SearcharxivSearch

arXiv subjects

Sebastiaan van der Tol

Publications and source records attributed to Sebastiaan van der Tol.

7 recordsLinked to original sources

Application of continuous corrections in widefield imaging obtained with the IDGCAL calibration method

Image Domain Gridding (IDG) is an efficient method to evaluate A-projection, a method for correcting for direction dependent effects (DDEs) in radio astronomical imaging. The corrections i.e. the A-terms need to be estimated from the observed data through calibration. IDG-CAL is a calibration algorithm that employs the IDG algorithm in an iterative fashion to estimate A-terms directly. Initial results for low order A-terms are promising, however for deeper images higher order A-terms are needed. Here two improvements to IDG-CAL are proposed to 1) reduce the computational cost of A-terms described by more parameters and 2) optimize the set of basis functions describing the A-terms based on a stochastic model of the gain variations and the model image.

astro-ph.IM

Direction-dependent calibration with image-domain gridding

Wide-field images made by radio interferometers are invariably affected by direction-dependent systematic effects such as the ionosphere or the beam pattern. Calibration along a set of discrete directions in the sky is the default technique to estimate and correct these systematic errors. However, additional processing such as smoothing and mosaicing are required to reconcile the step wise variation of the estimated systematic errors at the edges of the discrete directions (facets). We overcome the discrete nature of direction-dependent calibration by using image-domain gridding as the model for the calibration. Instead of discrete directions in the sky, calibration is performed using a basis that represents a set of sub-grids in the Fourier space. This automatically removes the need for extra operations to recover the wide-field systematics error model without any discontinuity. We provide results based on LOFAR data where we compare the traditional facet-based (discrete directional gains) calibration with the proposed approach. The comparison shows improved image quality, mainly because of the physical plausibility of the proposed approach as opposed to using a piecewise constant model for direction-dependent systematic errors.

astro-ph.IM

Image Domain Gridding: a fast method for convolutional resampling of visibilities

In radio astronomy obtaining a high dynamic range in synthesis imaging of wide fields requires a correction for time and direction-dependent effects. Applying direction-dependent correction can be done by either partitioning the image in facets and applying a direction-independent correction per facet, or by including the correction in the gridding kernel (AW-projection). An advantage of AW-projection over faceting is that the effectively applied beam is a sinc interpolation of the sampled beam, where the correction applied in the faceting approach is a discontinuous piece wise constant beam. However, AW-projection quickly becomes prohibitively expensive when the corrections vary over short time scales. This occurs for example when ionospheric effects are included in the correction. The cost of the frequent recomputation of the oversampled convolution kernels then dominates the total cost of gridding. Image domain gridding is a new approach that avoids the costly step of computing oversampled convolution kernels. Instead low-resolution images are made directly for small groups of visibilities which are then transformed and added to the large $uv$ grid. The computations have a simple, highly parallel structure that maps very well onto massively parallel hardware such as graphical processing units (GPUs). Despite being more expensive in pure computation count, the throughput is comparable to classical W-projection. The accuracy is close to classical gridding with a continuous convolution kernel. Compared to gridding methods that use a sampled convolution function, the new method is more accurate. Hence the new method is at least as fast and accurate as classical W-projection, while allowing for the correction for quickly varying direction-dependent effects.

astro-ph.IM

LOFAR: Recent imaging results & future prospects

The Low Frequency Array (LOFAR) is under construction in the Netherlands and in several surrounding European countries. In this contribution, we describe the layout and design of the telescope, with a particular emphasis on the imaging characteristics of the array when used in its "standard imaging" mode. After briefly reviewing the calibration and imaging software used for LOFAR image processing, we show some recent results from the ongoing imaging commissioning efforts. We conclude by summarizing future prospects for the use of LOFAR in observing the little-explored low frequency Universe.

astro-ph.CO

LOFAR: Early imaging results from commissioning for Cygnus A

The Low Frequency Array (LOFAR) will operate between 10 and 250 MHz, and will observe the low frequency Universe to an unprecedented sensitivity and angular resolution. The construction and commissioning of LOFAR is well underway, with over 27 of the Dutch stations and five International stations routinely performing both single-station and interferometric observations over the frequency range that LOFAR is anticipated to operate at. Here, we summarize the capabilities of LOFAR and report on some of the early commissioning imaging of Cygnus A.

astro-ph.CO

Progress with the LOFAR Imaging Pipeline

One of the science drivers of the new Low Frequency Array (LOFAR) is large-area surveys of the low-frequency radio sky. Realizing this goal requires automated processing of the interferometric data, such that fully calibrated images are produced by the system during survey operations. The LOFAR Imaging Pipeline is the tool intended for this purpose, and is now undergoing significant commissioning work. The pipeline is now functional as an automated processing chain. Here we present several recent LOFAR images that have been produced during the still ongoing commissioning period. These early LOFAR images are representative of some of the science goals of the commissioning team members.

astro-ph.IM

Calibration Challenges for Future Radio Telescopes

Instruments for radio astronomical observations have come a long way. While the first telescopes were based on very large dishes and 2-antenna interferometers, current instruments consist of dozens of steerable dishes, whereas future instruments will be even larger distributed sensor arrays with a hierarchy of phased array elements. For such arrays to provide meaningful output (images), accurate calibration is of critical importance. Calibration must solve for the unknown antenna gains and phases, as well as the unknown atmospheric and ionospheric disturbances. Future telescopes will have a large number of elements and a large field of view. In this case the parameters are strongly direction dependent, resulting in a large number of unknown parameters even if appropriately constrained physical or phenomenological descriptions are used. This makes calibration a daunting parameter estimation task, that is reviewed from a signal processing perspective in this article.

astro-ph.IM