arXiv subjects

S. Linzen

Publications and source records attributed to S. Linzen.

13 recordsLinked to original sources

arXiv2026

Spatial homogeneity of superconducting order parameter in NbN films grown by atomic layer deposition

Due to their high kinetic inductance, highly disordered superconducting thin films are a potential hardware for the realization of compact, low-noise elements in cryoelectronic applications. However, high disorder typically results in structural defects that cause spatial inhomogeneity of the superconducting order parameter, thereby impairing the film's properties. Here, we employ scanning tunneling microscopy to demonstrate that NbN thin films fabricated by plasma-enhanced atomic layer deposition (PE-ALD) exhibit unusual spatial homogeneity, even at thicknesses approaching the superconductor-insulator transition. Tunneling spectra acquired across the sample surface show only small variations of the order parameter with a standard deviation of 2-3%, on length scales that significantly exceed the film's grain size. At the same time, the films achieve a relatively high sheet resistance (up to 1400 Ohm) and, consequently, a high sheet kinetic inductance (up to approximately 200 pH), making them well-suited for applications.

cond-mat.supr-con↗

arXiv2026

Aharonov-Casher Effect and the Coherent Flux Tunneling in the Hybrid Charge Quantum Interference Device

By exploiting the Aharonov-Casher effect we demonstrate a suppression of magnetic flux tunneling in a Hybrid Charge Quantum Interference Device. The main part of this device is two Josephson junctions with a small superconducting island between them. To minimize phase fluctuations across Josephson junctions, this structure is embedded in a compact super-inductive NbN loop. The Interference between the flux tunneling paths is determined by the island-induced charge, which is controlled by an external voltage. The charge sensitive operation of the device is subjected to poisoning by the quasiparticles generated in the NbN film.

cond-mat.supr-con↗

arXiv2022

Quantized current steps due to the a.c. coherent quantum phase-slip effect

The AC Josephson effect predicted in 1962 and observed experimentally in 1963 as quantised voltage steps (the Shapiro steps) from photon assisted tunnelling of Cooper pairs is among the most fundamental phenomena of quantum mechanics and is vital for metrological quantum voltage standards. The physically dual effect, the AC coherent quantum phase slip (CQPS), photon assisted tunnelling of magnetic fluxes through a superconducting nanowire, is envisaged to reveal itself as quantised current steps. The basic physical significance of the AC CQPS is also complemented by practical importance in future current standards; a missing element for closing the Quantum Metrology Triangle. In 2012, the CQPS was demonstrated as superposition of magnetic flux quanta in superconducting nanowires. However the direct sharp current steps in superconductors; the only unavailable basic effect of superconductivity to date, was unattainable due to lack of appropriate materials and challenges in circuit engineering. Here we report the direct observation of the dual Shapiro steps in a superconducting nanowire. The sharp steps are clear up to 26 GHz frequency with current values 8.3 nA and limited by the present setup bandwidth. The current steps have been theoretically predicted in small Josephson junctions (JJs) 30 years ago. However, broadening unavoidable in JJs prevents their direct experimental observation. We solve this problem by placing a thin NbN nanowire in an inductive environment.

cond-mat.supr-con↗

arXiv2022

Reflection-enhanced gain in traveling-wave parametric amplifiers

The operating principle of traveling-wave parametric amplifiers is typically understood in terms of the standard coupled mode theory, which describes the evolution of forward propagating waves without any reflections, i.e. for perfect impedance matching. However, in practice, superconducting microwave amplifiers are unmatched nonlinear finite-length devices, where the reflecting waves undergo complex parametric processes, not described by the standard coupled mode theory. Here, we present an analytical solution for the TWPA gain, which includes the interaction of reflected waves. These reflections result in corrections to the well-known results of the standard coupled mode theory, which are obtained for both 3-wave and 4-wave mixing processes. Due to these reflections, gain is enhanced and unwanted nonlinear phase modulations are suppressed. Predictions of the model are experimentally demonstrated on two types of unmatched TWPA, based on coplanar waveguides with a central wire consisting of i) a high kinetic inductance superconductor, and ii) an array of 2000 Josephson junctions.

cond-mat.mtrl-sci↗

arXiv2017

Nearly quantum limited nanoSQUIDs based on cross-type Nb/AlOx/Nb junctions

We report on the development of nearly quantum limited SQUIDs with miniature pickup loop dimensions. The implemented high quality and low capacitance cross-type Nb/AlOx/Nb Josephson junctions offer large $I_CR_N$-products and therefore enable an exceptional low noise level of the SQUIDs. Devices with loop dimensions of 1 {\mu}m exhibit white flux noise levels as low as $45 n{\Phi}_0/Hz^{1/2}$ corresponding to an energy resolution {\epsilon} of about 1 h at 4.2 K, with h being Plancks constant. Moreover, the large usable voltage swings of the devices of about 300 {\mu}V allow highly sensitive and easy single-stage operation while exploring nearly the intrinsic noise of the SQUIDs, beneficial e.g. for sensor arrays in SQUID microscopy.

cond-mat.supr-con↗

arXiv2017

Thin-film based ultralow noise SQUID magnetometer

We report on the development of an ultralow noise thin-film based SQUID magnetometer. A niobium thin-film pickup coil is connected to the input coil of a SQUID current sensor. The low capacitance of the used sub-micrometer cross-type Josephson junctions enable superior noise performance of the device. Application scenarios e.g. in geophysics and ultra-low field magnetic resonance imaging are discussed.

physics.ins-det↗

arXiv2015

Investigation of all niobium Nano-SQUIDs based on sub-micrometer cross-type Josephson junctions

We report on the development of highly sensitive SQUIDs featuring sub-micrometer loop dimensions. The integration of high quality and low capacitance SIS Nb/AlOx/Nb cross-type Josephson tunnel junctions results in white flux noise levels as low as 66 n$\Phi_0$/Hz$^{ 1/2} $, well below state-of-the-art values of their Nb-based counterparts based on constriction type junctions. Estimation of the spin sensitivity of the best SQUIDs yield $S_\mu^{ 1/2} < 7 \mu_B$/Hz$^{ 1/2} $ in the white noise region, suitable for the investigation of small spin systems. We discuss fabrication challenges, show results on the electrical characterization of devices with various pickup loops, and describe options for further improvement, which may push the sensitivity of such devices even to single spin resolution.

cond-mat.supr-con↗

arXiv2007

Realization of a classical counterpart of a scalable design for adiabatic quantum computation

We implement a classical counterpart of a scalable design for adiabatic quantum computation. The key element of this design is a coupler providing controllable coupling between two bistable elements (in our case superconducting rings with a single Josephson junction playing the role of a classical counterpart of superconducting flux qubits) The coupler is also a superconducting ring with a single Josephson junction that operates in the non-hysteretic mode. The flux coupling between two bistable rings can be controlled by changing the magnetic flux through the coupler. Thereby, the coupling can be tuned from ferromagnetic trough zero to to anti-ferromagnetic.

cond-mat.supr-con↗

arXiv2007

Adiabatic quantum computation with flux qubits, first experimental results

Controllable adiabatic evolution of a multi-qubit system can be used for adiabatic quantum computation (AQC). This evolution ends at a configuration where the Hamiltonian of the system encodes the solution of the problem to be solved. As a first steps towards realization of AQC we have investigated two, three and four flux qubit systems. These systems were characterized by making use of a radio-frequency method. We designed two-qubit systems with coupling energies up to several kelvins. For the three-flux-qubit systems we determined the complete ground-state flux diagram in the three dimensional flux space around the qubits common degeneracy point. We show that the system`s Hamiltonian can be completely reconstructed from our measurements. Our concept for the implementation of AQC, by making use of flux qubits, is discussed.

cond-mat.supr-con↗

arXiv2006

Four-qubit device with mixed couplings

We present the first experimental results on a device with more than two superconducting qubits. The circuit consists of four three-junction flux qubits, with simultaneous ferro- and antiferromagnetic coupling implemented using shared Josephson junctions. Its response, which is dominated by the ground state, is characterized using low-frequency impedance measurement with a superconducting tank circuit coupled to the qubits. The results are found to be in excellent agreement with the quantum-mechanical predictions.

cond-mat.supr-con↗

arXiv2005

Direct Josephson coupling between superconducting flux qubits

We have demonstrated strong antiferromagnetic coupling between two three-junction flux qubits based on a shared Josephson junction, and therefore not limited by the small inductances of the qubit loops. The coupling sign and magnitude were measured by coupling the system to a high-quality superconducting tank circuit. Design modifications allowing to continuously tune the coupling strength and/or make the coupling ferromagnetic are discussed.

cond-mat.supr-con↗

arXiv2005

Flux Qubits and Readout Device with Two Independent Flux Lines

We report measurements on two superconducting flux qubits coupled to a readout Superconducting QUantum Interference Device (SQUID). Two on-chip flux bias lines allow independent flux control of any two of the three elements, as illustrated by a two-dimensional qubit flux map. The application of microwaves yields a frequency-flux dispersion curve for 1- and 2-photon driving of the single-qubit excited state, and coherent manipulation of the single-qubit state results in Rabi oscillations and Ramsey fringes. This architecture should be scalable to many qubits and SQUIDs on a single chip.

cond-mat.supr-con↗

arXiv2004

Entangling flux qubits with a bipolar dynamic inductance

We propose a scheme to implement variable coupling between two flux qubits using the screening current response of a dc Superconducting QUantum Interference Device (SQUID). The coupling strength is adjusted by the current bias applied to the SQUID and can be varied continuously from positive to negative values, allowing cancellation of the direct mutual inductance between the qubits. We show that this variable coupling scheme permits efficient realization of universal quantum logic. The same SQUID can be used to determine the flux states of the qubits.

quant-ph↗