu collisions has been obtained with the EOS Time Projection Chamber at the Bevalac. Low background in the invariant mass distribution allows for the unambiguous demonstration of Lambda directed flow. The transverse mass spectrum at mid-rapidity has the characteristic shoulder-arm shape of particles undergoing radial transverse expansion. A linear dependence of Lambda multiplicity on impact parameter is observed, from which a total Lambda + Sigma^0 production cross section of $112 +/- 24 mb is deduced. Detailed comparisons with the ARC and RVUU models are made.

nucl-ex

The Evolution of Nuclear Multifragmentation in the Temperature-Density Plane

The mean transverse kinetic energies of the fragments formed in the interaction of 1 A GeV Au+C have been determined. An energy balance argument indicates the presence of a collective energy which increases in magnitude with increasing multiplicity and accounts for nearly half of the measured mean transverse kinetic energy. The radial flow velocity associated with the collective energy yields estimates for the time required to expand to the freeze-out volume. Isentropic trajectories in the temperature-density plane are shown for the expansion and indicate that the system goes through the critical region at the same multiplicities as deduced from a statistical analysis. Here, the expansion time is approximately 70 fm/c.

nucl-ex

Radial Flow in Au+Au Collisions at E=0.25-1.15 A GeV

A systematic study of energy spectra for light particles emitted at midrapidity from Au+Au collisions at E=0.25-1.15 A GeV reveals a significant non-thermal component consistent with a collective radial flow. This component is evaluated as a function of bombarding energy and event centrality. Comparisons to Quantum Molecular Dynamics (QMD) and Boltzmann-Uehling-Uhlenbeck (BUU) models are made for different equations of state.

nucl-ex