arXiv subjects

Sho Kasumie

Publications and source records attributed to Sho Kasumie.

5 recordsLinked to original sources

arXiv2019

Raman Laser Switching Induced by Cascaded Light Scattering

We show that, in multimode Raman lasers, cascaded light scattering (CLS) not only extends the optical frequency range, but could also modulate the laser dynamics. The origin of this phenomenon is based on the fact that many Raman lasing modes are directly correlated through CLS. The coupled-mode equations only describe single-mode cascaded Raman lasers and are insufficient for describing the multimode case. In this work, we introduce additional terms to account for intermodal interaction and, thence, reveal the physical mechanism behind the mode-switching phenomenon. Additionally, mode-switching controlled solely by a single-mode pump in whispering gallery mode (WGM) silica Raman lasers is demonstrated. As the intracavity pump power is increased, laser switching happens between two adjacent WGMs in the same mode family.

physics.optics↗

arXiv2016

Tunable erbium-doped microbubble laser fabricated by sol-gel coating

In this work, we show that the application of a sol-gel coating renders a microbubble whispering gallery resonator into an active device. During the fabrication of the resonator, a thin layer of erbium-doped sol-gel is applied to a tapered microcapillary, then a microbubble with a wall thickness of 1.3 $μ$m is formed with the rare earth diffused into its walls. The doped microbubble is pumped at 980 nm and lasing in the emission band of the Er$^{3+}$ ions with a wavelength of 1535 nm is observed. The laser wavelength can be tuned by aerostatic pressure tuning of the whispering gallery modes of the microbubble. Up to 240 pm tuning is observed with 2 bar of applied pressure. It is shown that the doped microbubble could be used as a compact, tunable laser source. The lasing microbubble can also be used to improve sensing capabilities in optofluidic sensing applications.

physics.optics↗

arXiv2016

Cavity ring-up spectroscopy for dissipative and dispersive sensing in a whispering gallery mode resonator

In whispering gallery mode resonator sensing applications, the conventional way to detect a change in the parameter to be measured is by observing the steady state transmission spectrum through the coupling waveguide. Alternatively, cavity ring-up spectroscopy (CRUS) sensing can be achieved transiently. In this work, we investigate CRUS using coupled mode equations and find analytical solutions with a large spectral broadening approximation of the input pulse. The relationships between the frequency detuning, coupling gap and ring-up peak height are determined and experimentally verified using an ultrahigh \textit{Q}-factor silica microsphere. This work shows that distinctive dispersive and dissipative transient sensing can be realised by simply measuring the peak height of the CRUS signal, which might improve the data collection rate.

physics.optics↗

arXiv2016

Four-wave mixing parametric oscillation and frequency comb generation at visible wavelengths in a silica microbubble resonator

Frequency comb generation in microresonators at visible wavelengths has found applications in a variety of areas such as metrology, sensing, and imaging. To achieve Kerr combs based on four-wave mixing in a microresonator, dispersion must be in the anomalous regime. In this work, we demonstrate dispersion engineering in a microbubble resonator (MBR) fabricated by a two-CO$_2$ laser beam technique. By decreasing the wall thickness of the MBR down to 1.4 $μ$m, the zero dispersion wavelength shifts to values shorter than 764 nm, making phase matching possible around 765 nm. With the optical \textit{Q}-factor of the MBR modes being greater than $10^7$, four-wave mixing is observed at 765 nm for a pump power of 3 mW. By increasing the pump power, parametric oscillation is achieved, and a frequency comb with 14 comb lines is generated at visible wavelengths.

physics.optics↗

arXiv2016

Adiabatic excitation of a confined particle in one dimension with a variable infinitely sharp wall

It is shown that adiabatic cycles excite a quantum particle, which is confined in a one-dimensional region and is initially in an eigenstate. During the cycle, an infinitely sharp wall is applied and varied its strength and position. After the completion of the cycle, the state of the particle arrives another eigenstate. It is also shown that we may vary the final adiabatic state by choosing the parameters of the cycle. With a combination of these adiabatic cycles, we can connect an arbitrary pair of eigenstates. Hence, these cycles may be regarded as basis of the adiabatic excitations. A detailed argument is provided for the case that the particle is confined by an infinite square well. This is an example of exotic quantum holonomy in Hamiltonian systems.

quant-ph↗