SearcharxivSearch

arXiv subjects

Sarah-Jane Lock

Publications and source records attributed to Sarah-Jane Lock.

2 recordsLinked to original sources

Hybrid ensemble forecasting combining physics-based and machine-learning predictions through spectral nudging

We present the first application of spectral nudging in a probabilistic ensemble forecasting framework, combining the physics-based ECMWF Integrated Forecasting System ensemble (IFS-ENS) with forecasts from the probabilistic machine-learned AIFS-ENS ensemble. Large scales of virtual temperature and vorticity are relaxed toward the machine-learned forecasts, while mesoscale structures remain governed by the physics-based model. This hybrid ensemble shows substantial improvements in large-scale forecast skill, with gains in predictive skill extended by up to two days in the tropics and by approximately half a day in the extra-tropics relative to IFS-ENS. Despite nudging being applied only to upper-air fields, improvements are also found in several near-surface parameters. Tropical cyclone track forecasts improve significantly, consistent with improved representation of the large-scale steering flow, without degrading storm intensity or ensemble spread. These results demonstrate that spectral nudging can be successfully extended to ensemble prediction and provide an attractive pathway for combining machine-learned and physics-based weather prediction systems.

physics.ao-ph

Diagnostic vs dynamic representation of the inverse barometer effect in a global ocean model and its potential for probabilistic storm surge forecasting

The global ocean model NEMO is run in a series of stand-alone configurations (2015-2022) to investigate the potential for improving global medium-range storm surge forecasts by including the inverse barometer effect. The analysis focus on the residual water level, i.e. the water level variations not due to tides. Here, we compare a control experiment, where the inverse barometer effect was not included, against a run dynamically forced with mean sea level pressure. In the control experiment, the inverse barometer effect was then calculated diagnostically and added to the ocean model sea surface elevation, resulting in a total of three experiments to investigate. We compare against the global GESLA3 water level data set and find that the inclusion of the inverse barometer effect reduces the root-mean-square error by $\sim 1~cm$ on average. When we mask out all data where the observed residual water level is less than $\pm1$ or $\pm2$ standard deviations, including the inverse barometer effect reduces the RMS error by $4-5$ cm. While both methods reduce water level errors, there are regional differences in their performance. The run with dynamical pressure forcing is seen to perform slightly better than diagnostically adding the inverse barometer effect in enclosed basins such as the Baltic Sea. Finally, an ensemble forecast experiment with the Integrated Forecast System of the European Centre for Medium-range Weather Forecasts demonstrates that when the diagnostic inverse barometer effect is included for a severe storm surge event in the North Sea (Storm Xaver, December 2013), the ensemble spread of water level provides a stronger and earlier indication of the observed maximum surge level than the when the effect is excluded.

physics.ao-ph