arXiv subjects

S. Heun

Publications and source records attributed to S. Heun.

13 recordsLinked to original sources

arXiv2022

Propagation of Visible Light in Nanostructured Niobium Stripes Embedded in a Dielectric Polymer

Nanometric metallic stripes allow the transmission of optical signals via the excitation and propagation of surface-localized evanescent electromagnetic waves, with important applications in the field of nano-photonics. Whereas this kind of plasmonic phenomena typically exploits noble metals, like Ag or Au, other materials can exhibit viable light-transport efficiency. In this work, we demonstrate the transport of visible light in nanometric niobium stripes coupled with a dielectric polymeric layer, exploiting the remotely-excited/detected Raman signal of black phosphorus (bP) as the probe. The light-transport mechanism is ascribed to the generation of surface plasmon polaritons at the Nb/polymer interface. The propagation length is limited due to the lossy nature of niobium in the optical range, but this material may allow the exploitation of specific functionalities that are absent in noble-metal counterparts.

physics.optics↗

arXiv2022

Theory of scanning gate microscopy imaging of the supercurrent distribution in a planar Josephson junction

We theoretically investigate the mapping of the supercurrent distribution in a planar superconductor-normal-superconductor junction in the presence of a perpendicular magnetic field via the scanning gate microscopy technique. We find that the distribution of counter-propagating supercurrents aligned in Josephson vortices can be mapped by the change of the critical current induced by the tip of the scanning probe, if the flux in the junction is set close to maxima of the Fraunhofer pattern. Instead, when the magnetic field drives the junction to a supercurrent minimum in the Fraunhofer pattern, the superconducting phase adapts, and the tip always increases the supercurrent. The perpendicular magnetic field leads to the formation of Josephson vortices, whose extension for highly transparent junctions depends on the current circulation direction. We show that this leads to an asymmetric supercurrent distribution in the junction and that this can be revealed by scanning gate microscopy. We explain our findings on the basis of numerical calculations for both short- and long-junction limits and provide a phenomenological model for the observed phenomena.

cond-mat.mes-hall↗

arXiv2022

Metamorphic InAs/InGaAs QWs with electron mobilities exceeding $7\times10^5cm^2/Vs$

We present a study on the influence of strain-relieving InAlAs buffer layers on metamorphic InAs/InGaAs quantum wells grown by molecular beam epitaxy on GaAs. Residual strain in the buffer layer, the InGaAs barrier and the InAs wells were assessed by X-ray diffraction and high-resolution transmission electron microscopy. By carefully choosing the composition profile and thicknesses of the buffer layer, virtually unstrained InGaAs barriers embedding an InAs quantum well with thickness up to 7nm can be grown. This allows reaching low-temperature electron mobilities much higher than previously reported for samples obtained by metamorphic growth on GaAs, and comparable to the values achieved for samples grown on InP substrates.

cond-mat.mtrl-sci↗

arXiv2019

An atomically flat single-crystalline gold film thermometer on mica to study energy (heat) exchange at the nano-scale

There is a great interest in the scientific community to perform calorimetry on samples having mass in the nanogram range. A detailed knowledge of the energy (heat) exchange in the fast growing family of micro- and nano-systems could provide valuable information about the chemistry and physics at the nano-scale. The possibility to have an atomically flat thermal probe represents an added value, because it provides the unique opportunity to perform Scanning Probe Microscopy (SPM) together with calorimetry. Here we report the fabrication, characterization, and calibration of atomically flat, single-crystalline gold film thermometers on mica substrate. Gold re-crystallization has been obtained, and successively the thermometer surface has been studied by Low Energy Electron Diffraction (LEED) and Scanning Tunneling Microscopy (STM). The thermometer calibration demonstrates a heat exchange coefficient of 2.1 x 10^(-7) W/K and a performance about 10 times better than previous sensors based on Si substrates. The experimental setup allows the simultaneous investigation of heat exchange and surface physics on the same sample.

physics.app-ph↗

arXiv2018

STM Study of Exfoliated Few Layer Black Phosphorus Annealed in Ultrahigh Vacuum

Black Phosphorus (bP) has emerged as an interesting addition to the category of two-dimensional materials. Surface-science studies on this material are of great interest, but they are hampered by bP's high reactivity to oxygen and water, a major challenge to scanning tunneling microscopy (STM) experiments. As a consequence, the large majority of these studies were performed by cleaving a bulk crystal in situ. Here we present a study of surface modifications on exfoliated bP flakes upon consecutive annealing steps, up to 550 C, well above the sublimation temperature of bP. In particular, our attention is focused on the temperature range 375 C - 400 C, when sublimation starts, and a controlled desorption from the surface occurs alongside with the formation of characteristic well-aligned craters. There is an open debate in the literature about the crystallographic orientation of these craters, whether they align along the zigzag or the armchair direction. Thanks to the atomic resolution provided by STM, we are able to identify the orientation of the craters with respect to the bP crystal: the long axis of the craters is aligned along the zigzag direction of bP. This allows us to solve the controversy, and, moreover, to provide insight in the underlying desorption mechanism leading to crater formation.

cond-mat.mes-hall↗

arXiv2018

Phosphorus oxide gate dielectric for black phosphorus field effect transistors

The environmental stability of the layered semiconductor black phosphorus (bP) remains a challenge. Passivation of the bP surface with phosphorus oxide, POx, grown by a reactive ion etch with oxygen plasma is known to improve photoluminescence efficiency of exfoliated bP flakes. We apply phosphorus oxide passivation in the fabrication of bP field effect transistors using a gate stack consisting of a POx layer grown by reactive ion etching followed by atomic layer deposition of Al2O3. We observe room temperature top-gate mobilities of 115 cm2/Vs in ambient conditions, which we attribute to the low defect density of the bP/POx interface.

cond-mat.mes-hall↗

arXiv2017

Heterogeneous nucleation of catalyst-free InAs nanowires on silicon

We report on the heterogeneous nucleation of catalyst-free InAs nanowires on Si (111) substrates by chemical beam epitaxy. We show that nanowire nucleation is enhanced by sputtering the silicon substrate with energetic particles. We argue that particle bombardment introduces lattice defects on the silicon surface that serve as preferential nucleation sites. The formation of these nucleation sites can be controlled by the sputtering parameters, allowing the control of nanowire density in a wide range. Nanowire nucleation is accompanied by unwanted parasitic islands, but by careful choice of annealing and growth temperature allows to strongly reduce the relative density of these islands and to realize samples with high nanowire yield.

cond-mat.mes-hall↗

arXiv2016

Dephasing in strongly anisotropic black phosphorus

Weak localization was observed and determined in a black phosphorus (bP) field-effect transistor 65 nm thick. The weak localization behaviour was found to be in excellent agreement with the Hikami-Larkin-Nagaoka model for fields up to 1~T, from which characteristic scattering lengths could be inferred. The dephasing length $L_ϕ$ was found to increase linearly with increasing hole density attaining a maximum value of 55 nm at a hole density of approximately $10^{13} cm^{-2}$ inferred from the Hall effect. The temperature dependence of $L_ϕ$ was also investigated and above 1~K, it was found to decrease weaker than the $L_ϕ\propto T^{-\frac{1}{2}}$ dependence characteristic of electron-electron scattering in the presence of elastic scattering in two dimensions. Rather, the observed power law was found to be close to that observed previously in other quasi-one-dimensional systems such as metallic nanowires and carbon nanotubes. We attribute our result to the crystal structure of bP which host a `puckered' honeycomb lattice forming a strongly anisotropic medium

cond-mat.mes-hall↗

arXiv2015

Measurement of Topological Berry Phase in Highly Disordered Graphene

We have observed the quantum Hall effect (QHE) and Shubnikov-de Haas (SdH) oscillations in highly disordered graphene at magnetic fields up to 65 T. Disorder was introduced by hydrogenation of graphene up to a ratio H/C $\approx 0.1\%$. The analysis of SdH oscillations and QHE indicates that the topological part of the Berry phase, proportional to the pseudo-spin winding number, is robust against introduction of disorder by hydrogenation in large scale graphene.

cond-mat.mes-hall↗

arXiv2015

Increasing the active surface of titanium islands on graphene by nitrogen sputtering

Titanium-island formation on graphene as a function of defect density is investigated. When depositing titanium on pristine graphene, titanium atoms cluster and form islands with an average diameter of about 10nm and an average height of a few atomic layers. We show that if defects are introduced in the graphene by ion bombardment, the mobility of the deposited titanium atoms is reduced and the average diameter of the islands decreases to 5nm with monoatomic height. This results in an optimized coverage for hydrogen storage applications since the actual titanium surface available per unit graphene area is significantly increased.

physics.chem-ph↗

arXiv2013

Selective control of edge-channel trajectories by scanning gate microscopy

Electronic Mach-Zehnder interferometers in the Quantum Hall (QH) regime are currently discussed for the realization of quantum information schemes. A recently proposed device architecture employs interference between two co-propagating edge channels. Here we demonstrate the precise control of individual edge-channel trajectories in quantum point contact devices in the QH regime. The biased tip of an atomic force microscope is used as a moveable local gate to pilot individual edge channels. Our results are discussed in light of the implementation of multi-edge interferometers.

cond-mat.mes-hall↗

arXiv2007

Tuning the domain wall orientation in thin magnetic strips by induced anisotropy

We report on a method to tune the orientation of in-plane magnetic domains and domain walls in thin ferromagnetic strips by manipulating the magnetic anisotropy. Uniaxial in-plane anisotropy is induced in a controlled way by oblique evaporation of magnetic thin strips. A direct correlation between the magnetization direction and the domain wall orientation is found experimentally and confirmed by micromagnetic simulations. The domain walls in the strips are always oriented along the oblique evaporation-induced easy axis, in spite of the shape anisotropy. The controlled manipulation of domain wall orientations could open new possibilities for novel devices based on domain-wall propagation.

cond-mat.other↗

arXiv2005

Three-dimensional magnetic flux-closure patterns in mesoscopic Fe islands

We have investigated three-dimensional magnetization structures in numerous mesoscopic Fe/Mo(110) islands by means of x-ray magnetic circular dichroism combined with photoemission electron microscopy (XMCD-PEEM). The particles are epitaxial islands with an elongated hexagonal shape with length of up to 2.5 micrometer and thickness of up to 250 nm. The XMCD-PEEM studies reveal asymmetric magnetization distributions at the surface of these particles. Micromagnetic simulations are in excellent agreement with the observed magnetic structures and provide information on the internal structure of the magnetization which is not accessible in the experiment. It is shown that the magnetization is influenced mostly by the particle size and thickness rather than by the details of its shape. Hence, these hexagonal samples can be regarded as model systems for the study of the magnetization in thick, mesoscopic ferromagnets.

cond-mat.mtrl-sci↗