arXiv subjects

S. Shiraiwa

Publications and source records attributed to S. Shiraiwa.

4 recordsLinked to original sources

arXiv2025

Analysis of RF Sheath-Driven Tungsten Erosion at RF Antenna in the WEST Tokamak

This study applies the newly developed STRIPE (Simulated Transport of RF Impurity Production and Emission) framework to interpret tungsten (W) erosion at RF antenna structures in the WEST tokamak. STRIPE integrates SolEdge3x for edge plasma backgrounds, COMSOL for 3D RF sheath potentials, RustBCA for sputtering yields, and GITR for impurity transport and ion energy-angle distributions. In contrast to prior work by Kumar et al. 2025 Nucl. Fusion 65, 076039, which focused on framework validation for WEST ICRH discharge 57877, the present study provides a spatially resolved analysis of gross W erosion at both Q2 antenna limiters under ohmic and ICRH conditions. Using 2D SolEdge3x profiles in COMSOL, STRIPE captures rectified sheath potentials exceeding 300 V, leading to strong upper-limiter localization. Both poloidal and toroidal asymmetries are observed and attributed to RF sheath effects, with modeled erosion patterns deviating from experiment - highlighting sensitivity to sheath geometry and plasma resolution. High-charge-state oxygen ions (O6+-O8+) dominate erosion, while D+ contributes negligibly. A plasma composition of 1 percent oxygen and 98 percent deuterium is assumed. STRIPE predicts a 30-fold increase in gross W erosion from ohmic to ICRH phases, consistent with W-I 400.9 nm brightness measurements. Agreement within 5 percent (ohmic) and 30 percent (ICRH) demonstrates predictive capability and supports STRIPE's application in reactor-scale antenna design.

physics.plasm-ph↗

arXiv2024

Integrated modeling of RF-Induced Tungsten Erosion at ICRH Antenna Structures in the WEST Tokamak

This paper introduces STRIPE (Simulated Transport of RF Impurity Production and Emission), an advanced modeling framework designed to analyze material erosion and the global transport of eroded impurities originating from radio-frequency (RF) antenna structures in magnetic confinement fusion devices. STRIPE integrates multiple computational tools, each addressing different levels of physics fidelity: SolEdge3x for scrape-off-layer plasma profiles, COMSOL for 3D RF rectified voltage fields, RustBCA code for erosion yields and surface interactions, and GITR for 3D ion energy-angle distributions and global impurity transport. The framework is applied to an ion cyclotron RF heated, L-mode discharge #57877 in the WEST Tokamak, where it predicts a tenfold increase in tungsten erosion at RF antenna limiters under RF-sheath rectification conditions, compared to cases with only a thermal sheath. Highly charged oxygen ions (O6+ and higher) emerge as dominant contributors to tungsten sputtering at the antenna limiters. To verify model accuracy, a synthetic diagnostic tool based on inverse photon efficiency or S/XB coefficients from the ColRadPy-collisional radiative model enables direct comparisons between simulation results and experimental spectroscopic data. Model predictions, assuming plasma composition of 1% oxygen and 99% deuterium, align closely with measured neutral tungsten (W-I) spectroscopic data for the discharge #57877, validating the framework's accuracy. Currently, the STRIPE framework is being extended to investigate plasma-material interactions in other RF-heated linear and toroidal devices, offering valuable insights for RF antenna design, impurity control, and performance optimization in future fusion reactors.

physics.plasm-ph↗

arXiv2020

Scalability Analysis of Direct and Iterative Solvers Used to Model Charging of Non-insulated Superconducting Pancake Solenoids

A mathematical model for the charging simulation of non-insulated superconducting pancake solenoids is presented. Numerical solutions are obtained by the simulation model implemented on the Petra-M FEM platform using a variety of solvers. A scalability analysis is performed for both direct and preconditioned iterative solvers for four different pancakes solenoids with a varying number of turns and mesh elements. It is found that even with two extremely different time scales in the system an iterative solver combination (FGMRES-GMRES) in conjunction with the parallel Auxiliary Space Maxwell Solver (AMS) preconditioner outperforms a parallelized direct solver (MUMPS). In general, the computational time of the iterative solver is found to increase with the number of turns in the solenoids and/or the conductivity assumed for the superconducting material.

physics.comp-ph↗

arXiv2004

Ion acceleration during internal magnetic reconnection events in TST-2

Characteristics of ion acceleration in the internal magnetic reconnection events (IRE) have been studied by means of a neutral particle energy analyzer (NPA) in Tokyo Spherical Tokamak (TST-2). The major and minor radii are 0.38 m and 0.25m, respectively. The magnetic field strength is 0.3T and the maximum plasma current is up to 140 kA. The electron and ion temperatures are 0.4-0.5 keV and 0.1 keV, respectively and the electron density is ~1x1019 m-3. The NPA can be scanned toroidally from q = 74° (cw) to q = 114° (ccw), where q = 90° corresponds to the perpendicular sightline. The direction of the plasma current is cw. The NPA signals are digitized at every 50 ms. The NPA is calibrated in the energy range of 0.1 keV < E < 8.4 keV. When the IRE occurs, it is observed that the plasma current increases by ~ 20% and the loop voltage drops from 0.6 V to-5 V for ~ 0.1 ms. The enhanced charge exchange flux is observed by more than one order of magnitude at ~ 1 keV for this reconnection phase. The ion temperature increases by 80 eV at IREs. The angle q dependence of increment of Ti shows that DTi (q = 74°) is higher than that for q = 114°. This observation suggests that an ion is accelerated initially in the direction of magnetic field lines. The time evolution of the ion distribution function is simulated with a Fokker-Planck code taking into account the electric field effects.

physics.plasm-ph↗