arXiv subjects

S. Virostek

Publications and source records attributed to S. Virostek.

3 recordsLinked to original sources

arXiv2019

RF design of APEX2 two-cell continuous-wave normal conducting photoelectron gun cavity based on multi-objective genetic algorithm

High brightness, high repetition rate electron beams are key components for optimizing the performance of next generation scientific instruments, such as MHz-class X-ray Free Electron Laser (XFEL) and Ultra-fast Electron Diffraction/Microscopy (UED/UEM). In the Advanced Photo-injector EXperiment (APEX) at Berkeley Lab, a photoelectron gun based on a 185.7 MHz normal conducting re-entrant RF cavity, has been proven to be a feasible solution to provide high brightness, high repetition rate electron beam for both XFEL and UED/UEM. Based on the success of APEX, a new electron gun system, named APEX2, has been under development to further improve the electron beam brightness. For APEX2, we have designed a new 162.5 MHz two-cell photoelectron gun and achieved a significant increase on the cathode launching field and the beam exit energy. For a fixed charge per bunch, these improvements will allow for the emittance reduction and hence an increased beam brightness. The design of APEX2 gun cavity is a complex problem with multiple design goals and restrictions, some even competing each other. For a systematic and comprehensive search for the optimized cavity geometry, we have developed and implemented a novel optimization method based on the Multi-Objective Genetic Algorithm (MOGA).

physics.acc-ph↗

arXiv2013

Assembly and Installation of the Daya Bay Antineutrino Detectors

The Daya Bay reactor antineutrino experiment is designed to make a precision measurement of the neutrino mixing angle theta13, and recently made the definitive discovery of its nonzero value. It utilizes a set of eight, functionally identical antineutrino detectors to measure the reactor flux and spectrum at baselines of 300 - 2000m from the Daya Bay and Ling Ao Nuclear Power Plants. The Daya Bay antineutrino detectors were built in an above-ground facility and deployed side-by-side at three underground experimental sites near and far from the nuclear reactors. This configuration allows the experiment to make a precision measurement of reactor antineutrino disappearance over km-long baselines and reduces relative systematic uncertainties between detectors and nuclear reactors. This paper describes the assembly and installation of the Daya Bay antineutrino detectors.

physics.ins-det↗

arXiv2000

Analysis of Thermally Induced Frequency Shift for the Spallation Neutron Source RFQ

The Spallation Neutron Source (SNS) Front-End Systems Group at Lawrence Berkeley National Lab (LBNL) is developing a Radio Frequency Quadrupole (RFQ) to accelerate an H- beam from 65 keV to 2.5 MeV at the operating frequency of 402.5 MHz. The 4 section, 3.7 meter long RFQ is a 4 vane structure operating at 6% duty factor. The cavity walls are made from OFE Copper with a GlidCop outer layer to add mechanical strength. A set of 12 cooling channels in the RFQ cavity walls are fed and controlled separately from 4 channels embedded in the vanes. An ANSYS finite-element model has been developed to calculate the deformed shape of the cavity for given RF heat loads and cooling water temperatures. By combining the FEA results with a SUPERFISH RF cavity simulation, the relative shift in frequency for a given change in coolant temperature or heat load can be predicted. The calculated cavity frequency sensitivity is -33 kHz per 1 degC change in vane water temperature with constant-temperature wall water. The system start-up transient was also studied using the previously mentioned FEA model. By controlling the RF power ramp rate and the independent wall and vane cooling circuit temperatures, the system turn-on time can be minimized while limiting the frequency shift.

physics.acc-ph↗