arXiv subjects

Samith Abeywickrama

Publications and source records attributed to Samith Abeywickrama.

11 recordsLinked to original sources

arXiv2021

Channel Estimation for Intelligent Reflecting Surface Assisted Backscatter Communication

Intelligent reflecting surface (IRS) is a promising technology to improve the performance of backscatter communication systems by smartly reconfiguring the multi-reflection channel. To fully exploit the passive beamforming gain of IRS in backscatter communication, channel state information (CSI) is indispensable but more practically challenging to acquire than conventional IRS-assisted systems, since IRS passively reflects signals over both the forward and backward (backscattering) links between the reader and tag. To address this issue, we propose in this letter a new and efficient channel estimation scheme for the IRS-assisted backscatter communication system. To minimize the mean-square error (MSE) of channel estimation, we formulate and solve an optimization problem by designing the IRS training reflection matrix for channel estimation under the constraints of unit-modulus elements and full rank. Simulation results verify the effectiveness of the proposed channel estimation scheme as compared to other baseline schemes.

cs.IT↗

arXiv2020

Refined Nonlinear Rectenna Modeling and Optimal Waveform Design for Multi-User Multi-Antenna Wireless Power Transfer

In this paper, we study the optimal waveform design for wireless power transfer (WPT) from a multi-antenna energy transmitter (ET) to multiple single-antenna energy receivers (ERs) simultaneously in multi-path frequency-selective channels. First, we propose a refined nonlinear current-voltage model of the diode in the ER rectifier, and accordingly derive new expressions for the output direct current (DC) voltage and corresponding harvested power at the ER. Leveraging this new rectenna model, we first consider the single-ER case and study the multisine-based power waveform design based on the wireless channel to maximize the harvested power at the ER. We propose two efficient algorithms for finding high-quality suboptimal solutions to this non-convex optimization problem. Next, we extend our formulated waveform design problem to the general multi-ER case for maximizing the weighted sum of the harvested powers by all ERs, and propose an efficient difference-of-convex functions programming (DCP)-based algorithm for solving this problem. Finally, we demonstrate the superior performance of our proposed waveform designs based on the new rectenna model over existing schemes/models via simulations.

cs.IT↗

arXiv2020

Intelligent Reflecting Surface: Practical Phase Shift Model and Beamforming Optimization

Intelligent reflecting surface (IRS) that enables the control of the wireless propagation environment has been looked upon as a promising technology for boosting the spectrum and energy efficiency in future wireless communication systems. Prior works on IRS are mainly based on the ideal phase shift model assuming the full signal reflection by each of the elements regardless of its phase shift, which, however, is practically difficult to realize. In contrast, we propose in this paper a practical phase shift model that captures the phase-dependent amplitude variation in the element-wise reflection coefficient. Applying this new model to an IRS-aided wireless system, we formulate a problem to maximize its achievable rate by jointly optimizing the transmit beamforming and the IRS reflect beamforming. The formulated problem is non-convex and difficult to be optimally solved in general, for which we propose a low-complexity suboptimal solution based on the alternating optimization (AO) technique. Simulation results unveil a substantial performance gain achieved by the joint beamforming optimization based on the proposed phase shift model as compared to the conventional ideal model.

eess.SP↗

arXiv2020

Intelligent Reflecting Surface: Practical Phase Shift Model and Beamforming Optimization

Intelligent reflecting surface (IRS) that enables the control of wireless propagation environment has recently emerged as a promising cost-effective technology for boosting the spectrum and energy efficiency in future wireless communication systems. Prior works on IRS are mainly based on the ideal phase shift model assuming the full signal reflection by each of the elements regardless of its phase shift, which, however, is practically difficult to realize. In contrast, we propose in this paper the practical phase shift model that captures the phase-dependent amplitude variation in the element-wise reflection coefficient. Based on the proposed model and considering an IRS-aided multiuser system with an IRS deployed to assist in the downlink communications from a multi-antenna access point (AP) to multiple single-antenna users, we formulate an optimization problem to minimize the total transmit power at the AP by jointly designing the AP transmit beamforming and the IRS reflect beamforming, subject to the users' individual signal-to-interference-plus-noise ratio (SINR) constraints. Iterative algorithms are proposed to find suboptimal solutions to this problem efficiently by utilizing the alternating optimization (AO) or penalty-based optimization technique. Moreover, we analyze the asymptotic performance loss of the IRS-aided system that employs practical phase shifters but assumes the ideal phase shift model for beamforming optimization, as the number of IRS elements goes to infinity. Simulation results unveil substantial performance gains achieved by the proposed beamforming optimization based on the practical phase shift model as compared to the conventional ideal model.

cs.IT↗

arXiv2019

Opportunistic Wireless Energy Beamforming using RSSI Feedback

This paper proposes a novel channel estimation method, and a cluster-based opportunistic scheduling policy, that enhances the efficiency of wireless energy transfer in a system consisting of multiple energy receivers (ERs). Firstly, in the training stage, the energy transmitter (ET) obtains a set of RSSI feedback values from all ERs, and these values are used to estimate the channels between the ET and all ERs. Next, based on the channel estimates, the ERs are grouped into clusters, and the cluster that has its members closest to its centroid in phase is picked. This cluster will be given priority, and the beamformer that maximizes the minimum harvested energy among all ERs in the selected cluster is found by solving a convex optimization problem. This beamformer is used to transfer energy to the ERs using maximum ratio transmit beamforming. All ERs have the same chance of being selected regardless of their distances from the ET, and hence, this scheduling policy can be considered to be opportunistic as well as fair. It is shown that the proposed method achieves significant performance gains.

cs.IT↗

arXiv2018

RF-Based Direction Finding of UAVs Using DNN

This paper presents a sparse denoising autoencoder (SDAE)-based deep neural network (DNN) for the direction finding (DF) of small unmanned aerial vehicles (UAVs). It is motivated by the practical challenges associated with classical DF algorithms such as MUSIC and ESPRIT. The proposed DF scheme is practical and low-complex in the sense that a phase synchronization mechanism, an antenna calibration mechanism, and the analytical model of the antenna radiation pattern are not essential. Also, the proposed DF method can be implemented using a single-channel RF receiver. The paper validates the proposed method experimentally as well.

eess.SP↗

arXiv2018

Cluster-based Wireless Energy Transfer for Low Complex Energy Receivers

This paper proposes a novel channel estimation method and a cluster-based opportunistic scheduling policy, for a wireless energy transfer (WET) system consisting of multiple low-complex energy receivers (ERs) with limited processing capabilities. Firstly, in the training stage, the energy transmitter (ET) obtains a set of Received Signal Strength Indicator (RSSI) feedback values from all ERs, and these values are used to estimate the channels between the ET and all ERs. Next, based on the channel estimates, the ERs are grouped into clusters, and the cluster that has its members closest to its centroid in phase is selected for dedicated WET. The beamformer that maximizes the minimum harvested energy among all ERs in the selected cluster is found by solving a convex optimization problem. All ERs have the same chance of being selected regardless of their distances from the ET, and hence, this scheduling policy can be considered to be opportunistic as well as fair. It is shown that the proposed method achieves significant performance gains over benchmark schemes.

cs.IT↗

arXiv2018

Wireless Energy Transfer to a Pair of Energy Receivers using Signal Strength Feedback

This paper focuses on wireless energy transfer (WET) to a pair of low complex energy receivers (ER), by only utilizing received signal strength indicator (RSSI) values that are fed back from the ERs to the energy transmitter (ET). Selecting the beamformer that maximizes the total average energy transfer between the ET and the ERs, while satisfying a minimum harvested energy criterion at each ER, is studied. This is a nonconvex constrained optimization problem which is difficult to solve analytically. Also, any analytical solution to the problem should only consists of parameters that the ET knows, or the ET can estimate, as utilizing only RSSI feedback values for channel estimation prohibits estimating some channel parameters. Thus, the paper focuses on obtaining a suboptimal solution analytically. It is proven that if the channels between the ET and the ERs satisfy a certain sufficient condition, this solution is in fact optimal. Simulations show that the optimality gap is negligibly small as well. Insights into a system with more than two ERs are also presented. To this end, it is highlighted that if the number of ERs is large enough, it is possible to always find a pair of ERs satisfying the sufficient condition, and hence, a pairwise scheduling policy that does not violate optimality can be used for the WET.

cs.IT↗

arXiv2018

Over-the-Air Implementation of Uplink NOMA

Though the concept of non-orthogonal multiple access (NOMA) was proposed several years ago, the performance of uplink NOMA has only been verified in theory, but not in practice. This paper presents an over-the-air implementation of a uplink NOMA system, while providing solutions to most common practical problems, i.e., carrier frequency offset (CFO) synchronization, time synchronization, and channel estimation. The implemented CFO synchronization method adopts the primary synchronization signal (PSS) of LTE. Also, we design a novel preamble for each uplink user, and it is appended to every frame before it is transmitted through the air. This preamble will be used for time synchronization and channel estimation at the BS. Also, a low-complexity, iterative linear minimum mean squared error (LMMSE) detector has been implemented for multi-user decoding. The paper also validates the proposed architecture numerically, as well as experimentally.

cs.NI↗

arXiv2017

Wireless Energy Beamforming Using Signal Strength Feedback

Multiple antenna techniques, that allow energy beamforming, have been looked upon as a possible candidate for increasing the efficiency of the transfer process between the energy transmitter (ET) and the energy receiver (ER) in wireless energy transfer. This paper introduces a novel scheme that facilitates energy beamforming by utilizing Received Signal Strength Indicator (RSSI) values to estimate the channel. Firstly, in the training stage, the ET will transmit sequentially using each beamforming vector in a codebook, which is pre-defined using a Cramer-Rao lower bound analysis. The RSSI value corresponding to each beamforming vector is fed back to the ET, and these values are used to estimate the channel through a maximum likelihood analysis. The results that are obtained are remarkably simple, requires minimal processing, and can be easily implemented. Also, the results are general and hold for all well known fading models. The paper also validates the analytical results numerically, as well as experimentally, and it is shown that the proposed method achieves impressive results in wireless energy transfer.

eess.SP↗

arXiv2017

Wireless Energy Beamforming using Received Signal Strength Indicator Feedback

Multiple antenna techniques that allow energy beamforming have been looked upon as a possible candidate for increasing the transfer efficiency between the energy transmitter (ET) and the energy receiver (ER) in wireless power transfer. This paper introduces a novel scheme that facilitates energy beamforming by utilizing Received Signal Strength Indicator (RSSI) values to estimate the channel. Firstly, in the training stage, the ET will transmit using each beamforming vector in a codebook, which is pre-defined using a Cramer-Rao lower bound analysis. RSSI value corresponding to each beamforming vector is fed back to the ET, and these values are used to estimate the channel through a maximum likelihood analysis. The results that are obtained are remarkably simple, requires minimal processing, and can be easily implemented. The paper also validates the analytical results numerically, as well as experimentally, and it is shown that the proposed method achieves impressive results.

cs.IT↗