Searcharxiv⌕ Search

arXiv subjects

S. Saito

Publications and source records attributed to S. Saito.

At least 37 records · Page 2Linked to original sources
arXiv2011

Fermi Large Area Telescope Detection of Bright Gamma-ray Outbursts from a Peculiar Quasar 4C +21.35

In this paper we report on the two-year-long Fermi-LAT observation of the peculiar blazar 4C +21.35 (PKS 1222+216). This source was in a quiescent state from the start of science operations of the Fermi Gamma-ray Space Telescope in 2008 August until 2009 September, and then became more active, with gradually increasing flux and some moderately-bright flares. In 2010 April and June, 4C +21.35 underwent a very strong GeV outburst composed of several major flares characterized by rise and decay timescales of the order of a day. During the outburst, the GeV spectra of 4C +21.35 displayed a broken power-law form with spectral breaks observed near 1-3 GeV photon energies. We demonstrate that, at least during the major flares, the jet in 4C +21.35 carried a total kinetic luminosity comparable to the total accretion power available to feed the outflow. We also discuss the origin of the break observed in the flaring spectra of 4C +21.35. We show that, in principle, a model involving annihilation of the GeV photons on the He II Lyman recombination continuum and line emission of "broad line region" clouds may account for such. However, we also discuss the additional constraint provided by the detection of 4C +21.35 at 0.07-0.4 TeV energies by the MAGIC telescope, which coincided with one of the GeV flares of the source. We argue that there are reasons to believe that the $lesssim$,TeV emission of 4C +21.35 (as well as the GeV emission of the source, if co-spatial), is not likely to be produced inside the broad line region zone of highest ionization ($sim 10^{17}$,cm from the nucleus), but instead originates further away from the active center, namely around the characteristic scale of the hot dusty torus surrounding the 4C +21.35 nucleus ($sim 10^{19}$,cm).

astro-ph.HE↗
arXiv2010

Readout strength dependence of state projection in superconducting qubit

We have controlled the measurement strength of the qubit readout process by using a Josephson bifurcation amplifier (JBA : an AC-driven SQUID). The optimum readout pulse changes the superposition state into an eigenstate. To clarify how a sufficiently strong measurement causes a projection phenomenon, we have studied the projection conditions in the JBA readout. We found that the projection occurs above the pulse height at which visibility starts to appear. Furthermore, the projection continues to occur as readout strength increases, even though the visibility vanishes. This result helps us understanding the JBA readout process.

cond-mat.supr-con↗
arXiv2009

Experimentally Realizable C-NOT Gate in a Flux Qubit/Resonator System

In this paper we present an experimentally realizable microwave pulse sequence that effects a Controlled NOT (C-NOT) gate operation on a Josephson junction-based flux-qubit/resonator system with high fidelity in the end state. We obtained a C-NOT gate process fidelity of 0.988 (0.980) for a two (three) qubit/resonator system under ideal conditions, and a fidelity of 0.903 for a two qubit/resonator system under the best, currently achieved, experimental conditions. In both cases, we found that "qubit leakage" to higher levels of the resonator causes a majority of the loss of fidelity, and that such leakage becomes more pronounced as decoherence effects increase.

cond-mat.mes-hall↗
arXiv2008

Role of relaxation in the quantum measurement of a superconducting qubit using a nonlinear oscillator

We analyze the relaxation of a superconducting flux qubit during measurement. The qubit state is measured with a nonlinear oscillator driven across the threshold of bifurcation, acting as a switching dispersive detector. This readout scheme is of quantum non-demolition type. Two successive readouts are used to analyze the evolution of the qubit and the detector during the measurement. We introduce a simple transition rate model to characterize the qubit relaxation and the detector switching process. Corrected for qubit relaxation the readout fidelity is at least 95%. Qubit relaxation strongly depends on the driving strength and the state of the oscillator.

cond-mat.supr-con↗
arXiv2008

Phase-Coherent Dynamics of a Superconducting Flux Qubit with Capacitive-Bias Readout

We present a systematic study of the phase-coherent dynamics of a superconducting three-Josephson-junction flux qubit. The qubit state is detected with the integrated-pulse method, which is a variant of the pulsed switching DC SQUID method. In this scheme the DC SQUID bias current pulse is applied via a capacitor instead of a resistor, giving rise to a narrow band-pass instead of a pure low-pass filter configuration of the electromagnetic environment. Measuring one and the same qubit with both setups allows a direct comparison. With the capacitive method about four times faster switching pulses and an increased visibility are achieved. Furthermore, the deliberate engineering of the electromagnetic environment, which minimizes the noise due to the bias circuit, is facilitated. Right at the degeneracy point the qubit coherence is limited by energy relaxation. We find two main noise contributions. White noise is limiting the energy relaxation and contributing to the dephasing far from the degeneracy point. 1/f-noise is the dominant source of dephasing in the direct vicinity of the optimal point. The influence of 1/f-noise is also supported by non-random beatings in the Ramsey and spin echo decay traces. Numeric simulations of a coupled qubit-oscillator system indicate that these beatings are due to the resonant interaction of the qubit with at least one point-like fluctuator, coupled especially strongly to the qubit.

cond-mat.supr-con↗
arXiv2008

Two-photon probe of the Jaynes-Cummings model and symmetry breaking in circuit QED

Superconducting qubits behave as artificial two-level atoms and are used to investigate fundamental quantum phenomena. In this context, the study of multi-photon excitations occupies a central role. Moreover, coupling superconducting qubits to on-chip microwave resonators has given rise to the field of circuit QED. In contrast to quantum-optical cavity QED, circuit QED offers the tunability inherent to solid-state circuits. In this work, we report on the observation of key signatures of a two-photon driven Jaynes-Cummings model, which unveils the upconversion dynamics of a superconducting flux qubit coupled to an on-chip resonator. Our experiment and theoretical analysis show clear evidence for the coexistence of one- and two-photon driven level anticrossings of the qubit-resonator system. This results from the symmetry breaking of the system Hamiltonian, when parity becomes a not well-defined property. Our study provides deep insight into the interplay of multiphoton processes and symmetries in a qubit-resonator system.

cond-mat.supr-con↗
arXiv2006

Quantum non-demolition measurement of a superconducting two-level system

In quantum mechanics, the process of measurement is a subtle interplay between extraction of information and disturbance of the state of the quantum system. A quantum non-demolition (QND) measurement minimizes this disturbance by using a particular system - detector interaction which preserves the eigenstates of a suitable operator of the quantum system. This leads to an ideal projective measurement. We present experiments in which we perform two consecutive measurements on a quantum two -level system, a superconducting flux qubit, by probing the hysteretic behaviour of a coupled nonlinear resonator. The large correlation between the results of the two measurements demonstrates the QND nature of the readout method. The fact that a QND measurement is possible for superconducting qubits strengthens the notion that these fabricated mesoscopic systems are to be regarded as fundamental quantum objects. Our results are also relevant for quantum information processing, where projective measurements are used for protocols like state preparation and error correction.

cond-mat.supr-con↗
arXiv2006

Development of a Time Projection Chamber Using Gas Electron Multipliers (GEM-TPC)

We developed a prototype time projection chamber using gas electron multipliers (GEM-TPC) for high energy heavy ion collision experiments. To investigate its performance, we conducted a beam test with 3 kinds of gases (Ar(90%)-CH4(10%), Ar(70%)-C2H6(30%) and CF4). Detection efficiency of 99%, and spatial resolution of 79 $μ$m in the pad-row direction and 313 $μ$m in the drift direction were achieved. The test results show that the GEM-TPC meets the requirements for high energy heavy ion collision experiments. The configuration and performance of the GEM-TPC are described.

physics.ins-det↗
arXiv2006

Dephasing of a superconducting flux qubit

In order to gain a better understanding of the origin of decoherence in superconducting flux qubits, we have measured the magnetic field dependence of the characteristic energy relaxation time ($T_1$) and echo phase relaxation time ($T_2^{\rm echo}$) near the optimal operating point of a flux qubit. We have measured $T_2^{\rm echo}$ by means of the phase cycling method. At the optimal point, we found the relation $T_2^{\rm echo}\approx 2T_1$. This means that the echo decay time is {\it limited by the energy relaxation} ($T_1$ process). Moving away from the optimal point, we observe a {\it linear} increase of the phase relaxation rate ($1/T_{2}^{\rm echo}$) with the applied external magnetic flux. This behavior can be well explained by the influence of magnetic flux noise with a $1/f$ spectrum on the qubit.

cond-mat.supr-con↗
arXiv2006

Fabrication and properties of MgB2/AlOx/MgB2 tunnel junctions

Sandwich-type MgB2 Josephson tunnel junctions (MgB2/AlOx/MgB2) have been fabricated using as-grown MgB2 films formed by molecular beam epitaxy. The junctions exhibited substantial supercurrent and a well-defined superconducting gap (D=2.2~2.3mV). The superconducting gap voltage (D) agrees well with those of the smaller gap in the multi-gap scenario. The IcRN product is 0.4-1.3 mV at 4.2K, but approaches to 2.0 mV at 50 mK. The Ic has peculiar temperature dependence far from the Ambegaokar-Baratoff formula. It rapidly decreases with temperature, and disappears above T = 20 K, which is much lower than the gap closing temperature. Interface microstructure between AlOx and MgB2 were investigated using cross-sectional transmission electron microscopy to clarify the problems in our tunnel junctions. There are poor-crystalline MgB2 layers and/or amorphous Mg-B composite layers of a few nanometers between AlOx barrier and the upper MgB2 layer. The poor-crystalline upper Mg-B layers seem to behave as normal metal or deteriorated superconducting layers, which may be the principal reason for all non-idealities of our MgB2/AlOx/MgB2 junctions.

cond-mat.supr-con↗
arXiv2005

Vacuum Rabi oscillations in a macroscopic superconducting qubit LC oscillator system

We have observed the coherent exchange of a single energy quantum between a flux qubit and a superconducting LC circuit acting as a quantum harmonic oscillator. The exchange of an energy quantum is known as the vacuum Rabi oscillations: the qubit is oscillating between the excited state and the ground state and the oscillator between the vacuum state and the first excited state. We have also obtained evidence of level quantization of the LC circuit by observing the change in the oscillation frequency when the LC circuit was not initially in the vacuum state.

cond-mat.supr-con↗
arXiv2005

Parametric control of a superconducting flux qubit

Parametric control of a superconducting flux qubit has been achieved by using two-frequency microwave pulses. We have observed Rabi oscillations stemming from parametric transitions between the qubit states when the sum of the two microwave frequencies or the difference between them matches the qubit Larmor frequency. We have also observed multi-photon Rabi oscillations corresponding to one- to four-photon resonances by applying single-frequency microwave pulses. The parametric control demonstrated in this work widens the frequency range of microwaves for controlling the qubit and offers a high quality testing ground for exploring nonlinear quantum phenomena.

cond-mat.mes-hall↗
arXiv2005

A Hadron Blind Detector for the PHENIX Experiment at RHIC

A Hadron Blind Detector (HBD) is being developed for the PHENIX experiment at RHIC. It consists of a Cherenkov radiator operated with pure CF4 directly coupled in a windowless configuration to a triple-GEM detector element with a CsI photocathode and pad readout. The HBD operates in the bandwidth 6-11.5 eV(110-200 nm). We studied the detector response to minimum ionizing particles and to electrons. We present measurements of the CsI quantum efficiency, which are in very good agreement with previously published results over the bandwidth 6-8.3 eV and extend them up to 10.3 eV. Discharge probability andaging studies of the GEMs and the CsI photocathode in pure CF4 are presented.

physics.ins-det↗
arXiv2004

All-MgB2 Josephson tunnel junctions

Sandwich-type all-MgB2 Josephson tunnel junctions (MgB2/AlOx/MgB2) have been fabricated for the first time with as-grown MgB2 films formed by molecular beam epitaxy. The junctions exhibit substantial superconducting current (IcRN product ~ 0.8 mV at 4.2K), a well-defined superconducting gap (delta = ~2.3 mV), and clear Fraunhofer patterns. The superconducting gap voltage of delta agrees well with the smaller gap in the multi-gap scenario. The results demonstrate that MgB2 has great promise for superconducting electronics that can be operated at T ~ 20 K.

cond-mat.supr-con↗
arXiv2004

A theoretical analysis of flux-qubit measurements with a dc-SQUID

The readout process of a superconducting flux-qubit is theoretically analyzed in terms of the quantum dynamics of a qubit-SQUID coupled system during measurement. The quantity directly observed by the measurement is the switching current (Isw) of the dc-SQUID placed around the qubit ring. In order to clarify the relation between the Isw and the qubit state, we calculated the time evolution of the density operator of the qubit-SQUID system while increasing the SQUID bias current until switching events occur and obtained the switching current distributions. This clarifies what information of the qubit is obtained by a dc-SQUID switching current measurement under specific conditions, for example, when the qubit eigenstate is a superposition of two different flux states.

cond-mat.supr-con↗
arXiv2004

Multiphoton transitions in a macroscopic quantum two-state system

We have observed multiphoton transitions between two macroscopic quantum-mechanical superposition states formed by two opposite circulating currents in a superconducting loop with three Josephson junctions. Resonant peaks and dips of up to three-photon transitions were observed in spectroscopic measurements when the system was irradiated with a strong RF-photon field. The widths of the multiphoton absorption dips are shown to scale with the Bessel functions in agreement with theoretical predictions derived from the Bloch equation or from a spin-boson model.

cond-mat.mes-hall↗