arXiv subjects
Publications and source records attributed to S. G. Mashnik.
Nuclear fragments emitted at 3.5 degrees in 12C fragmentation at 0.6 GeV/nucleon have been measured. The spectra obtained are used for testing the predictions of four ion-ion interaction models: INCL++, BC, LAQGSM03.03 and QMD as well as for the comparison with the analytical parametrization in the framework of thermodynamical picture of fragmentation.
Results of t production in Al foil monitors are presented. These foils have been irradiated by protons of different energies in a range of 0.04 - 2.6 GeV. The irradiations were carried out at the ITEP accelerator U-10 under the ISTC Project 3266 during 2006 - 2009. t has been extracted from Al foils using an A307 Sample Oxidizer. The values of the Al(p,x)t cross sections obtained in these experiments are compared with data measured at other laboratories and with results of simulations by the MCNP6 radiation transport code using the CEM03.03 event generator.
Due to potential level of energy intensity 178m2Hf is an extremely interesting isomer. One possible way to produce this isomer is irradiation of nat-Ta or nat-W samples with high energy protons. Irradiation of nat-Ta and nat-W samples performed for other purposes provides an opportunity to study the corresponding reactions. This paper pre-sents the 178m2Hf independent production cross sections for both targets measured by the gamma-ray spectrometry method. The reaction excitation functions have been obtained for the proton energies from 40 up to 2600 MeV. The experimental results were compared with calculations by various versions of the intranuclear cascade model in the well-known codes: ISABEL, Bertini, INCL4.5+ABLA07, PHITS, CASCADE07 and CEM03.02. The isomer ratio for the nat-Ta(p,x)178m2Hf reaction is evaluated on the basis of the available data.
Momentum spectra of hydrogen isotopes have been measured at 3.5 deg from C12 fragmentation on a Be target. Momentum spectra cover both the region of fragmentation maximum and the cumulative region. Differential cross sections span five orders of magnitude. The data are compared to predictions of four Monte Carlo codes: QMD, LAQGSM, BC, and INCL++. There are large differences between the data and predictions of some models in the high momentum region. The INCL++ code gives the best and almost perfect description of the data.
Nuclear data for neutron-induced reactions in the intermediate energy range of 20 to 200 MeV are of great importance for the development of nuclear reaction codes since little data exist in that range. Also several different applications benefit from such data, notably accelerator-driven incineration of nuclear waste. The Medley setup was used for a series of measurements of p, d, t, $^3$He and $α$-particle production by 175 MeV quasi-mono-energetic neutrons on various target nuclei. The measurements were performed at the The Svedberg Laboratory in Uppsala, Sweden. Eight detector telescopes placed at angles between 20$^\circ$ and 160$^\circ$ were used. Medley uses the $ΔE$-$ΔE$-$E$ technique to discriminate among the particle types and is able to measure double-differential cross sections over a wide range of particle energies. This paper briefly describes the experimental setup, summarizes the data analysis and reports on recent changes in the previously reported preliminary data set on bismuth. Experimental data are compared with INCL4.5-Abla07, MCNP6 using CEM03.03, TALYS and PHITS model calculations as well as with nuclear data evaluations. The models agree fairly well overall but in some cases systematic differences are found.
178m2-Hf is an extremely interesting isomeric state due to its potential energy capacity level. One possible way to obtain it is by irradiation of a nat-Ta sample with a high-current proton accelerator. Up to now, there was no information in the international experimental nuclear data base (EXFOR) for this reaction. Irradiations of nat-Ta samples performed for other purposes provide an opportunity to address this question. This paper presents the 172m2-Hf independent production cross-sections determined by gamma-ray spectrometry. The nat-Ta(p,x)172m2-Hf excitation function is studied in the 20-3500 MeV energy range. Comparisons with results by several nuclear models (ISABEL, Bertini, INCL4.5+ABLA07, PHITS, CASCADE07, and CEM03.02) used as event-generators in modern transport codes are also reported. However, since such models are generally not able to separately predict ground and isomeric states of reaction products, only 178-Hf independent and cumulative cross-section data are compared.
A calorimetric-time-of-flight (CTOF) technique was used for real-time, high-precision measurement of the neutron spectrum at an angle of 175 deg from the initial proton beam direction, which hits a face plane of a cylindrical copper target of 20 cm in diameter and 25 cm thick. A comparison was performed between the neutron spectra predicted by the MARS, RTS&T, GEANT4, and the MCNP6 codes and that measured for 800, 1000, and 1200 MeV protons. The transport codes tested here describe with different success the measured spectra, depending on the energy of the detected neutrons and on the incident proton energy, but all the models agree reasonably well with our data.
For the past several years, a major effort has been undertaken at Los Alamos National Laboratory (LANL) to develop the transport code MCNP6, the latest LANL Monte-Carlo transport code representing a merger and improvement of MCNP5 and MCNPX. We emphasize a description of the latest developments of MCNP6 at higher energies to improve its reliability in calculating rare-isotope production, high-energy cumulative particle production, and a gamut of reactions important for space-radiation shielding, cosmic-ray propagation, and accelerator applications. We present several examples of validation and verification of MCNP6 compared to a wide variety of intermediate- and high-energy experimental data on reactions induced by photons, mesons, nucleons, and nuclei at energies from tens of MeV to about 1 TeV/nucleon, and compare to results from other modern simulation tools.
A single terbium foil was irradiated with 800 MeV protons to ascertain the potential for production of lanthanide isotopes of interest in medical, astrophysical, and basic science research and to contribute to nuclear data repositories. Isotopes produced in the foil were quantified by gamma spectroscopy. Cross sections for 36 isotopes produced in the irradiation are reported and compared with predictions by the MCNP6 transport code using the CEM03.03, Bertini, and INCL+ABLA event generators. Our results indicate the need to accurately consider fission and fragmentation of relatively light target nuclei like terbium in the modeling of nuclear reactions at 800 MeV. The predictive power of the code was found to be different for each event generator tested but was satisfactory for most of the product yields in the mass region where spallation reactions dominate. However, none of the event generators' results are in complete agreement with measured data.
Cross sections for 223,225Ra, 225Ac and 227Th production by the proton bombardment of natural thorium targets were measured at proton energies below 200 MeV. Our measurements are in good agreement with previously published data and offer a complete excitation function for 223,225Ra in the energy range above 90 MeV. Comparison of theoretical predictions with the experimental data shows reasonable-to-good agreement. Results indicate that accelerator-based production of 225Ac and 223Ra below 200 MeV is a viable production method.
Cross sections for the formation of 225,227-Ac, 223,225-Ra, and 227-Th via the proton bombardment of natural thorium targets were measured at a nominal proton energy of 800 MeV. No earlier experimental cross section data for the production of 223,225-Ra, 227-Ac and 227-Th by this method were found in the literature. A comparison of theoretical predictions with the experimental data shows agreement within a factor of two. Results indicate that accelerator-based production of 225-Ac and 223-Ra is a viable production method.
Nuclide production cross sections measured at ITEP for the targets of nat-Cr, 56-Fe, nat-Ni, 93-Nb, 181-Ta, nat-W, nat-Pb, 209-Bi irradiated by protons with energies from 40 to 2600 MeV were used to estimate the predictive accuracy of several popular high-energy transport codes. A general agreement of the ITEP data with the data obtained by other groups, including the numerous GSI data measured by the inverse kinematics method was found. Simulations of the measured data were performed with the MCNPX (Bertini and ISABEL options), CEM03.02, INCL4.2+ABLA, INCL4.5+ABLA07, PHITS, and CASCADE.07 codes. Deviation factors between the calculated and experimental cross sections have been estimated for each target and for the whole energy range covered by our measurements. Two-dimensional diagrams of deviation factor values were produced for estimating the predictive power of every code for intermediate, not measured masses of nuclei-targets and bombarding energies of protons. Further improvements of all tested here codes are recommended. In addition, new measurements at ITEP of nuclide yields from a 208-Pb target irradiated by 500 MeV protons are presented. A good agreement between these new data and the GSI measurements obtained by the inverse kinematics method was found
We measured the production of \nuc{57}{Co}, \nuc{54}{Mn}, \nuc{68}{Ge}, \nuc{65}{Zn}, and \nuc{60}{Co} in a sample of Ge enriched in isotope 76 due to high-energy neutron interactions. These isotopes, especially \nuc{68}{Ge}, are critical in understanding background in Ge detectors used for double-beta decay experiments. They are produced by cosmogenic-neutron interactions in the detectors while they reside on the Earth's surface. These production rates were measured at neutron energies of a few hundred MeV. We compared the measured production to that predicted by cross-section calculations based on CEM03.02. The cross section calculations over-predict our measurements by approximately a factor of three depending on isotope. We then use the measured cosmic-ray neutron flux, our measurements, and the CEM03.02 cross sections to predict the cosmogenic production rate of these isotopes. The uncertainty in extrapolating the cross section model to higher energies dominates the total uncertainty in the cosmogenic production rate.
A calorimetric-time-of-flight (CTOF) technique was used for real-time, high-precision measurement of neutron spectrum at the angle of 175 degrees from the initial proton beam direction, which hits a face plane of a cylindrical iron target of 20 cm in diameter and 25 cm thick. A comparison was performed between the neutron spectra predicted by the MARS and the MCNPX code systems and measured by experiments for 0.4-, 0.6-, 0.8-, 1.0-, and 1.2-GeV protons.
The recoil properties of the product nuclei from the interaction of 2.2 GeV/nucleon 12-C ions from Nuclotron of the Laboratory of High Energies (LHE), Joint Institute for Nuclear Research (JINR) at Dubna with a 118-Sn target have been studied using catcher foils. The experimental data were analyzed using the mathematical formalism of the standard two-step vector model. The results for 12-C ions are compared with those for deuterons and protons. Three different Los Alamos versions of the Quark-Gluon String Model (LAQGSM) were used for comparison with our experimental data.
A description of the IntraNuclear Cascade (INC), preequilibrium, evaporation, fission, coalescence, and Fermi breakup models used by the latest versions of our CEM03.03 and LAQGSM03.03 event generators is presented, with a focus on our most recent developments of these models. The recently developed "S" and "G" versions of our codes, that consider multifragmentation of nuclei formed after the preequilibrium stage of reactions when their excitation energy is above 2A MeV using the Statistical Multifragmentation Model (SMM) code by Botvina et al. ("S" stands for SMM) and the fission-like binary-decay model GEMINI by Charity ("G" stands for GEMINI), respectively, are briefly described as well. Examples of benchmarking our models against a large variety of experimental data on particle-particle, particle-nucleus, and nucleus-nucleus reactions are presented. Open questions on reaction mechanisms and future necessary work are outlined.
Cross-sections for radioactive nuclide production in 56Fe(p,x) reactions at 300, 500, 750, 1000, 1500, and 2600 MeV were measured using the ITEP U-10 proton accelerator. In total, 221 independent and cumulative yields of products of half-lives from 6.6 min to 312 days have been obtained via the direct-spectrometry method. The measured data have been compared with the experimental data obtained elsewhere by the direct and inverse kinematics methods and with calculations by 15 codes, namely: MCNPX (INCL, CEM2k, BERTINI, ISABEL), LAHET (BERTINI, ISABEL), CEM03 (.01, .G1, .S1), LAQGSM03 (.01, .G1, >.S1), CASCADE-2004, LAHETO, and BRIEFF. Most of our data are in a good agreement with the inverse kinematics results and disprove the results of some earlier activation measurements that were quite different from the inverse kinematics measurements. The most significant calculation-to-experiment differences are observed in the yields of the A<30 light nuclei, indicating that further improvements in nuclear reaction models are needed, and pointing out as well to a necessity of more complete measurements of such reactions.
This paper presents part of an internal LANL Progress Report on LAQGSM03.03, an upgrade of the Los Alamos version of the Quark-Gluon String Model event generator for MCNPX/6 and MARS15 transport codes and on its validation and testing against a large variety of recent measurements. We present here an analysis with LAQGSM03.03 of the recent PHENIX mid-rapidity spectra of pi+, pi-, K+, K-, p, and p-bar produced in ultra-relativistic p + p interactions at sqrt(s) = 200 GeV; GSI cross sections for the fragmentation of Pb208 at 1 GeV/nucleon on Be9; fragmentation cross sections of Si28 on H, C, Al, Cu, Sn, and Pb at energies from 290 to 1200 MeV/nucleon measred recently at HIMAC and BNL; recent HIMAC data on B, Be, Li, and He production cross sections from fragmentation of C12 on H, C, Al, Cu, Sn, and Pb at 290 and 400 MeV/nucleon; BNL data on fragmentation cross sections of Fe56 on H, C, Al, Cu, and Pb targets at 1.05 GeV/nucleon; recent pi+ and pi- spectra from 6.4, 12.3, and 17.5 GeV/c p + Be9 from the E910 BNL measurements; and fragmentation cross sections of Ca40, Ca48, Ni58, and Ni64 on Be9 and Ta181 at 140 MeV/nucleon, and of Kr86 at 64 MeV/nucleon on the same targets measured recently at NSCL-MSU and RARF-RIKEN, respectively.