arXiv subjects

Serhiy Cherevko

Publications and source records attributed to Serhiy Cherevko.

3 recordsLinked to original sources

arXiv2026

Fe3O4 nano-octahedra and SnO2 nanorods modifying low-Pd amount electrocatalysts for alkaline direct ethanol fuel cells

This work describes the ethanol oxidation reaction (EOR) in alkaline medium using low-palladium nanoparticle electrocatalysts modified by Fe3O4 nano-octahedra and SnO2 nanorods. Operation studies on an alkaline direct ethanol fuel cell (ADEFC) were conducted using the developed electrocatalysts, and stability studies were performed using the advanced scanning flow cell (SFC) technique coupled to inductively coupled plasma mass spectrometry (online SFC-ICP-MS). The EOR was catalyzed by single (Pd/C and commercial Pd/C Alfa Aesar) and by synthesized binary and ternary electrocatalysts, in which Fe3O4 and SnO2 nanostructures partially replaced the high-cost noble metal. The PdFe3O4/C was identified as the most promising synthesized material in the electrochemical studies, exhibiting the highest mass activity (1426 mA mg-1 Pd) by cyclic voltammetry (CV), followed by the binary PdSnO2/C (1135 mA mg-1 Pd), and by the ternary (1074 mA mg-1 Pd). This enhancement was attributed to the bifunctional mechanism enabled by Fe3O4 and SnO2, therefore reducing poisoning and improving the EOR. Moreover, the operating results revealed that PdFe3O4/C showed the highest power density among the synthesized materials (31 mW cm-2 at 70 C), even with an approximately 45 percent reduction in Pd content compared to the commercial catalyst. XPS results showed that the Pd 3d5/2 and 3d3/2 peaks for PdFe3O4/C, PdSnO2/C, and PdFe3O4SnO2/C were shifted by approximately 0.5 eV to higher binding energies compared to Pd/C, indicating a loss of electron density in Pd due to strong metal-oxide interactions.

cond-mat.mtrl-sci↗

arXiv2026

Stability of Supported Pd-based Ethanol Oxidation Reaction Electrocatalysts in Alkaline Media

This study evaluates the dissolution of the supported electrocatalysts Pd/C, PdSn/C, PdNb/C, and PdFe3O4/C during ethanol oxidation reaction for ADLFC applications. A scanning flow cell (SFC) coupled to an inductively coupled mass spectrometry (online ICP-MS) is used to assess the dissolution stability in a broad potential window. Accelerated stress tests with and without ethanol are developed using a rotating disk electrode (RDE) with dissolution products analysis by ex-situ ICP-MS. Potential profiles simulating those experienced by the catalyst during regular fuel cell operation were used. Sn and Fe catalysts demonstrate improved activity and stability compared with the material with Pd alone. For these reasons, PdSn/C and PdFe3O4/C are suitable for ADLFC applications. Severe Nb dissolution destabilizes Pd, increasing its leaching. This work demonstrates that while additional metals and oxides can improve the alcohol oxidation kinetics of Pd, these additives' dissolution stability must already be considered at the catalyst design stage.

cond-mat.mtrl-sci↗

arXiv2021

Different Photostability of BiVO4 in Near-pH-Neutral Electrolytes

Photoelectrochemical water splitting is a promising route to produce hydrogen from solar energy. However, corrosion of semiconducting photoelectrodes remains a fundamental challenge for their practical application. The stability of BiVO4, one of the best performing photoanode materials, is systematically examined here using an illuminated scanning flow cell to measure its dissolution operando. The dissolution rates of BiVO4 under illumination depend on the electrolyte and decrease in the order: borate (pH=9.3) > phosphate (pH=7.2) > citrate (pH=7.0). BiVO4 exhibits an inherent lack of stability during the oxygen evolution reaction (OER), while hole-scavenging citrate electrolyte offers kinetic protection. The dissolution of Bi peaks at different potentials than the dissolution of V in phosphate buffer, whereas both ions dissolve simultaneously in borate buffer. The life cycle of a 90 nm BiVO4 film is monitored during one hour of light-driven OER in borate buffer. The photocurrent and dissolution rates show independent trends with time, highlighting the importance to measure both quantities operando. Dissolution rates are correlated to the surface morphology and chemistry characterized using electron microscopy, X-ray photoelectron spectroscopy and atom probe tomography. These correlative measurements further the understanding on corrosion processes of photoelectrodes down to the nanoscopic scale to facilitate their future developments.

cond-mat.mtrl-sci↗