arXiv subjects

S. Komura

Publications and source records attributed to S. Komura.

13 recordsLinked to original sources

arXiv2021

Brownian motion of a charged colloid in restricted confinement

We study the Brownian motion of a charged colloid, confined between two charged walls, for small separation between the colloid and the walls. The system is embedded in an ionic solution. The combined effect of electrostatic repulsion and reduced diffusion due to hydrodynamic forces results in a specific motion in the direction perpendicular to the confining walls. The apparent diffusion coefficient at short times as well as the diffusion characteristic time are shown to follow a sigmoid curve as function of a dimensionless parameter. This parameter depends on the electrostatic properties and can be controlled by tuning the solution ionic strength. At low ionic strength, the colloid moves faster and is localized, while at high ionic strength it moves slower and explores a wider region between the walls, resulting in a larger diffusion characteristic time.

cond-mat.soft↗

arXiv2016

Readout technologies for directional WIMP Dark Matter detection

The measurement of the direction of WIMP-induced nuclear recoils is a compelling but technologically challenging strategy to provide an unambiguous signature of the detection of Galactic dark matter. Most directional detectors aim to reconstruct the dark-matter-induced nuclear recoil tracks, either in gas or solid targets. The main challenge with directional detection is the need for high spatial resolution over large volumes, which puts strong requirements on the readout technologies. In this paper we review the various detector readout technologies used by directional detectors. In particular, we summarize the challenges, advantages and drawbacks of each approach, and discuss future prospects for these technologies.

physics.ins-det↗

arXiv2015

Correlated lateral phase separations in stacks of lipid membranes

Motivated by the experimental study of Tayebi et al. [Nature Mater. 11, 1074 (2012)] on phase separation of stacked multi-component lipid bilayers, we propose a model composed of stacked two-dimensional Ising spins. We study both its static and dynamical features using Monte Carlo simulations with Kawasaki spin exchange dynamics that conserves the order parameter. We show that at thermodynamical equilibrium, due to strong inter-layer correlations, the system forms a continuous columnar structure for any finite interaction across adjacent layers. Furthermore, the phase separation shows a faster dynamics as the inter-layer interaction is increased. This temporal behavior is mainly due to an effective deeper temperature quench because of the larger value of the critical temperature, $T_{\rm c}$, for larger inter-layer interaction. When the temperature ratio, $T/T_{\rm c}$, is kept fixed, the temporal growth exponent does not increase and even slightly decreases as function of the increased inter-layer interaction, as the system crosses-over from two to three dimensions.

cond-mat.soft↗

arXiv2015

An Electron-Tracking Compton Telescope for a Survey of the Deep Universe by MeV gamma-rays

Photon imaging for MeV gammas has serious difficulties due to huge backgrounds and unclearness in images, which are originated from incompleteness in determining the physical parameters of Compton scattering in detection, e.g., lack of the directional information of the recoil electrons. The recent major mission/instrument in the MeV band, Compton Gamma Ray Observatory/COMPTEL, which was Compton Camera (CC), detected mere $\sim30$ persistent sources. It is in stark contrast with $\sim$2000 sources in the GeV band. Here we report the performance of an Electron-Tracking Compton Camera (ETCC), and prove that it has a good potential to break through this stagnation in MeV gamma-ray astronomy. The ETCC provides all the parameters of Compton-scattering by measuring 3-D recoil electron tracks; then the Scatter Plane Deviation (SPD) lost in CCs is recovered. The energy loss rate (dE/dx), which CCs cannot measure, is also obtained, and is found to be indeed helpful to reduce the background under conditions similar to space. Accordingly the significance in gamma detection is improved severalfold. On the other hand, SPD is essential to determine the point-spread function (PSF) quantitatively. The SPD resolution is improved close to the theoretical limit for multiple scattering of recoil electrons. With such a well-determined PSF, we demonstrate for the first time that it is possible to provide reliable sensitivity in Compton imaging without utilizing an optimization algorithm. As such, this study highlights the fundamental weak-points of CCs. In contrast we demonstrate the possibility of ETCC reaching the sensitivity below $1\times10^{-12}$ erg cm$^{-2}$ s$^{-1}$ at 1 MeV.

astro-ph.IM↗

arXiv2015

Performance of a new electron-tracking Compton camera under intense radiations from a water target irradiated with a proton beam

We have developed an electron-tracking Compton camera (ETCC) for use in next-generation MeV gamma ray telescopes. An ETCC consists of a gaseous time projection chamber (TPC) and pixel scintillator arrays (PSAs). Since the TPC measures the three dimensional tracks of Compton-recoil electrons, the ETCC can completely reconstruct the incident gamma rays. Moreover, the ETCC demonstrates efficient background rejection power in Compton-kinematics tests, identifies particle from the energy deposit rate (dE/dX) registered in the TPC, and provides high quality imaging by completely reconstructing the Compton scattering process. We are planning the "Sub-MeV gamma ray Imaging Loaded-on-balloon Experiment" (SMILE) for our proposed all-sky survey satellite. Performance tests of a mid-sized 30 cm-cubic ETCC, constructed for observing the Crab nebula, are ongoing. However, observations at balloon altitudes or satellite orbits are obstructed by radiation background from the atmosphere and the detector itself. The background rejection power was checked using proton accelerator experiments conducted at the Research Center for Nuclear Physics, Osaka University. To create the intense radiation fields encountered in space, which comprise gamma rays, neutrons, protons, and other energetic entities, we irradiated a water target with a 140 MeV proton beam and placed a SMILE-II ETCC near the target. In this situation, the counting rate was five times than that expected at the balloon altitude. Nonetheless, the ETCC stably operated and identified particles sufficiently to obtain a clear gamma ray image of the checking source. Here, we report the performance of our detector and demonstrate its effective background rejection based in electron tracking experiments.

astro-ph.IM↗

arXiv2014

Development of a 30 cm-cube Electron-Tracking Compton Camera for the SMILE-II Experiment

To explore the sub-MeV/MeV gamma-ray window for astronomy, we have developed the Electron-Tracking Compton Camera (ETCC), and carried out the first performance test at room condition using several gamma-ray sources in the sub-MeV energy band. Using a simple track analysis for a quick first test of the performance, the gamma-ray imaging capability was demonstrated by clear images and 5.3 degrees of angular resolution measure (ARM) measured at 662 keV. As the greatest impact of this work, a gamma-ray detection efficiency on the order of $10^{-4}$ was achieved at the sub-MeV gamma-ray band, which is one order of magnitude higher than our previous experiment. This angular resolution and detection efficiency enables us to detect the Crab Nebula at the 5 sigma level with several hours observation at balloon altitude in middle latitude. Furthermore, good consistency of efficiencies between this performance test and simulation including only physical processes has a large importance; it means we achieve nearly 100% detection of Compton recoil electrons. Thus, our estimation of enhancements by upgrades of the detector is more dependable. We are planning to confirm the imaging capability of the ETCC by observation of celestial objects in the SMILE-II (Sub-MeV gamma ray Imaging Loaded-on-balloon Experiment II). The SMILE-II and following SMILE-III project will be an important key of sub-MeV/MeV gamma-ray astronomy.

astro-ph.IM↗

arXiv2012

Anomalous lateral diffusion in a viscous membrane surrounded by viscoelastic media

We investigate the lateral dynamics in a purely viscous lipid membrane surrounded by viscoelastic media such as polymeric solutions. We first obtain the generalized frequency-dependent mobility tensor and focus on the case when the solvent is sandwiched by hard walls. Due to the viscoelasticity of the solvent, the mean square displacement of a disk embedded in the membrane exhibits an anomalous diffusion. An useful relation which connects the mean square displacement and the solvent modulus is provided. We also calculate the cross-correlation of the particle displacements which can be applied for two-particle tracking experiments.

cond-mat.soft↗

arXiv2011

Charged bilayer membranes in asymmetric ionic solutions: Phase diagrams and critical behavior

We consider the phase separation in an asymmetrically charged lipid bilayer membrane consisting of neutral and negatively charged lipids that are in contact with in/out ionic solutions having different ionic strengths. The two asymmetric leaflets are coupled through electrostatic interactions. Based on a free energy approach, the critical point and phase diagrams are calculated for different ionic strength of the two solutions and coupling parameter. An increase of the coupling constant or asymmetry in the salt concentration between the in/out solutions yields a higher phase separation temperature because of electrostatic interactions. As a consequence, the phase-coexistence region increases for strong screening (small Debye length). Finally, possible three-phase coexistence regions in the phase diagram are predicted.

cond-mat.soft↗

arXiv2011

Elasticity of smectic liquid crystals with focal conic domains

We study the elastic properties of thermotropic smectic liquid crystals with focal conic domains (FCDs). After the application of the controlled preshear at different temperatures, we independently measured the shear modulus G' and the FCD size L. We find out that these quantities are related by the scaling relation G' ~ γ_{eff}/L where γ_{eff} is the effective surface tension of the FCDs. The experimentally obtained value of γ_{\rm eff} shows the same scaling as the effective surface tension of the layered systems \sqrt{KB} where K and B are the bending modulus and the layer compression modulus, respectively. The similarity of this scaling relation to that of the surfactant onion phase suggests an universal rheological behavior of the layered systems with defects.

cond-mat.soft↗

arXiv2007

The Phase Behavior of Mixed Lipid Membranes in Presence of the Rippled Phase

We propose a model describing liquid-solid phase coexistence in mixed lipid membranes by including explicitly the occurrence of a rippled phase. For a single component membrane, we employ a previous model in which the membrane thickness is used as an order parameter. As function of temperature, this model properly accounts for the phase behavior of the three possible membrane phases: solid, liquid and the rippled phase. Our primary aim is to explore extensions of this model to binary lipid mixtures by considering the composition dependence of important model parameters. The obtained phase diagrams show various liquid, solid and rippled phase coexistence regions, and are in quantitative agreement with the experimental ones for some specific lipid mixtures.

cond-mat.soft↗

arXiv2005

Tension-Induced Morphological Transition in Mixed Lipid Bilayers

Recently, Rozovsky et al. reported on the morphology and dynamics of superstructures in three-component lipid bilayers containing saturated and unsaturated lipids as well as cholesterol [J. Am. Chem. Soc. 127, 36 (2005)]. We comment that the observed sequence of the stripe to hexagonal morphological transition in mixed bilayers can be attributed to an enhanced membrane surface tension that is induced by the vesicle adhesion on the solid surface.

cond-mat.soft↗

arXiv2002

Mechanical, adhesive and thermodynamic properties of hollow nanoparticles

When sheets of layered material like C, WS$_2$ or BN are restricted to finite sizes, they generally form single- and multi-walled hollow nanoparticles in order to avoid dangling bonds. Using continuum approaches to model elastic deformation and van der Waals interactions of spherical nanoparticles, we predict the variation of mechanical stability, adhesive properties and phase behavior with radius $R$ and thickness $h$. We find that mechanical stability is limited by forces in the nN range and pressures in the GPa range. Adhesion energies scale linearly with $R$, but depend only weakly on $h$. Deformation due to van der Waals adhesion occurs for single-walled particles for radii of few nm, but is quickly suppressed for increasing thickness. As $R$ is increased, the gas-liquid coexistence disappears from the phase diagram for particle radii in the range of 1-3 nm (depending on wall thickness) since the interaction range decreases like 1/R.

cond-mat.soft↗

arXiv2000

Deformation and tribology of multi-walled hollow nanoparticles

Multi-walled hollow nanoparticles made from tungsten disulphide (WS$_2$) show exceptional tribological performance as additives to liquid lubricants due to effective transfer of low shear strength material onto the sliding surfaces. Using a scaling approach based on continuum elasticity theory for shells and pairwise summation of van der Waals interactions, we show that van der Waals interactions cause strong adhesion to the substrate which favors release of delaminated layers onto the surfaces. For large and thin nanoparticles, van der Waals adhesion can cause considerable deformation and subsequent delamination. For the thick WS$_2$ nanoparticles, deformation due to van der Waals interactions remains small and the main mechanism for delamination is pressure which in fact leads to collapse beyond a critical value. We also discuss the effect of shear flow on deformation and rolling on the substrate.

cond-mat.mtrl-sci↗