arXiv subjects

S. Sánchez

Publications and source records attributed to S. Sánchez.

9 recordsLinked to original sources

arXiv2025

Shared-optical-path VLBI frequency phase transfer from 86 to 258 GHz on an 8600 km baseline: Demonstrated with the APEX and IRAM 30 m telescopes

The receiver N3AR operating at a frequency range between 67 and 116 GHz has been commissioned at the APEX telescope in October 2024. This adds a new low-frequency band for APEX, with the capability of simultaneous dual-frequency observations using a dichroic beamsplitter. The 3 mm receiver also allows APEX to join the existing 3 mm global VLBI network. One of our commissioning goals was to perform simultaneous dual-band VLBI observations at 86 and 258 GHz using receivers with shared-optical-paths (SOP) to correct the atmospheric phase fluctuations using the frequency phase transfer (FPT) technique. This was possible together with the IRAM 30 m telescope, which has already developed such a capability. We aimed to verify the expected phase coherence and sensitivity improvement at the higher frequency achievable by applying FPT. With the dual-band, single baseline data, we applied the FPT method, which uses the lower frequency data to correct the simultaneously observed higher-frequency data. We evaluate the improvement compared to the conventional single-band observing mode by analyzing the coherence factor in the higher frequency data. Our results show that the phase fluctuations at the two bands are well correlated. After applying FPT, the interferometric phases at the higher frequency vary much slower and the coherence factor is significantly improved. Our analysis confirms the feasibility of applying FPT to frequencies above 250 GHz with SOP receivers. Future observations in this mode could dramatically improve the sensitivity and imaging fidelity of high-frequency VLBI.

astro-ph.IM↗

arXiv2024

A nonlinear room mode determines the operating conditions of a large-cavity synthetic jet actuator at low frequencies

Synthetic Jet (SJ) actuators are an intrinsically complex combination of electronics, electric and mechanical systems. When studied theoretically, these elements are often simplified to coupled damped harmonic oscillators (DHO) that induce a pressure field within the cavity and drive momentum exchange. Thus, the performance of an SJ actuator results from coupling these DHOs, naturally leading to a few resonant modes. There is good evidence in the specialized literature of two resonant modes developing in SJ actuators: the membrane/piezoelectric mode and the Helmholtz resonance. In this work, we report on the effect of a third resonant mode that develops at very low frequencies due to a cavity much larger than the volume displaced by the actuator. We present evidence that the large-cavity dynamics determine the SJ performance in combination with the well-described formation criteria. We compare the intensity of this resonant mode with the first room modes using standard frequency analysis. Unlike typical room modes, the distribution of this resonant mode is very biased to lower frequencies. We also show that the resonant mode may be dimmed and focused by adding an obstacle in different cavity positions for the lower sound intensities. This mode overcomes the Helmholtz resonance, dominating the dynamics for higher sound intensities. We show that jet and vortex velocities mimic the sound pressure curve for the low-frequency range. Its effect mitigates for the higher range due to a delve through smaller stroke lengths, characterized as a fixed relation between the Reynolds and the Stokes numbers. We consider that the large-cavity dynamics is an additional element that, if integrated as design criteria, could extend the optimum frequency response of SJs.

physics.flu-dyn↗

arXiv2023

Metadata for the Flux Density Calibration of the April 2018 Event Horizon Telescope Data

The Event Horizon Telescope (EHT) observations carried out in 2018 April at 1.3 mm wavelengths included 9 stations in the array, comprising 7 single-dish telescopes and 2 phased arrays. The metadata package for the 2018 EHT observing campaign contains calibration tables required for the a-priori amplitude calibration of the 2018 April visibility data. This memo is the official documentation accompanying the release of the 2018 EHT metadata package, providing an overview of the contents of the package. We describe how telescope sensitivities, gain curves and other relevant parameters for each station in the EHT array were collected, processed, and validated to produce the calibration tables.

astro-ph.IM↗

arXiv2021

The jet collimation profile at high resolution in BL Lacertae

Controversial studies on the jet collimation profile of BL Lacertae (BL Lac), the eponymous blazar of BL Lac objects class, complicate the scenario in this already puzzling class of objects. Understanding the jet geometry, in connection with the jet kinematics and the physical conditions in the surrounding medium, is fundamental to better constrain the formation, acceleration and collimation mechanisms in extragalactic jets. With the aim of investigating the jet geometry in the innermost regions of the jet of BL Lac, and solving the controversy, we explore the radio jet in this source, using high resolution millimeter-wave VLBI data. We collect 86GHz GMVA and 43GHz VLBA data to obtain stacked images that we use to infer the jet collimation profile by means of two comparable methods. We analyze the kinematics at 86GHz, and we discuss it in the context of the jet expansion. Finally we consider a possible implication of the Bondi sphere in shaping the different expanding region observed along the jet. We found that the jet in BL Lac expands with an overall conical geometry. A higher expanding rate region is observed between ~5 and 10 pc (de-projected) from the black hole. Such a region is associated with the decrease in brightness usually observed in high-frequency VLBI images of BL Lac. The jet retrieves the original jet expansion around 17 pc, where the presence of a recollimation shock is supported by both the jet profile and the 15GHz kinematics (MOJAVE survey). The change in the jet expansion profile occurring at ~5 pc could be associated with a change in the external pressure profile in correspondence of the Bondi radius (~3.3X10$^5$$R_s$).

astro-ph.HE↗

arXiv2020

Detection of the magnetar XTE J1810-197 at 150 and 260 GHz with the NIKA2 Kinetic Inductance Detector camera

The investigation of pulsars between millimetre and optical wavelengths is challenging due to the faintness of the pulsar signals and the relative low sensitivity of the available facilities compared to 100-m class telescopes operating in the centimetre band. The Kinetic Inductance Detector (KID) technology offers large instantaneous bandwidths and a high sensitivity that can help to substantially increase the ability of existing observatories at short wavelengths to detect pulsars and transient emission. To investigate the feasibility of detecting pulsars with KIDs, we observed the anomalous X-ray pulsar XTE J1810-197 with the New IRAM KIDs Array-2 (NIKA2) camera installed at the IRAM 30-m Telescope in Spain. We detected the pulsations from the pulsar with NIKA2 at its two operating frequency bands, 150 and 260 GHz ($λ$=2.0 and 1.15 mm, respectively). This is the first time that a pulsar is detected with a receiver based on KID technology in the millimetre band. In addition, this is the first report of short millimetre emission from XTE J1810-197 after its reactivation in December 2018, and it is the first time that the source is detected at 260 GHz, which gives us new insights into the radio emission process of the star.

astro-ph.IM↗

arXiv2017

Self-assembly of micro-machining systems powered by Janus micro-motors

Integration of active matter in larger micro-devices can provide an embedded source of propulsion and lead to self-actuated micromachining systems that do not rely on any external power or control apparatus. Here we demonstrate that Janus colloids can self-assemble around micro-fabricated rotors in reproducible configurations with a high degree of spatial and orientational order. The final configuration maximizes the torque applied on the rotor leading to a unidirectional and steady rotating motion. We discuss how the interplay between geometry and dynamical behavior consistently leads to the self-assembly of autonomous micromotors starting from randomly distributed building blocks.

cond-mat.soft↗

arXiv2015

First 230 GHz VLBI Fringes on 3C 279 using the APEX Telescope

We report about a 230 GHz very long baseline interferometry (VLBI) fringe finder observation of blazar 3C 279 with the APEX telescope in Chile, the phased submillimeter array (SMA), and the SMT of the Arizona Radio Observatory (ARO). We installed VLBI equipment and measured the APEX station position to 1 cm accuracy (1 sigma). We then observed 3C 279 on 2012 May 7 in a 5 hour 230 GHz VLBI track with baseline lengths of 2800 M$λ$ to 7200 M$λ$ and a finest fringe spacing of 28.6 micro-arcseconds. Fringes were detected on all baselines with SNRs of 12 to 55 in 420 s. The correlated flux density on the longest baseline was ~0.3 Jy/beam, out of a total flux density of 19.8 Jy. Visibility data suggest an emission region <38 uas in size, and at least two components, possibly polarized. We find a lower limit of the brightness temperature of the inner jet region of about 10^10 K. Lastly, we find an upper limit of 20% on the linear polarization fraction at a fringe spacing of ~38 uas. With APEX the angular resolution of 230 GHz VLBI improves to 28.6 uas. This allows one to resolve the last-photon ring around the Galactic Center black hole event horizon, expected to be 40 uas in diameter, and probe radio jet launching at unprecedented resolution, down to a few gravitational radii in galaxies like M 87. To probe the structure in the inner parsecs of 3C 279 in detail, follow-up observations with APEX and five other mm-VLBI stations have been conducted (March 2013) and are being analyzed.

astro-ph.IM↗

arXiv2015

The CALIFA survey across the Hubble sequence: How galaxies grow their bulges and disks

We characterize in detail the radial structure of the stellar population properties of 300 galaxies in the nearby universe, observed with integral field spectroscopy in the CALIFA survey. The sample covers a wide range of Hubble types, from spheroidal to spiral galaxies, ranging in stellar masses from $M_\star \sim 10^9$ to $7 \times 10^{11}$ $M_\odot$. We derive the stellar mass surface density ($μ_\star$), light-weighted and mass-weighted ages ($\langle {\rm log}\,age\rangle _L$, $\langle {\rm log}\,age\rangle _M$), and mass-weighted metallicity ($\langle {\rm log}\,Z_\star\rangle _M$), applying the spectral synthesis technique. We study the mean trends with galaxy stellar mass, $M_\star$, and morphology (E, S0, Sa, Sb, Sbc, Sc and Sd). We confirm that more massive galaxies are more compact, older, more metal rich, and less reddened by dust. Additionally, we find that these trends are preserved spatially with the radial distance to the nucleus. Deviations from these relations appear correlated with Hubble type: earlier types are more compact, older, and more metal rich for a given M$_\star$, which evidences that quenching is related to morphology, but not driven by mass.

astro-ph.GA↗

arXiv2014

Radial velocity confirmation of Kepler-91 b. Additional evidence of its planetary nature using the Calar Alto/CAFE instrument

The object transiting the star Kepler-91 was recently assessed as being of planetary nature. The confirmation was achieved by analysing the light-curve modulations observed in the Kepler data. However, quasi-simultaneous studies claimed a self-luminous nature for this object, thus rejecting it as a planet. In this work, we apply an {independent} approach to confirm the planetary mass of Kepler-91b by using multi-epoch high-resolution spectroscopy obtained with the Calar Alto Fiber-fed Echelle spectrograph (CAFE). We obtain the physical and orbital parameters with the radial velocity technique. In particular, we derive a value of $1.09 \pm 0.20\,M_{\mathrm{Jup}}$ for the mass of Kepler-91b, in excellent agreement with our previous estimate that was based on the orbital brightness modulation.

astro-ph.EP↗