arXiv subjects

Sanyam Bajaj

Publications and source records attributed to Sanyam Bajaj.

11 recordsLinked to original sources

arXiv2019

Lateral Heterojunction BaTiO3/AlGaN Diodes with >8MV/cm Breakdown Field

In this paper, we report enhanced breakdown characteristics of Pt/BaTiO3/Al0.58Ga0.42N lateral heterojunction diodes compared to Pt/Al0.58Ga0.42N Schottky diodes. BaTiO3, an extreme dielectric constant material, has been used, in this study, as dielectric material under the anode to significantly reduce the peak electric field at the anode edge of the heterojunction diode such that the observed average breakdown field was higher than 8 MV/cm, achieved for devices with anode to cathode spacing less than 0.2 microns. Control Schottky anode devices (Pt/Al0.58Ga0.42N) fabricated on the same sample displayed an average breakdown field around 4 MV/cm for devices with similar dimensions. While both breakdown fields are significantly higher than those exhibited by incumbent technologies such as GaN-based devices, BaTiO3 can enable more effective utilization of the higher breakdown fields available in ultra-wide bandgap materials by proper electric field management. This demonstration thus lays the groundwork needed to realize ultra-scaled lateral devices with significantly improved breakdown characteristics.

physics.app-ph↗

arXiv2019

Compositionally graded contact layers for MOCVD grown high Al-content AlGaN transistors

In this letter, we design and demonstrate an improved MOCVD grown reverse Al-composition graded contact layer to achieve low resistance contact to MOCVD grown ultra-wide bandgap (UWBG) Al0.70Ga0.30N channel metal semiconductor field-effect transistors (MESFETs). Increasing the thickness of the reverse graded layer was found to improve contact layer resistance significantly, leading to contact resistance of 3.3x10^-5 Ohm.cm2. Devices with gate length, LG, of 0.6 microns and source-drain spacing, LSD, of 1.5 microns displayed a maximum current density, IDSMAX, of 635 mA/mm with an applied gate voltage, VGS, of +2 V. Breakdown measurements on transistors with gate to drain spacing, LGD, of 770 nm had breakdown voltage greater than 220 , corresponding to minimum breakdown field of 2.86 MV/cm. This work provides a framework for the design of low resistance contacts to MOCVD grown high Al-content AlxGa1-xN channel transistors.

physics.app-ph↗

arXiv2018

High Mobility 2DEG in modulation-doped \b{eta}-(AlxGa1-x)2O3/Ga2O3 heterostructures

Beta-phase Ga2O3 has emerged as a promising candidate for a wide range of device applications, including power electronic devices, radio-frequency devices and solar-blind photodetectors. The wide bandgap energy and the predicted high breakdown field, together with the availability of low-cost native substrates, make \b{eta}-Ga2O3 a promising material compared to other conventional wide bandgap materials, such as GaN and SiC. Alloying of Al with \b{eta}-Ga2O3 could enable even larger band gap materials, and provide more flexibility for electronic and optoelectronic device design. In this work, we demonstrate a high mobility two-dimensional electron gas (2DEG) formed at the \b{eta}-(AlxGa1-x)2O3/Ga2O3 interface through modulation doping. Shubnikov-de Haas oscillation was observed for the first time in the modulation-doped \b{eta}-(AlxGa1-x)2O3/Ga2O3 structure, indicating a high-quality channel formed at the heterojunction interface. The formation of the 2DEG channel was further confirmed by a weak temperature-dependence of the carrier density, and the peak low temperature mobility was found to be 2790 cm2/Vs, which is significantly higher than can be achieved in bulk-doped \b{eta}-Ga2O3. The demonstrated modulation-doped \b{eta}-(AlxGa1-x)2O3/Ga2O3 structure lays the foundation for future exploration of quantum physical phenomena as well as new semiconductor device technologies based on the \b{eta}-Ga2O3 material system.

cond-mat.mtrl-sci↗

arXiv2017

Tunnel-injected sub-260 nm ultraviolet light emitting diodes

We report on tunnel-injected deep ultraviolet light emitting diodes (UV LEDs) configured with a polarization engineered Al0.75Ga0.25N/ In0.2Ga0.8N tunnel junction structure. Tunnel-injected UV LED structure enables n-type contacts for both bottom and top contact layers. However, achieving Ohmic contact to wide bandgap n-AlGaN layers is challenging and typically requires high temperature contact metal annealing. In this work, we adopted a compositionally graded top contact layer for non-alloyed metal contact, and obtained a low contact resistance of Rc=4.8x10-5 Ohm cm2 on n-Al0.75Ga0.25N. We also observed a significant reduction in the forward operation voltage from 30.9 V to 19.2 V at 1 kA/cm2 by increasing the Mg doping concentration from 6.2x1018 cm-3 to 1.5x1019 cm-3. Non-equilibrium hole injection into wide bandgap Al0.75Ga0.25N with Eg>5.2 eV was confirmed by light emission at 257 nm. This work demonstrates the feasibility of tunneling hole injection into deep UV LEDs, and provides a novel structural design towards high power deep-UV emitters.

cond-mat.mtrl-sci↗

arXiv2017

Delta-doped Beta- Gallium Oxide Field Effect Transistor

We report silicon delta doping in Gallium Oxide (\b{eta}-Ga2O3) grown by plasma assisted molecular beam epitaxy using a shutter pulsing technique. We describe growth procedures that can be used to realize high Si incorporation in an oxidizing oxygen plasma environment. Delta doping was used to realize thin (12 nm) low-resistance layers with sheet resistance of 320 Ohm/square (mobility of 83 cm^2/Vs, integrated sheet charge of 2.4x10^14 cm^-2). A single delta-doped sheet of carriers was employed as a channel to realize a field effect transistor with current ID,MAX =292 mA/mm and transconductance gM = 27 mS/mm.

cond-mat.mes-hall↗

arXiv2016

AlGaN Channel Field Effect Transistors with Graded Heterostructure Ohmic Contacts

We report on ultra-wide bandgap (UWBG) Al0.75Ga0.25N channel metal-insulator-semiconductor field-effect transistors (MISFET) with heterostructure engineered low-resistance ohmic contacts. The low intrinsic electron affinity of AlN (0.6 eV) leads to large Schottky barriers at metal-AlGaN interface, resulting in highly resistive ohmic contacts. In this work, we use reverse compositional graded n++ AlGaN contact layer to achieve upward electron affinity grading, leading to a low specific contact resistance of 1.9x10-6 ohm.cm2 to n-Al0.75Ga0.25N channels (bandgap ~ 5.3 eV) with non-alloyed contacts. We also demonstrate UWBG Al0.75Ga0.25N channel MISFET device operation employing compositional graded n++ ohmic contact layer and 20 nm atomic layer deposited Al2O3 as the gate-dielectric.

cond-mat.mes-hall↗

arXiv2016

Phonon lasing as a likely mechanism for density-dependent velocity saturation in GaN transistors

We show that density-dependent velocity saturation in a GaN High Electron Mobility Transistor (HEMT) can be related to the stimulated emission of longitudinal optical (LO) phonons. As the drift velocity of electrons increases, the drift of the Fermi distribution in reciprocal space produces population inversion and gain for the LO phonons. Once this gain reaches a threshold value, the avalanche-like increase of LO emission causes a rapid loss of electron energy and momentum and leads to drift velocity saturation. Our simple model correctly predicts both the general trend of the saturation velocity decreasing with increasing electron density and the values of saturation velocity measured in our experiments.

cond-mat.mes-hall↗

arXiv2015

Simulation of Enhancement Mode GaN HEMTs with Threshold > 5 V using P-type Buffer

A high threshold voltage enhancement-mode GaN HEMT with p-type doped buffer is discussed and simulated. Analytical expressions are derived to explain the role of buffer capacitance in designing and enhancing threshold voltage. Simulations of the proposed device with p-type buffer show threshold voltages above 5 V, and a positive shift in threshold voltage as the oxide capacitance is reduced, thus enabling threshold voltage tunability over an unprecedented range for GaN-based HEMTs. The electric field profiles, breakdown performance, on-resistance and delay tradeoffs in the proposed pGaN back HEMT device are also discussed.

physics.ins-det↗

arXiv2015

Density-Dependent Electron Transport and Precise Modeling of GaN HEMTs

We report on the direct measurement of two-dimensional sheet charge density dependence of electron transport in AlGaN/GaN high electron mobility transistors. Pulsed IV measurements established increasing electron velocities with decreasing sheet charge densities, resulting in saturation velocity of 1.9 x 10^7 cm/s at a low sheet charge density of 7.8 x 10^11 cm-2. A new optical phonon emission-based electron velocity model for GaN is also presented. It accommodates stimulated LO phonon emission which clamps the electron velocity with strong electron-phonon interaction and long LO phonon lifetime in GaN. A comparison with the measured density-dependent saturation velocity shows that it captures the dependence rather well. Finally, the experimental result is applied in TCAD-based device simulator to predict DC and small signal characteristics of a reported GaN HEMT. Good agreement between the simulated and reported experimental results validated the measurement presented in this report and established accurate modeling of GaN HEMTs.

cond-mat.mtrl-sci↗

arXiv2014

Modeling of High Composition AlGaN Channel HEMTs with Large Threshold Voltage

We report on the potential of high electron mobility transistors (HEMTs) consisting of high composition AlGaN channel and barrier layers for power switching applications. Detailed 2D simulations show that threshold voltages in excess of 3 V can be achieved through the use of AlGaN channel layers. We also calculate the two-dimensional electron gas (2DEG) mobility in AlGaN channel HEMTs and evaluate their power figures of merit as a function of device operating temperature and Al mole fraction in the channel. Our models show that power switching transistors with AlGaN channels would have comparable on-resistance to GaN-channel based transistors for the same operation voltage. The modeling in this paper shows the potential of high composition AlGaN as a channel material for future high threshold enhancement mode transistors.

cond-mat.mtrl-sci↗

arXiv2011

Electrical Properties of Atomic Layer Deposited Aluminum Oxide on Gallium Nitride

We report on our investigation of the electrical properties of metal/Al2O3/GaN metal-insulator-semiconductor (MIS) capacitors. We determined the conduction band offset and interface charge density of the alumina/GaN interface by analyzing capacitance-voltage characteristics of atomic layer deposited Al2O3 films on GaN substrates. The conduction band offset at the Al2O3/GaN interface was calculated to be 2.13 eV, in agreement with theoretical predications. A non-zero field of 0.93 MV/cm in the oxide under flat-band conditions in the GaN was inferred, which we attribute to a fixed net positive charge density of magnitude 4.60x1012 cm-2 at the Al2O3/GaN interface. We provide hypotheses to explain the origin of this charge by analyzing the energy band line-up.

cond-mat.mes-hall↗