arXiv subjects

Sebastian Sailler

Publications and source records attributed to Sebastian Sailler.

7 recordsLinked to original sources

arXiv2026

From Film to Flakes: Electronic Properties and Magnetization Variations in Yttrium Iron Garnet

Yttrium iron garnet (YIG) is a ferrimagnetic insulator valued for its high Curie temperature, very low magnetic damping, and ability to support long-range spin-wave transport. These qualities have established it as a cornerstone material in the field of spintronics and magnonics. Most studies on YIG so far have been focused on bulk crystals, thin films, and nanoparticles, including variants with substitutions at the yttrium or iron site. New morphologies such as sub-micron flakes have drawn interest recently as their geometry and mechanical flexibility might enable different device architectures. However, detailed investigations combining their electronic structure and magnetic behavior remain scarce. In this work, we present a comparative study of the electronic and magnetic properties of a bulk-like YIG film and a sub-micron-sized YIG flake. Our results highlight the distinct behavior that emerges in sub-micron dimensions and point toward future uses for flake-based YIG in compact spintronics devices.

cond-mat.mtrl-sci↗

arXiv2025

Statistical characterization of the spin Hall magnetoresistance in YIG/Pt heterostructures

The spin Hall magnetoresistance (SMR) is widely used to study the interplay between charge and spin currents in bilayers of a magnetic insulator and a normal metal. However, not much is known about the spatial variation of the SMR across the surface of one and the same sample. In this work, we investigate the statistical distribution of the SMR in hundreds of nominally identical Hall bar structures patterned into prototypical yttrium iron garnet (YIG)/Pt heterostructures. We find a Gaussian-distributed SMR with a narrow standard deviation of approximately 10$\,$% of the mean value in each YIG/Pt bilayer studied. However, the variation of the mean SMR between different YIG/Pt samples can be as large as ~30$\,$%, despite nominally identical fabrication conditions. This demonstrates that spatial variations of the SMR amplitude must not be neglected, in particular when comparing different heterostructures. On a microscopic level, local variations of the interface quality captured by the spin mixing conductance are the most likely origin for the observed SMR amplitude variations.

cond-mat.mtrl-sci↗

arXiv2025

Spin Hall magnetoresistance at the altermagnetic insulator/Pt interface

The resistance of a heavy metal can be modulated by an adjacent magnetic material through the combined effects of the spin Hall effect, inverse spin Hall effect, and dissipation of the spin accumulation at the interface. This phenomenon is known as the spin Hall magnetoresistance. The dissipation of the spin accumulation can occur via various mechanisms, with spin-transfer torque being the most extensively studied. In this work, we report the observation of spin Hall magnetoresistance at the interface between platinum and an insulating altermagnetic candidate, Ba$_2$CoGe$_2$O$_7$. Our findings reveal that this heterostructure exhibits a relatively large spin Hall magnetoresistance signal, which is anisotropic with respect to the crystal orientation of the current channel. We explore and rule out several potential explanations for this anisotropy and propose that our results may be understood in the context of the anisotropies of the spin current channels across the Pt/altermagnetic Ba$_2$CoGe$_2$O$_7$ interface.

cond-mat.mes-hall↗

arXiv2024

Competing Ordinary and Hanle Magnetoresistance in Pt and Ti Thin Films

One of the key elements in spintronics research is the spin Hall effect, allowing to generate spin currents from charge currents. A large spin Hall effect is observed in materials with strong spin orbit coupling, e.g., Pt. Recent research suggests the existence of an orbital Hall effect, the orbital analogue to the spin Hall effect, which also arises in weakly spin orbit coupled materials like Ti, Mn or Cr. In Pt both effects are predicted to coexist. In any of these materials, a magnetic field perpendicular to the spin or orbital accumulation leads to additional Hanle dephasing and thereby the Hanle magnetoresistance (MR). To reveal the MR behavior of a material with both spin and orbital Hall effect, we thus study the MR of Pt thin films over a wide range of thicknesses. Careful evaluation shows that the MR of our textured samples is dominated by the ordinary MR rather than by the Hanle effect. We analyze the intrinsic properties of Pt films deposited by different groups and show that next to the resistivity also the structural properties of the film influence which MR dominates. We further show that this correlation can be found in both spin Hall active materials like Pt and orbital Hall active materials, like Ti. For both materials, the crystalline samples shows a MR attributed to the ordinary MR, whereas we find a large Hanle MR for the samples without apparent structural order. We then provide a set of rules to distinguish between the ordinary and the Hanle MR. We conclude that in all materials with a spin or orbital Hall effect the Hanle MR and the ordinary MR coexist and the purity and crystallinity of the thin film determine the dominating effect.

cond-mat.mtrl-sci↗

arXiv2024

Observation of the anomalous Nernst effect in altermagnetic candidate Mn5Si3

The anomalous Nernst effect generates transverse voltage to the applied thermal gradient in magnetically ordered systems. The effect was previously considered excluded in compensated magnetic materials with collinear ordering. However, in the recently identified class of compensated magnetic materials, dubbed altermagnets, time-reversal symmetry breaking in the electronic band structure makes the presence of the anomalous Nernst effect possible despite the collinear spin arrangement. In this work, we investigate epitaxial Mn5Si3 thin films known to be an altermagnetic candidate. We show that the material manifests a sizable anomalous Nernst coefficient despite the small net magnetization of the films. The measured magnitudes of the anomalous Nernst coefficient reach a scale of microVolts per Kelvin. We support our magneto-thermoelectric measurements by density-functional theory calculations of the material's spin-split electronic structure, which allows for the finite Berry curvature in the reciprocal space. Furthermore, we present our calculations of the intrinsic Berry-curvature Nernst conductivity, which agree with our experimental observations.

cond-mat.mtrl-sci↗

arXiv2023

Lateral Solid Phase Epitaxy of Yttrium Iron Garnet

Solid phase epitaxy is a crystallization technique used to produce high quality thin films. Lateral solid phase epitaxy furthermore enables the realization of non-planar structures, which are interesting, e.g., in the field of spintronics. Here, we demonstrate lateral solid phase epitaxy of yttrium iron garnet over an artificial edge, such that the crystallization direction is perpendicular to the initial seed. We use single crystalline garnet seed substrates partially covered by a SiOx film to study the lateral crystallization over the SiOx mesa. The yttrium iron garnet layer retains the crystal orientation of the substrate not only when in direct contact with the substrate, but also across the edge on top of the SiOx mesa. By controlling the crystallization dynamics it is possible to almost completely suppress the formation of polycrystals and to enable epitaxial growth of single crystalline yttrium iron garnet on top of mesas made from arbitrary materials. From a series of annealing experiments, we extract an activation energy of 3.0 eV and a velocity prefactor of $6.5 \times 10^{14}$ nm/s for the lateral epitaxial crystallization along the <100> direction. Our results pave the way to engineer single crystalline non-planar yttrium iron garnet structures with controlled crystal orientation.

cond-mat.mtrl-sci↗

arXiv2023

Crystallization Dynamics of Amorphous Yttrium Iron Garnet Thin Films

Yttrium iron garnet (YIG) is a prototypical material in spintronics due to its exceptional magnetic properties. To exploit these properties high quality thin films need to be manufactured. Deposition techniques like sputter deposition or pulsed laser deposition at ambient temperature produce amorphous films, which need a post annealing step to induce crystallization. However, not much is known about the exact dynamics of the formation of crystalline YIG out of the amorphous phase. Here, we conduct extensive time and temperature series to study the crystallization behavior of YIG on various substrates and extract the crystallization velocities as well as the activation energies needed to promote crystallization. We find that the type of crystallization as well as the crystallization velocity depend on the lattice mismatch to the substrate. We compare the crystallization parameters found in literature with our results and find an excellent agreement with our model. Our results allow us to determine the time needed for the formation of a fully crystalline film of arbitrary thickness for any temperature.

cond-mat.mtrl-sci↗