SearcharxivSearch

arXiv subjects

Seung-Bo Shim

Publications and source records attributed to Seung-Bo Shim.

10 recordsLinked to original sources

On-chip superconducting GHz RF reflectometry of the capacitance response in bilayer graphene

In dual-gated bilayer graphene, a perpendicular displacement field opens a band gap that modifies both the channel conductance and the electronic compressibility, motivating measurements that resolve resistive and capacitive responses on the same device. We integrate an hBN-encapsulated bilayer graphene heterostructure with an on-chip superconducting Nb lumped-element LC resonator and carry out RF reflectometry near 4.25 GHz. DC transport and finite-bias spectroscopy on the same device provide a transport reference. Top and bottom gates independently set the carrier density and displacement field. The DC and RF gate maps share the same gate-dependent features, with finite-bias measurements revealing a region of suppressed conductance whose bias extent grows with the displacement field, consistent with a field-induced gap. The gate-dependent resonance-frequency shift is converted to the effective capacitance seen by the resonator using an equivalent-circuit model. The capacitance shows a minimum near the conductance-suppressed region, consistent with reduced electronic compressibility in the gapped bilayer graphene, and exhibits an electron-hole asymmetry. The on-chip configuration probes the gate-dependent admittance of a dual-gated van der Waals heterostructure, providing capacitance-sensitive information that complements DC transport within a single device.

cond-mat.mes-hall

Evidence for unexpectedly low quasiparticle generation rates across Josephson junctions of driven superconducting qubits

Recent studies find that even drives far below the superconducting gap frequency may cause drive-induced quasiparticle generation (QPG) across Josephson junctions (JJs) of superconducting qubits (SCQs), posing a serious concern for fault-tolerant superconducting quantum computing (FTSQC). Nonetheless, quantitative experimental estimation on QPG rates has remained vague. Here, we investigate QPG using strongly driven SCQs, reaching qubit drive amplitudes up to $2\pi\times$300 GHz by applying intense drive fields through the readout resonators. The resonator nonlinear responses enable quantification of the energy loss at SCQs, including the contribution from QPG. Surprisingly, the estimated total energy loss rates are far lower than those expected by the Floquet-Markov formalism with QPG as the sole loss mechanism. Meanwhile, calculations that incorporate high-frequency cutoffs (HFCs) in the QPG conductance at approximately 17-20 GHz effectively explain the experimental observations. These results suggest limitations in either the QPG conductance model or the Markovian treatment of the QPG processes. Both possibilities possess crucial implications for handling QPG problems toward FTSQC and for a more deeper understanding of Josephson junctions.

quant-ph

Radio-Frequency Detection of Fabry-Pérot Interference and Quantum Capacitance in Long-Channel Three-Dimensional Dirac Semimetal Cd3As2 Nanowires

We demonstrate phase-coherent transport in suspended long-channel Cd3As2 nanowire devices using both direct current (DC) transport and radio-frequency (RF) reflectometry measurements. By integrating Cd3As2 nanowires with on-chip superconducting LC resonators, we achieve sensitive detection of both resistance and quantum capacitance variations. In a long-channel device (L ~ 1.8 μm), clear Fabry-Pérot (FP) interference patterns are observed in both DC and RF measurements, provide strong evidence for ballistic electron transport. RF reflectometry reveals gate-dependent modulations of the resonance frequency, arising from quantum capacitance oscillations induced by changes in the density of states and FP interference. These oscillations exhibit a quasi-periodic structure that closely correlates with the FP patterns in DC transport measurements. In another device of a Cd3As2 nanowire Josephson junction (L ~ 730 nm, superconducting Al contacts), FP interference patterns are too weak to be resolved in DC conductance but are detectable using RF reflectometry. These results demonstrate the high quality of our Cd3As2 nanowires and the versatility of RF reflectometry, establishing their potential for applications in topological quantum devices, such as Andreev qubits or gatemon architectures.

cond-mat.mes-hall

Electric Control of Polarity in Spin-Orbit Josephson Diode

The effect of spin-orbit coupling in a Josephson diode has not been elucidated due to its interplay with the complexity of Josephson devices. Here, we systematically control local electric fields in epitaxial Al-InAs Josephson junctions under in-plane magnetic fields and observe a polarity reversal of the Josephson diode. We interpret this polarity reversal as an effect of field-tunable spin-orbit coupling on nonreciprocal Josephson currents. A theoretical model, accounting for Rashba and Dresselhaus spin-orbit couplings in a planar Josephson junction containing many transverse subbands, aligns with the observed polarity reversal and its dependence on magnetic field. Our finding addresses spin-orbit control in a Josephson diode, enabling manipulation of Josephson harmonics.

cond-mat.supr-con

Diamond molecular balance: Revolutionizing high-resolution mass spectrometry from MDa to TDa at room temperature

The significance of mass spectrometry lies in its unparalleled ability to accurately identify and quantify molecules in complex samples, providing invaluable insights into molecular structures and interactions. Here, we leverage diamond nanostructures as highly sensitive mass sensors by utilizing a self-excitation mechanism under an electron beam in a conventional scanning electron microscope (SEM). The diamond molecular balance (DMB) exhibits an exceptional mass resolution of 0.36 MDa, based on its outstanding mechanical quality factor and frequency stability, along with an extensive dynamic range from MDa to TDa. This positions the DMB at the forefront of molecular balances operating at room temperature. Notably, the DMB demonstrates its ability to measure the mass of a single bacteriophage T4 by precisely locating the analyte on the device. These findings highlight the groundbreaking potential of the DMB as a revolutionary tool for mass spectrometry at room temperature.

cond-mat.mes-hall

Superconducting Nanoelectromechanical Transducer Resilient to Magnetic Fields

Nanoscale electromechanical coupling provides a unique route towards control of mechanical motions and microwave fields in superconducting cavity electromechanical devices. Though their successes in utilizing the optomechanical or electromechanical back-action effects for various purposes, aluminum imposes severe constraints on their operating conditions with its low superconducting critical temperature (1.2 K) and magnetic field (0.01 T). To extend the potential of the devices, here we fabricate a superconducting electromechanical device employing niobium and demonstrate a set of cavity electromechanical dynamics including back-action cooling and amplification, and electromechanically induced reflection at 4.2 K and in strong magnetic fields up to 0.8 T. This device could be used to realize electromechanical microwave components for quantum technologies by integrating amplifiers, converters, and circulators on a single chip that can be installed at the 4K stage of dilution refrigerators. Moreover, with its ability to control and readout nanomechanical motions simultaneously, this niobium electromechanical transducer could provide powerful nanomechanical sensing platforms.

physics.app-ph

Interplay between superconductivity and magnetism in one-unit-cell LaAlO3 capped with SrTiO3

To form a conducting layer at the interface between the oxide insulators LaAlO3 and SrTiO3, the LaAlO3 layer on the SrTiO3 substrate must be at least four unit-cells-thick. The LaAlO3 SrTiO3 heterointerface thus formed exhibits various intriguing phenomena such as ferromagnetism and superconductivity. It has been widely studied for being a low-dimensional ferromagnetic oxide superconducting system with a strong gate-tunable spin-orbit interaction. However, its lack of stability and environmental susceptiveness have been an obstacle to its further experimental investigations and applications. Here, we demonstrate that capping the bilayer with SrTiO3 relieves this thickness limit, while enhancing the stability and controllability of the interface. In addition, the SrTiO3-capped LaAlO3 exhibits unconventional superconductivity; the critical current dramatically increases under a parallel magnetic field, and shows a reversed hysteresis contrary to the conventional hysteresis of magnetoresistance. Its superconducting energy gap of $Δ\sim 1.31k_BT_c$ also deviates from conventional BCS-type superconductivity. The oxide trilayer could be a robust platform for studying the extraordinary interplay of superconductivity and ferromagnetism at the interface electron system between LaAlO3 and SrTiO3.

cond-mat.mes-hall

Directly Detecting the Edge Current in a $p_x + ip_y$ Topological Superfluid

Topological superconductors are one of the most actively studied materials these days. They are a promising candidate for hosting Majorana fermions either on their boundaries or in vortex cores. Detecting 1D edge current around the periphery of a 2D $p_x + ip_y$ superconductor would be a hallmark signature of topological superconductivity, but Majorana fermions are not amenable to electronic current measurements due to their charge neutral nature. Thermal conductivity measurements, such as thermal Hall effect, are alternatively proposed, but material synthesis must come first. Superfluid $^3$He-$A$, on the other hand, is a known $p_x + ip_y$ superfluid whose edge current can be measured with a gyroscopic technique. Here, we propose a microelectromechanical system based gyroscope that will not only have enough signal sensitivity to measure the edge current but also be used to observe dimensionality induced phase transitions between different topological superfluids.

cond-mat.supr-con

Superconducting Circuitry for Quantum Electromechanical Systems

Superconducting systems have a long history of use in experiments that push the frontiers of mechanical sensing. This includes both applied and fundamental research, which at present day ranges from quantum computing research and efforts to explore Planck-scale physics to fundamental studies on the nature of motion and the quantum limits on our ability to measure it. In this paper, we first provide a short history of the role of superconducting circuitry and devices in mechanical sensing, focusing primarily on efforts in the last decade to push the study of quantum mechanics to include motion on the scale of human-made structures. This background sets the stage for the remainder of the paper, which focuses on the development of quantum electromechanical systems (QEMS) that incorporate superconducting quantum bits (qubits), superconducting transmission line resonators and flexural nanomechanical elements. In addition to providing the motivation and relevant background on the physical behavior of these systems, we discuss our recent efforts to develop a particular type of QEMS that is based upon the Cooper-pair box (CPB) and superconducting coplanar waveguide (CPW) cavities, a system which has the potential to serve as a testbed for studying the quantum properties of motion in engineered systems.

quant-ph

Quantum Friction in Nanomechanical Oscillators at Millikelvin Temperatures

We report low-temperature measurements of dissipation in megahertz-range, suspended, single-crystal nanomechanical oscillators. At millikelvin temperatures, both dissipation (inverse quality factor) and shift in the resonance frequency display reproducible features, similar to those observed in sound attenuation experiments in disordered glasses and consistent with measurements in larger micromechanical oscillators fabricated from single-crystal silicon. Dissipation in our single-crystal nanomechanical structures is dominated by internal quantum friction due to an estimated number of roughly 50 two-level systems, which represent both dangling bonds on the surface and bulk defects.

cond-mat.other