Searcharxiv⌕ Search

arXiv subjects

S. Hidalgo-Caballero

Publications and source records attributed to S. Hidalgo-Caballero.

3 recordsLinked to original sources

Penetration of Rigid Rods, Flexible Rods, and Granular Jets into Low-Density Granular Media

The penetration of projectiles into granular materials has been mainly studied using spherical intruders. Here we explore the dynamics of rods penetrating vertically in a two-dimensional granular bed composed of expanded polystyrene spheres. The experiments were performed using rigid rods, flexible rods and vertical arrays of non-cohesive particles, and the dynamics for the three cases was compared. In contrast to the vertical penetration observed for a single spherical projectile, high speed videos reveal that a rod rapidly deviates from its initial vertical direction due to inhomogeneities of the bed packing fraction. Then, the rod rotates due to the torque induced by the resistance force and follows a curved trajectory until be aligned horizontally at a final depth. A short rod tends to deviate faster than a longer rod due to the smaller moment of inertia. Moreover, long flexible rods always lose their vertical alignment and experience buckling, whereas rigid rods of the same size penetrate deeper before being deviated. On the other hand, experiments and molecular dynamics simulations show that a initially vertical array of grains also loses its verticality and stops adopting a final horizontal configuration. The granular array penetrates considerably less than the rods of equivalent mass, and the stopping mechanism is based on vertical-to-horizontal momentum transfer during a collisional process of the constituting particles.

cond-mat.soft↗

The simultaneous discharge of liquid and grains from a silo

The flow rate of water through an orifice at the bottom of a container depends on the hydrostatic pressure whereas for a dry granular material is nearly constant. But what happens during the simultaneous discharge of grains and liquid from a silo? By measuring the flow rate as a function of time, we found that: (i) different regimes appear, going from constant flow rate dominated by the effective fluid viscosity to a hydrostatic-like discharge depending on the aperture and grain size, (ii) the mixed material is always discharged faster than dry grains but slower than liquid, (iii) for the mixture, the liquid level drops faster than the grains level but they are always linearly proportional to one another, and (iv) a sudden growth in the flow rate happens during the transition from a biphasic to a single phase discharge. These results are associated to the competition between the decrease of hydrostatic pressure above the granular bed and the hydrodynamic resistance. A model combining the Kozeny-Carman, Bernoulli and mass conservation equations is proposed and the numerical results are in good agreement with experiments.

physics.flu-dyn↗

Surface depression with double-angle geometry during the discharge of close-packed grains from a silo

When rough grains in standard packing conditions are discharged from a silo, a conical depression with a single slope is formed at the surface. We observed that the increase of the volume fraction generates a more complex depression characterized by two angles of discharge: a lower angle close to the one measured for standard packing and a considerably larger upper angle. The change in slope appears at the boundary between a densely packed stagnant region at the periphery and the central flowing channel formed over the aperture. Since the material in the latter zone is always fluidized, the flow rate is unaffected by the initial packing of the bed. On the other hand, the contrast between both angles is markedly smaller when smooth particles of the same size and density are used, which reveals that high volume fraction and friction must combine to produce the observed geometry. Our results show that the surface profile helps to identify by simple visual inspection the packing conditions of a granular bed, and this can be useful to prevent undesirable collapses during silo discharge in industry.

cond-mat.soft↗