arXiv subjects

Sergei A. Egorov

Publications and source records attributed to Sergei A. Egorov.

13 recordsLinked to original sources

arXiv2024

Evidence of sharp transitions between octahedral and capped trigonal prism states of the solvation shell of Fe$^{+3}$(aq)

The structure of the solvation shell of aqueous Fe$^{+3}$ ion has been a subject of controversy due to discrepancies between experiments and different levels of theory. We address this issue by performing simulations for a wide range of ion concentrations, using various empirical potential energy functions, as well as density functional theory calculations of selected configurations. The solvation shell undergoes abrupt transitions between two states: an octahedral (OH) state with 6-fold coordination, and a capped trigonal prism (CTP) state with 7-fold coordination. The lifetime of these states is concentration dependent. In dilute $\mathrm{FeCl_3}$ solutions, the lifetime of the two states is similar ($\approx 1$ ns). However, the lifetime of the OH state increases with ion concentration, while that of the CTP state decreases slightly. When a uniform negative background charge is used instead of explicit counterions, the lifetime of the OH state is greatly overestimated. These findings underscore the need for further experimental measurements as well as high-level simulations over sufficiently long timescales and low concentration.

physics.chem-ph↗

arXiv2023

Rugotaxis: Droplet motion without external energy supply

Nano-patterned substrates offer possibilities for controlling the motion of fluids without external energy supply in novel technologies in microfluidics, coatings, etc. Here, we report on the rugotaxial motion of droplets on wrinkled substrates with gradient in the wavelength of the wrinkles by exploring a broad range of parameters, such as amplitude of the wrinkles, substrate wettability, droplet size and wavelength gradient. Adopting a theoretical and molecular dynamics approach, we determine the Cassie-Baxter and Wenzel states of the droplets, investigate the efficiency of rugotaxis as a function of different parameters, and discuss additional effects, such as pinning. We find that shallow wrinkles characterised by small wavelength gradients, and moderate adhesion of the droplet to the substrate favour the rugotaxis motion with growing droplet size, when pinning is avoided. We also find that the driving force in rugotaxis is the gain in interfacial energy between the droplet and the substrate as the droplet enters regions of denser wrinkles (smaller wavelengths of the wrinkles).

physics.flu-dyn↗

arXiv2023

Unidirectional Droplet Propulsion onto Gradient Brushes without External Energy Supply

Using extensive molecular dynamics simulation of a coarse-grained model, we demonstrate the possibility of sustained unidirectional motion (durotaxis) of droplets without external energy supply when placed on a polymer brush substrate with stiffness gradient in a certain direction. The governing key parameters for the specific substrate design studied, which determine the durotaxis efficiency, are found to be the grafting density of the brush and the droplet adhesion to the brush surface, whereas the strength of the stiffness gradient, the viscosity of the droplet, or the length of the polymer chains of the brush have only a minor effect on the process. It is shown that this durotaxial motion is driven by the steady increase of the interfacial energy between droplet and brush as the droplet moves from softer to stiffer parts of the substrate whereby the mean driving force gradually declines with decreasing roughness of the brush surface. We anticipate that our findings indicate further possibilities in the area of nanoscale motion without external energy supply.

physics.flu-dyn↗

arXiv2021

Macroscopic rotation of active colloids in a colloid-polymer mixture confined inside a spherical cavity

From studies via Molecular Dynamics simulations, we report results on structure and dynamics in mixtures of active colloids and passive polymers that are confined inside a spherical container with a repulsive boundary. Such systems mimic the presence of bacteria in the background of bio-polymers. All interactions in the fully passive case are chosen in such a way that in equilibrium coexistence between colloid-rich and polymer-rich phases occurs. For most part of the studies the chosen compositions give rise to Janus structure; one side of the sphere is occupied by the colloids and the rest by the polymers. This partially wet situation mimics nearly a neutral wall in the fully passive scenario. Following the introduction of a velocity-aligning activity to the colloids, the shape of the polymer-rich domain changes to that of an ellipsoid, around the long axis of which the colloid-rich domain attains a macroscopic angular momentum. In the steady state, the orientation of this axis evolves via diffusion, implying that the passive domain is set into motion as well by the active particles.

cond-mat.soft↗

arXiv2021

Wetting transitions of polymer solutions: Effects of chain length and chain stiffness

Wetting and drying phenomena are studied for flexible and semiflexible polymer solutions via coarse-grained molecular dynamics simulations and density functional theory calculations. The study is based on the use of Young's equation for the contact angle, determining all relevant surface tensions from the anisotropy of the pressure tensor. The solvent quality (or effective temperature, equivalently) is varied systematically, while all other interactions remain unaltered. For flexible polymers, the wetting transition temperature $T_{\rm w}$ increases monotonically with chain length $N$, while the contact angle at temperatures far below $T_{\rm w}$ is independent of $N$. For semiflexible polymer solutions, $T_{\rm w}$ varies non-monotonically with the persistence length: Initially, $T_{\rm w}$ increases with increasing chain stiffness and reaches a maximum, but then a sudden drop of $T_{\rm w}$ is observed, which is associated with the isotropic-nematic transition of the system.

cond-mat.soft↗

arXiv2020

Entropic Unmixing in Nematic Blends of Semiflexible Polymers

Binary mixtures of semiflexible polymers with the same chain length but different persistence lengths separate into two coexisting different nematic phases when the osmotic pressure of the lyotropic solution is varied. Molecular Dynamics simulations and Density Functional Theory predict phase diagrams either with a triple point, where the isotropic phase coexists with two nematic phases, or a critical point of unmixing within the nematic mixture. The difference in locally preferred bond angles between the constituents drives this unmixing without any attractive interactions between monomers.

cond-mat.soft↗

arXiv2020

When does Wenzel's extension of Young's equation for the contact angle of droplets apply? A density functional study

he contact angle of a liquid droplet on a surface under partial wetting conditions differs for a nanoscopically rough or periodically corrugated surface from its value for a perfectly flat surface. Wenzel's relation attributes this difference simply to the geometric magnification of the surface area (by a factor $r_{\rm w}$), but the validity of this idea is controversial. We elucidate this problem by model calculations for a sinusoidal corrugation of the form $z_{\rm wall}(y) = Δ\cos(2πy/λ)$ , for a potential of short range $σ_{\rm w}$ acting from the wall on the fluid particles. When the vapor phase is an ideal gas, the change of the wall-vapor surface tension can be computed exactly, and corrections to Wenzel's equation are typically of order $σ_{\rm w}Δ/λ^2$. For fixed $r_{\rm w}$ and fixed $σ_{\rm w}$ the approach to Wenzel's result with increasing $λ$ may be nonmonotonic and this limit often is only reached for $λ/σ_{\rm w}>30$. For a non-additive binary mixture, density functional theory is used to work out the density profiles of both coexisting phases both for planar and corrugated walls, as well as the corresponding surface tensions. Again, deviations from Wenzel's results of similar magnitude as in the above ideal gas case are predicted. Finally, a crudely simplified description based on the interface Hamiltonian concept is used to interpret corresponding simulation results along similar lines. Wenzel's approach is found to generally hold when $λ/σ_{\rm w}\gg 1$, $Δ/λ<1$, and conditions avoiding proximity of wetting or filling transitions.

cond-mat.soft↗

arXiv2019

Phase behavior of flexible and semiflexible polymers in solvents of varying quality

The interplay of nematic order and phase separation in solutions of semiflexible polymers in solvents of variable quality is investigated by density functional theory (DFT) and molecular dynamics (MD) simulations. We studied coarse-grained models, with a bond-angle potential to control chain stiffness, for chain lengths comparable to the persistence length of the chains. We varied both the density of the monomeric units and the effective temperature that controls the quality of the implicit solvent. For very stiff chains only a single transition from an isotropic fluid to a nematic is found, with a phase diagram of "swan-neck" topology. For less stiff chains, however, also unmixing between isotropic fluids of different concentration, ending in a critical point, occurs for temperatures above a triple point. The associated critical behavior is examined in the MD simulations and found compatible with Ising universality. Apart from this critical behavior, DFT calculations agree qualitatively with the MD simulations.

cond-mat.soft↗

arXiv2018

Do the contact angle and line tension of surface-attached droplets depend on the radius of curvature?

Results from Monte Carlo simulations of wall-attached droplets in the three-dimensional Ising lattice gas model and in a symmetric binary Lennard-Jones fluid, confined by antisymmetric walls, are analyzed, with the aim to estimate the dependence of the contact angle $(Θ)$ on the droplet radius $(R)$ of curvature. Sphere-cap shape of the wall-attached droplets is assumed throughout. An approach, based purely on "thermodynamic" observables, e.g., chemical potential, excess density due to the droplet, etc., is used, to avoid ambiguities in the decision which particles belong (or do not belong, respectively) to the droplet. It is found that the results are compatible with a variation $[Θ(R)-Θ_{\infty}] \propto 1/R$, $Θ_{\infty}$ being the contact angle in the thermodynamic limit ($R=\infty$). The possibility to use such results to estimate the excess free energy related to the contact line of the droplet, namely the line tension, at the wall, is discussed. Various problems that hamper this approach and were not fully recognized in previous attempts to extract the line tension are identified. It is also found that the dependence of wall tensions on the difference of chemical potential of the droplet from that at the bulk coexistence provides effectively a change of the contact angle of similar magnitude. The simulation approach yields precise estimates for the excess density due to wall-attached droplets and the corresponding free energy excess, relative to a system without a droplet at the same chemical potential. It is shown that this information suffices to estimate nucleation barriers, not affected by ambiguities on droplet shape, contact angle and line tension.

cond-mat.soft↗

arXiv2016

Semiflexible Polymers Under Good Solvent Conditions Interacting With Repulsive Walls

Solutions of semiflexible polymers confined by repulsive planar walls are studied by density functional theory and Molecular Dynamics simulations, to clarify the competition between the chain alignment favored by the wall and the depletion caused by the monomer-wall repulsion. A coarse-grained bead-spring model with bond bending potential is studied, varying both the contour length and the persistence length of the polymers, as well as the monomer concentration in the solution (good solvent conditions are assumed throughout, and solvent molecules are not included explicitly). The profiles of monomer density and pressure tensor components near the wall are studied, and the surface tension of the solution is obtained. While the surface tension slightly decreases with chain length for flexible polymers, it clearly increases with chain length for stiff polymers. Thus, at fixed density and fixed chain length the surface tension also increases with increasing persistence length. Chain ends always are enriched near the wall, but this effect is much larger for stiff polymers than for flexible ones. Also the profiles of the mean square gyration radius components near the wall and the nematic order parameter are studied to clarify the conditions where wall-induced nematic order occurs.

cond-mat.soft↗

arXiv2016

Anomalous fluctuations of nematic order in solutions of semiflexible polymers

The nematic ordering in semiflexible polymers with contour length $L$ exceeding their persistence length $\ell_p$ is described by a confinement of the polymers in a cylinder of radius $r_{eff}$ much larger than the radius $r_ρ$, expected from the respective concentration of the solution. Large scale Molecular Dynamics simulations combined with Density Functional Theory are used to locate the Isotropic-Nematic ($I-N$)-transition and to validate this cylindrical confinement. Anomalous fluctuations, due to chain deflections from neighboring chains in the nematic phase are proposed. Considering deflections as collective excitations in the nematically ordered phase of semiflexible polymers elucidates the origins of shortcomings in the description of the $I-N$ transition by existing theories.

cond-mat.soft↗

arXiv2010

Spherical Polymer Brushes Under Good Solvent Conditions: Molecular Dynamics Results Compared to Density Functional Theory

A coarse grained model for flexible polymers end-grafted to repulsive spherical nanoparticles is studied for various chain lengths and grafting densities under good solvent conditions, by Molecular Dynamics methods and density functional theory. With increasing chain length the monomer density profile exhibits a crossover to the star polymer limit. The distribution of polymer ends and the linear dimensions of individual polymer chains are obtained, while the inhomogeneous stretching of the chains is characterized by the local persistence lengths. The results on the structure factor of both single chain and full spherical brush as well as the range of applicability of the different theoretical tools are presented. Eventually an outlook on experiments is given.

cond-mat.soft↗

arXiv2010

Structural and Dynamical Anomalies of a Gaussian Core Fluid: a Mode Coupling Theory Study

We present a theoretical study of transport properties of a liquid comprised of particles uist1:/home/sokrates/egorov/oldhome/Pap41/Submit > m abs.tex We present a theoretical study of transport properties of a liquid comprised of particles interacting via Gaussian Core pair potential. Shear viscosity and self-diffusion coefficient are computed on the basis of the mode-coupling theory, with required structural input obtained from integral equation theory. Both self-diffusion coefficient and viscosity display anomalous density dependence, with diffusivity increasing and viscosity decreasing with density within a particular density range along several isotherms below a certain temperature. Our theoretical results for both transport coefficients are in good agreement with the simulation data.

cond-mat.soft↗