arXiv subjects

S. V. Shitov

Publications and source records attributed to S. V. Shitov.

10 recordsLinked to original sources

arXiv2024

Coplanar waveguide ground potentials imbalance as a source of useful signal in Near-Field Scanning Microwave Microscopy

Various techniques are available in order to obtain information on samples of a different nature in near-field scanning microwave microscopy (NSMM), with transmission-line resonator (TLR) techniques considered as the most advanced in terms of sensitivity and resolution. In this paper, we focus on development of a TLR-based NSMM supplied by a new source of useful signal: coplanar waveguide ground potentials imbalance. Electromagnetic modeling of the device and experimental scanning of two planar structures are conducted to examine the performance of the proposed technique. Both modeling and experimental results demonstrate the ability to distinguish symmetric inhomogeneity positions with respect to the central conductor of the coplanar waveguide by the phase of imbalance signal. The thin-film structure scanning procedure displays the possibility of proposed approach to resolve low-contrast structures with accuracy up to 98.7 %.

cond-mat.supr-con↗

arXiv2019

Microwave impedance readout of a hafnium microbridge detector

We present proof-of-operation for a new method of electron thermometry using microwave impedance of a hafnium micro-absorber. The new method leads to an ultimate THz-range detector suitable for microwave readout and frequency division multiplexing. The sensing part of the device is a hot-electron-gas absorber responding to the incident radiation by variation of its impedance measured at probing frequency about 1.5 GHz. The absorber is a microbridge made from hafnium (Tc = 375 mK, RN = 30 Ohm) sized 2.5 um by 2.5 um by 50 nm and integrated with a planar 600-700 GHz antenna placed near the open end of a quarter-wave CPW resonator (Q-factor about 10^4). All elements of the circuit, except the microbridge, are made from 100-nm thick Nb, including the resonator, which is weakly coupled to a throughput line. The device was tested at 50-350 mK smoothly responding with its transmission coefficient S21 to applied microwave power at the resonance frequency. We have found that the power absorbed by the bridge fits to the model of hot electron gas, P=k(Te^n-Tph^n) (n = 5...6). The idle NEP down to about 10^-18 W/Hz^(-1/2) and the corresponding cross-over temperature for photon background about 5 K are estimated from the measured data. The saturation power of about 1 pW and possibility of moderate gain are anticipated for a practicable device operating at temperature 200 mK. Since the optimum readout frequency is found exactly at the resonance, the detector is insensitive to most phase instabilities at the probing frequency.

physics.ins-det↗

arXiv2017

Superconducting noise bolometer with microwave bias and readout for array applications

We present a superconducting noise bolometer for terahertz radiation, which is suitable for large-format arrays. It is based on an antenna-coupled superconducting micro-bridge embedded in a high-quality factor superconducting resonator for a microwave bias and readout with frequency-division multiplexing in the GHz range. The micro-bridge is kept below its critical temperature and biased with a microwave current of slightly lower amplitude than the critical current of the micro-bridge. The response of the detector is the rate of superconducting fluctuations, which depends exponentially on the concentration of quasiparticles in the micro-bridge. Excess quasiparticles are generated by an incident THz signal. Since the quasiparticle lifetime increases exponentially at lower operation temperature, the noise equivalent power rapidly decreases. This approach allows for large arrays of noise bolometers operating above 1 K with sensitivity, limited by 300-K background noise. Moreover, the response of the bolometer always dominates the noise of the readout due to relatively large amplitude of the bias current. We performed a feasibility study on a proof-of-concept device with a ${1.0\times 0.5 \rm μm^{2}}$ micro-bridge from a 9-nm thin Nb film on a sapphire substrate. Having a critical temperature of 5.8 K, it operates at 4.2 K and is biased at the frequency 5.6 GHz. For the quasioptical input at 0.65 THz, we measured the noise equivalent power ${\approx 3\times 10^{-12}\rm W/\sqrt Hz}$ , which is close to expectations for this particular device in the noise-response regime.

physics.ins-det↗

arXiv2014

Design and experimental study of superconducting left-handed transmission lines with tunable dispersion and improved impedance match

We continue detailed study of microwave properties of a superconducting left-handed tunable CPW transmission line (LHTL). The line consists of a central conductor, loaded with series of Josephson junctions as fixed inductors; the line is shunted with SQUIDs as tunable inductors. The inductance of the SQUIDs is varied in the range of 0.08-0.5 nH by applying an external dc magnetic field. The circuit is designed to have left- and right-handed transmission bands separated by a variable rejection band. At zero magnetic field, we observed only one pass-band between 8 and 10 GHz within the frequency range of 8-12 GHz. The rejection band is anticipated to appear between 10 GHz and 11 GHz by design, and it has been detected in our previous work. To solve the problem of standing waves and RF leak in measurements of our experimental 20-cell LHTL, we have designed a high-ratio (5-50 Ohm) wideband (8-11 GHz) impedance transformer integrated at the chip, along with improved sample holder. The experimental data are compared with numerical simulations.

cond-mat.supr-con↗

arXiv2014

Nonreciprocal transmission of microwaves through a long Josephson junction

Nonreciprocal microwave transmission through a long Josephson junction in the flux-flow regime is studied analytically and numerically within the framework of the perturbed sine-Gordon model. We demonstrate that the maximum attenuation of the transmitted power occurs when the direction of the flux flow is opposite to the direction of the microwave propagation. This attenuation is nonreciprocal with respect to the flux-flow direction and can be enhanced by increasing the system length and proper impedance matching of the junction ends to external transmission line.

cond-mat.supr-con↗

arXiv2014

Wide-Range Bolometer with RF Readout TES

To improve both scalability and noise-filtering capability of a Transition-Edge Sensor (TES), a new concept of a thin-film detector is suggested, which is based on embedding a microbridge TES into a high-Q planar GHz range resonator weakly coupled to a 50 Ohm-readout transmission line. Such a TES element is designed as a hot-electron microbolometer coupled to a THz range antenna and as a load of the resonator at the same time. A weak THz signal coupled to the antenna heats the microbridge TES, thus reducing the quality factor of the resonator and leading to a power increment in the readout line. The power-to-power conversion gain, an essential figure of merit, is estimated to be above 10. To demonstrate the basic concept, we fabricated and tested a few submicron sized devices from Nb thin films for operation temperature about 5 K. The dc and rf characterization of the new device is made at a resonator frequency about 5.8 GHz. A low-noise HEMT amplifier is used in our TES experiments without the need for a SQUID readout. The optical sensitivity to blackbody radiation within the frequency band 600-700 GHz is measured as $\sim3\times 10^{-14} \textrm W/\sqrt{\textrm Hz}$ at Tc {\approx} 5 K at bath temperature ~ 1.5 K.

physics.ins-det↗

arXiv2014

Superconducting hot-electron nanobolometer with microwave bias and readout

We propose a new detection technique based on radio-frequency (RF) bias and readout of an antenna-coupled superconducting nanobolometer. This approach is suitable for Frequency-Division-Multiplexing (FDM) readout of large arrays using broadband low-noise RF amplifier. We call this new detector RFTES. This feasibility study was made on demonstrator devices which are made in all-Nb technology and operate at 4.2 K. The studied RFTES devices consist of an antenna-coupled superconducting nanobolometer made of ultrathin niobium films with transition temperature Tc = 5.2 K. The 0.65-THz antenna and nanobolometer are embedded as a load into a GHz-range coplanar niobium resonator (Tc = 8.9 K, Q = 4000). To heat the superconducting Nb nanobolometer close to the Tc, the RF power at resonator frequency f = 5.8 GHz is applied via a transmission line which is weakly coupled (-11 dB) to the loaded resonator. The THz-antenna of RFTES was placed in the focus of a sapphire immersion lens inside a He4-cryostat equipped with an optical window and a semiconductor RF amplifier. We have demonstrated optical response of the RFTES to THz radiation. The demonstrator receiver system employing the RFTES device showed an optical Noise-Equivalent Power (NEP) 1e-14 W/sqrt(Hz) at 4.2 K.

physics.ins-det↗

arXiv2013

Design and experimental study of superconducting left-handed transmission lines with tunable dispersion

We study microwave properties of a superconducting tunable coplanar waveguide (CPW). Pairs of Josephson junctions are forming superconducting quantum interference devices (SQUIDs), which shunt the central conductor of the CPW. The Josephson inductance of the SQUIDs is varied in the range of 0.08-0.5 nH by applying an external dc magnetic field. The central conductor of the CPW contains Josephson junctions connected in series that provide extra inductances; the magnetic field controlling the SQUIDs is weak enough not to influence the inductance of the chain of the single junctions. The circuit is designed to have left- and right-handed transmission properties separated by a variable rejection band; the band edges can be tuned by the magnetic field. We present transmission measurements on CPWs based on up to 120 Nb-AlOx-Nb Josephson junctions. At zero magnetic field, we observed no rejection band in the frequency range of 8-11 GHz. When applying the magnetic field, a rejection band between 7 GHz and 9 GHz appears. The experimental data are compared with numerical simulations.

cond-mat.supr-con↗

arXiv2013

Ultra-compact tunable split-ring resonators

We propose tunable superconducting split-ring resonators (SRRs) employing nonlinear Josephson inductance. A fraction of SRR is replaced by Nb-AlOx-Nb Josephson tunnel junctions connected in parallel and forming a superconducting quantum interference device (SQUID), whose inductance is sensitive to the external dc magnetic field. Due to the lumped nature of the Josephson inductance, the SRR can be made very compact and its resonance frequency can be tuned by applying magnetic field. We present the model, results of extensive EM-simulation and experimental data for the SRR weakly coupled to a transmission line within frequency range 11-13 GHz.

cond-mat.supr-con↗

arXiv2008

Novel Regime of Operation for Superconducting Quantum Interference Filters

A new operating regime of the Superconducting Quantum Interference Filter (SQIF) is investigated. The voltage to magnetic field response function, V(H), is determined by a Fraunhofer dependence of the critical current and magnetic flux focusing effect in Josephson junctions (F-mode). For SQIF-arrays made of high-Tc superconducting bicrystal Josephson junctions the F-mode plays a predominant role in the voltage-field response V(H). The relatively large superconducting loops of the SQIF are used for inductive coupling to the external input circuit. It is shown that the output noise of a SQIF-array measured with a cooled amplifier in the 1-2 GHz range is determined by the slope of the V(H) characteristic. Power gain and saturation power were evaluated using low frequency SQIF parameters. Finally, we consider the influence of the spread in the parameters of Josephson junctions in the SQIF-array on the V(H) characteristic of the whole structure.

cond-mat.supr-con↗