arXiv subjects

S. Gorno

Publications and source records attributed to S. Gorno.

8 recordsLinked to original sources

arXiv2024

Investigating the influence of divertor baffles on nitrogen-seeded detachment in TCV with SOLPS-ITER simulations and TCV experiments

Plasma edge simulations with the SOLPS-ITER code are performed to study the influence of divertor baffles on nitrogen-seeded detachment in TCV single-null, L-mode discharges. Scans of nitrogen seeding rate are conducted in both baffled and unbaffled TCV divertors, where the nitrogen seeding with baffles is found to yield lower target temperatures and heat fluxes than with baffles-only and with seeding-only. The cumulative effects of baffles and seeding on target parameters are explained by the two-point model. The divertor neutral density and neutral compression increase with baffles, due to lower divertor to main chamber neutral conductance, as explained by a schematic neutral transport model with baffles. The nitrogen retention, defined as the ratio of average nitrogen nuclei density in divertor and main chamber, increases with the seeding rate if baffled, and remains constant if unbaffled. At the same outboard mid-plane separatrix plasma density, the nitrogen retention with baffles is lower than the unbaffled retention at low seeding levels and is higher at high seeding levels, which is explained by the changes of nitrogen ion and neutral transport with baffles and seeding. The baffled carbon retention is higher than the unbaffled retention due to lower divertor to main chamber carbon neutral conductance. Baffles increase the divertor radiation. The predicted trends of target parameters, the distribution of neutrals and radiations are well supported by TCV experiments, though discrepancies in the absolute values remain. The simulations yield an overall colder and denser divertor, consistent with previous SOLPS-ITER simulations of Ohmically heated L-modes in TCV. The successful comparison of simulation and experiment, together with the understanding gained from the neutral transport model, increases the confidence in the SOLPS simulations for the next TCV divertor upgrade.

physics.plasm-ph↗

arXiv2024

Parallel flows as a key component to interpret Super-X divertor experiments

The Super-X Divertor (SXD) is an alternative divertor configuration leveraging total flux expansion at the Outer Strike Point (OSP). While the extended 2-Point Model (2PM) predicts facilitated detachment access and control in the SXD configuration, these attractive features are not always retrieved experimentally. These discrepancies are at least partially explained by the effect of parallel flows which, when self-consistently included in the 2PM, reveal the role of total flux expansion on the pressure balance and weaken the total flux expansion effect on detachment access and control, compared to the original predictions. This new model can partially explain the discrepancies between the 2PM and experiments performed on tokamak à configuration variable (TCV), in ohmic L-mode scenarios, which are particularly apparent when scanning the OSP major radius Rt. In core density ramps in lower Single-Null (SN) configuration, the impact of Rt on the CIII emission front movement in the divertor outer leg - used as a proxy for the plasma temperature in the divertor - is substantially weaker than 2PM predictions. Furthermore, in OSP radial sweeps in lower and upper SN configurations, in ohmic L-mode scenarios with a constant core density, the peak parallel particle flux density at the OSP is almost independent of Rt, while the 2PM predicts a linear dependence. Finally, analytical and numerical modeling of parallel flows in the divertor is presented. It is shown that an increase in total flux expansion can favour supersonic flows at the OSP. Parallel flows are also shown to be relevant by analysing SOLPS-ITER simulations of TCV.

physics.plasm-ph↗

arXiv2024

SPLEND1D, a reduced one-dimensional model to investigate the physics of plasma detachment

Studying the process of divertor detachment and the associated complex interplay of plasma dynamics and atomic physics processes is of utmost importance for future fusion reactors. Whilst simplified analytical models exist to interpret the general features of detachment, they are limited in their predictive power, and complex 2D or even 3D codes are generally required to provide a self-consistent picture of the divertor. As an intermediate step, 1D models of the Scrape-Off Layer (SOL) can be particularly insightful as the dynamics are greatly simplified, while still self-consistently including various source and sink terms at play, as well as additional important effects such as flows. These codes can be used to shed light on the physics at play, to perform fast parameter scans, or to interpret experiments. In this paper, we introduce the SPLEND1D (Simulator of PLasma ENabling Detachment in 1D) code: a fast and versatile 1D SOL model. We present in detail the model that is implemented in SPLEND1D. We then employ the code to explore various elements of detachment physics for parameters typical of the Tokamak à Configuration Variable (TCV), including the atomic physics and other processes behind power and momentum losses, and explore the various hypotheses and free parameters of the model.

physics.plasm-ph↗

arXiv2024

Comparison of detachment in Ohmic plasmas with positive and negative triangularity

In recent years, negative triangularity (NT) has emerged as a potential high-confinement L-mode reactor solution. In this work, detachment is investigated using core density ramps in lower single null Ohmic L-mode plasmas across a wide range of upper, lower, and average triangularity (the mean of upper and lower triangularity: $δ$) in the TCV tokamak. It is universally found that detachment is more difficult to access for NT shaping. The outer divertor leg of discharges with $δ\approx -0.3$ could not be cooled to below $5~\mathrm{eV}$ through core density ramps alone. The behavior of the upstream plasma and geometrical divertor effects (e.g. a reduced connection length with negative lower triangularity) do not fully explain the challenges in detaching NT plasmas. Langmuir probe measurements of the target heat flux widths ($λ_q$) were constant to within 30% across an upper triangularity scan, while the spreading factor $S$ was lower by up to 50% for NT, indicating a generally lower integral Scrape-Off Layer width, $λ_{int}$. The line-averaged core density was typically higher for NT discharges for a given fuelling rate, possibly linked to higher particle confinement in NT. Conversely, the divertor neutral pressure and integrated particle fluxes to the targets were typically lower for the same line-averaged density, indicating that NT configurations may be closer to the sheath-limited regime than their PT counterparts, which may explain why NT is more challenging to detach.

physics.plasm-ph↗

arXiv2024

Modelling of power exhaust in TCV positive and negative triangularity L-mode plasmas

L-mode negative triangularity (NT) operation is a promising alternative to the positive triangularity (PT) H-mode as a high-confinement ELM-free operational regime. In this work, two TCV L-mode lower single null Ohmic discharges with opposite triangularity $δ\simeq \pm 0.3$ are investigated using SOLPS-ITER modelling. The main focus is the exploration of the reasons behind the experimentally observed feature of NT plasmas being more difficult to detach than similar PT experiments. SOLPS-ITER simulations are performed assuming the same anomalous diffusivity for particles $D_n^{AN}$ and energy $κ_{e/i}^{AN}$ in PT and NT. Nonetheless, the results clearly show dissimilar transport and accumulation of neutral particles in the scrape-off layer (SOL) of the two configurations, which consequently gives rise to different ionization sources for the plasma and produces different poloidal and cross-field fluxes. Simulations also recover the experimental feature of the outer target being hotter in the NT scenario (with $T_{e, NT} \gtrsim 5 \, \mathrm{eV}$) than in the PT counterpart.

physics.plasm-ph↗

arXiv2022

Improved Heat and Particle Flux Mitigation in High Core Confinement, Baffled, Alternate Divertor Configurations in the TCV tokamak

Nitrogen seeded detachment has been achieved in the Tokamak a Configuration Variable (TCV) in advanced divertor configurations (ADCs), namely X-divertor and X-point target, with and without baffles in H-mode plasmas with high core confinement. Both ADCs show a remarkable reduction in the inter-ELM particle and heat fluxes to the target compared to the standard divertor configuration. 95-98% of the peak heat flux to the target is mitigated as a synergetic effect of ADCs, baffling, and nitrogen seeded detachment. The effect of divertor geometry and baffles on core-divertor compatibility is investigated in detail. The power balance in these experiments is also investigated to explore the physics behind the observed reduction in heat fluxes in the ADCs.

physics.plasm-ph↗

arXiv2022

New insights on divertor parallel flows, ExB drifts, and fluctuations from in situ, two-dimensional probe measurement in the Tokamak à Configuration Variable

In-situ, two-dimensional (2D) Langmuir probe measurements across a large part of the TCV divertor are reported in L-mode discharges with and without divertor baffles. This provides detailed insights into time averaged profiles, particle fluxes, and fluctuations behavior in different divertor regimes. The presence of the baffles is shown to substantially increase the divertor neutral pressure for a given upstream density and to facilitate the access to detachment, an effect that increases with plasma current. The detailed, 2D probe measurements allow for a divertor particle balance, including ion flux contributions from parallel flows and ExB drifts. The poloidal flux contribution from the latter is often comparable or even larger than the former, such that the divertor parallel flow direction reverses in some conditions, pointing away from the target. In most conditions, the integrated particle flux at the outer target can be predominantly ascribed to ionization along the outer divertor leg, consistent with a closed-box approximation of the divertor. The exception is a strongly detached divertor, achieved here only with baffles, where the total poloidal ion flux even decreases towards the outer target, indicative of significant plasma recombination. The most striking observation from relative density fluctuation measurements along the outer divertor leg is the transition from poloidally uniform fluctuation levels in attached conditions to fluctuations strongly peaking near the X-point when approaching detachment.

physics.plasm-ph↗

arXiv2021

Validation of edge turbulence codes against the TCV-X21 diverted L-mode reference case

Self-consistent full-size turbulent-transport simulations of the divertor and SOL of existing tokamaks have recently become feasible. This enables the direct comparison of turbulence simulations against experimental measurements. In this work, we perform a series of diverted Ohmic L-mode discharges on the TCV tokamak, building a first-of-a-kind dataset for the validation of edge turbulence models. This dataset, referred to as TCV-X21, contains measurements from 5 diagnostic systems -- giving a total of 45 1- and 2-D comparison observables in two toroidal magnetic field directions. The dataset is used to validate three flux-driven 3D fluid-turbulence models: GBS, GRILLIX and TOKAM3X. With each model, we perform simulations of the TCV-X21 scenario, tuning the particle and power source rates to achieve a reasonable match of the upstream separatrix value of density and electron temperature. We find that the simulations match the experimental profiles for most observables at the OMP -- both in terms of profile shape and absolute magnitude -- while a poorer agreement is found towards the divertor targets. The match between simulation and experiment is seen to be sensitive to the value of the resistivity, the heat conductivities, the power injection rate and the choice of sheath boundary conditions. Additionally, despite targeting a sheath-limited regime, the discrepancy between simulations and experiment also suggests that the neutral dynamics should be included. The results of this validation show that turbulence models are able to perform simulations of existing devices and achieve reasonable agreement with experimental measurements. Where disagreement is found, the validation helps to identify how the models can be improved. By publicly releasing the experimental dataset, this work should help to guide and accelerate the development of predictive turbulence simulations of the edge and SOL.

physics.plasm-ph↗