arXiv subjects
Publications and source records attributed to S. Werkema.
We explore the feasibility of a next-generation Mu2e experiment that uses Project-X beams to achieve a sensitivity approximately a factor ten better than the currently planned Mu2e facility.
A proposal to search for direct μ-->e conversion at Fermilab requires slow, resonant extraction of an intense proton beam. Large space charge forces will present challenges, partly due to the substantial betatron tune spread. The main challenges will be maintaining a uniform spill profile and moderate losses at the septum. We propose to use "radio frequency knockout" (RFKO) for fine tuning the extraction. Strategies for the use of the RFKO method will be discussed here in the context of the Mu2e experiment. The feasibility of this method has been demonstrated in simulations.
The current design of beam preparation for a proposed mu->e conversion experiment at Fermilab is based on slow resonant extraction of protons from the Debuncher. The Debuncher ring will have to operate with beam intensities of 3 x 10**12 particles, approximately four orders of magnitude larger than its current value. The most challenging requirements on the beam quality are the spill uniformity and low losses in the presence of large space charge and momentum spread. We present results from simulations of third integer resonance extraction assisted by RF knock-out (RFKO), a technique developed for medical accelerators. Tune spreads up to 0.05 have been considered.
We present new precision measurements of the psi(2S) total and partial widths from excitation curves obtained in antiproton-proton annihilations by Fermilab experiment E835 at the Antiproton Accumulator in the year 2000. A new technique of complementary scans was developed to study narrow resonances with stochastically cooled antiproton beams. The technique relies on precise revolution-frequency and orbit-length measurements, while making the analysis of the excitation curve almost independent of machine lattice parameters. We study the psi(2S) meson through the processes pbar p -> e+ e- and pbar p -> J/psi + X -> e+ e- + X. We measure the width to be Gamma = 290 +- 25(sta) +- 4(sys) keV and the combination of partial widths Gamma_e+e- * Gamma_pbarp / Gamma = 579 +- 38(sta) +- 36(sys) meV, which represent the most precise measurements to date.
We have measured several branching ratios for $ψ^\prime$ decay using the data collected by FNAL E835 experiment during year 2000, obtaining ${\cal B}(ψ^\prime \to e^+ e^-) = 0.0068\pm0.0001\pm0.0004$, ${\cal B}(ψ^\prime \to J/ψπ^+ π^-) = 0.292\pm0.005\pm0.018$, ${\cal B}(ψ^\prime \to J/ψπ^0 π^0) = 0.167\pm0.005\pm0.014$ and ${\cal B}(ψ^\prime \to J/ψη) = 0.028\pm0.002\pm0.002$. We also present a measurement of the dipion mass distribution in the decays $ψ^\prime \to J/ψππ$.
This document is the second in a series of reports on the exciting physics that would be accessible at Fermilab in the event of an upgraded proton source. Where the first report covered a broad range of topics, this report focuses specifically on three areas of study: there are brief discussions on the new measurements one could make in both the neutron and anti-proton sectors, and then a detailed discussion of what could be achieved in the neutrino oscillation sector using an upgraded proton source to supply the NuMI beamline with more protons. If one places a new detector optimized for $ν_e$ appearance at a new location slightly off the axis defined by the MINOS experiment, that new experiment would be ideal for making the next important steps in lepton flavor studies, namely, the search for $ν_μ\to ν_e$ at the atmospheric mass splitting, and CP violations. The report concludes with a summary of proton economics and demands for increased proton intensity for the Booster and Main Injector: what the proton source at Fermilab can currently supply, and what adiabatic changes could be implemented to boost the proton supply on the way from here to a proton driver upgrade.