arXiv subjects

S. Dambach

Publications and source records attributed to S. Dambach.

5 recordsLinked to original sources

arXiv2020

Generating two continuous entangled microwave beams using a dc-biased Josephson junction

We show experimentally that a dc-biased Josephson junction in series with two microwave resonators emits entangled beams of microwaves leaking out of the resonators. In the absence of a stationary phase reference for characterizing the entanglement of the outgoing beams, we measure second-order coherence functions for proving entanglement up to an emission rate of 2.5 billion photon pairs per second. The experimental results are found in quantitative agreement with theory, proving that the low frequency noise of the dc bias is the main limitation for the coherence time of the entangled beams. This agreement allows us to evaluate the entropy of entanglement of the resonators, and to identify the improvements that could bring this device closer to a useful bright source of entangled microwaves for quantum-technological applications.

cond-mat.mes-hall↗

arXiv2019

Antibunched photons emitted by a dc biased Josephson junction

We show experimentally that a dc biased Josephson junction in series with a high-enough impedance microwave resonator emits antibunched photons. Our resonator is made of a simple micro-fabricated spiral coil that resonates at 4.4 GHz and reaches a 1.97 k$Ω$ characteristic impedance. The second order correlation function of the power leaking out of the resonator drops down to 0.3 at zero delay, which demonstrates the antibunching of the photons emitted by the circuit at a rate of 6 $10^7$ photons per second. Results are found in quantitative agreement with our theoretical predictions. This simple scheme could offer an efficient and bright single-photon source in the microwave domain.

cond-mat.mes-hall↗

arXiv2009

Signal height in silicon pixel detectors irradiated with pions and protons

Pixel detectors are used in the innermost part of multi purpose experiments at the Large Hadron Collider (LHC) and are therefore exposed to the highest fluences of ionising radiation, which in this part of the detectors consists mainly of charged pions. The radiation hardness of the detectors has thoroughly been tested up to the fluences expected at the LHC. In case of an LHC upgrade the fluence will be much higher and it is not yet clear up to which radii the present pixel technology can be used. In order to establish such a limit, pixel sensors of the size of one CMS pixel readout chip (PSI46V2.1) have been bump bonded and irradiated with positive pions up to 6E14 Neq/cm^2 at PSI and with protons up to 5E15 Neq/cm^2. The sensors were taken from production wafers of the CMS barrel pixel detector. They use n-type DOFZ material with a resistance of about 3.7kOhm cm and an n-side read out. As the performance of silicon sensors is limited by trapping, the response to a Sr-90 source was investigated. The highly energetic beta-particles represent a good approximation to minimum ionising particles. The bias dependence of the signal for a wide range of fluences will be presented.

physics.ins-det↗

arXiv2006

Neutrino reconstruction with topological information

In general a decay with a missing (not detected) particle can not be fully reconstructed apart from a few exceptions. For example, if the momentum of the decaying particle is known or if the missing energy in an event is measured precisely, then the missing particle 4-momentum can be determined. Here a new method is proposed that utilizes additional information about the topology of a decay: The direction from the primary to the secondary vertex combined with momentum conservation allows the determination of the missing particle momentum up to a twofold ambiguity. The semileptonic decay of the Bs mesons is considered as an example to illustrate this method and to compare its performance against conventional approaches.

hep-ph↗

arXiv1998

First experiments with a 100 period superconductive undulator with a period length of 3.8 mm

A prototype of a novel superconductive undulator with a period length of 3.8 mm is described. The undulator is 100 periods long. In the first tests described in this paper the undulator was cooled in a helium bath and it was shown that it can be operated as expected with a maximum current of 1400 A. Afterwards the undulator field was measured with a miniature Hall probe with an active area of (100x100)x10^-6 m^2. Calculated and measured field distributions are in good agreement. A cryostat for a beam test at Mainz microtron MAMI was built in which liquid helium cools indirectly the in-vacuum undulator. At the moment the cryostat is tested and optimized.

physics.acc-ph↗