arXiv subjects

Shotaro Kawano

Publications and source records attributed to Shotaro Kawano.

5 recordsLinked to original sources

arXiv2026

Femtosecond-to-millisecond holographic imaging of laser ablation dynamics

Femtosecond laser ablation redistributes optically deposited energy across electronic, structural, mechanical, and thermal degrees of freedom over timescales from femtoseconds to milliseconds. However, these coupled processes are usually measured in separate temporal ranges and through different observables, limiting quantitative comparison between early transient dynamics, residual heating, and final morphology. Here we introduce pump-probe holographic imaging that reconstructs amplitude- and phase-resolved optical fields across this full temporal range under matched imaging conditions. Applied to deep-ultraviolet femtosecond ablation of BK7 glass, the method captures the transition from early excitation and removal-stage dynamics to residual substrate heating and permanent modification. Differential phase analysis isolates sub-nanosecond evolution of the transient ablating layer and microsecond residual heating after material removal. Above the ablation threshold, crater depth increases with fluence, whereas the residual thermal signal saturates, indicating that additional absorbed energy is preferentially partitioned into material removal and ablation-related processes rather than retained as substrate heat. These results identify fluence-dependent energy partitioning as a dynamical basis of low-heat-affected femtosecond processing and establish holographic imaging as a route to tracking laser-driven nonequilibrium material transformations.

physics.optics↗

arXiv2026

Video-rate volumetric chemical imaging via mid-infrared photothermal optical diffraction tomography

Label-free vibrational microscopy provides chemically specific access to cellular structure, yet quantitative volumetric chemical dynamics in living cells remain largely inaccessible, particularly on subsecond timescales relevant to intracellular transport and structural reorganization. This limitation arises because most high-speed vibrational techniques rely on raster scanning, which constrains volumetric throughput to approximately one volume per second (vps). Although mid-infrared photothermal (MIP) imaging offers a pathway toward spatially parallel chemical detection, existing implementations have remained far below video-rate volumetric operation, reflecting a fundamental trade-off between imaging speed and signal-to-noise ratio. Here, we overcome this trade-off in MIP tomography and realize video-rate volumetric chemical imaging using mid-infrared photothermal optical diffraction tomography (MIP-ODT), achieving high photothermal sensitivity while maintaining quantitative measurement fidelity. High per-angle detectability supports volumetric reconstruction without temporal averaging, yielding a signal-to-noise ratio exceeding 70 under video-rate acquisition conditions. Consequently, volumetric imaging at 19.2 vps is achieved, representing a nearly 400-fold improvement over prior implementations. Using this capability, we performed video-rate three-dimensional tracking of lipid droplets in living cells and quantified anomalous diffusion from full volumetric trajectories, revealing heterogeneous intracellular transport behaviors that are obscured in two-dimensional measurements. We further demonstrate high-speed hyperspectral volumetric chemical imaging across a 300 cm-1 spectral window within 1 s through rapid MIR wavenumber sweeping, paving the way for real-time three-dimensional organelle-specific chemical phenotyping.

physics.optics↗

arXiv2025

Prototype sub-wavelength structure anti-reflection coating on alumina filters for ground-based CMB telescopes

We present designs and fabrication of sub-wavelength anti-reflection (AR) structures on alumina for infrared absorptive filters with passbands near 30, 125, and 250 GHz. These bands are widely used by ground-based instruments measuring the cosmic microwave background radiation. The designs are tuned to provide reflectance of 2% or less for fractional bandwidths between 51% and 72%, with each of the three primary bands containing two sub-bands. We make the sub-wavelength structures (SWS), which resemble a two-dimensional array of pyramids, using laser ablation. We measure the shapes of the fabricated pyramids and show that for incidence angles up to 20 degrees the predicted in-band average reflectance is 2% or less, in agreement with the design. The band average instrumental polarization is less than $3\times 10^{-3}$.

astro-ph.IM↗

arXiv2025

Experimental Validation of String Oscillation in Subharmonic Generation

The lowest notes produced by string instruments are typically limited by the fundamental vibration of the strings. However, precise control of bow pressure can lead to the production of even lower notes. Despite significant interest in this counterintuitive technique and various proposed explanations, no conclusive evidence has been provided, making detailed discussions of the underlying mechanism challenging. In this study, we employ high-speed imaging to visualize the spatial vibration modes of stringed instruments, confirming Helmholtz motion and its modifications under subharmonic conditions. Finite element simulations further demonstrated that increased bow pressure amplifies frictional forces, suppressing standard vibrations and allowing subharmonic frequencies to emerge. Our results provide the clear experimental validation of the mechanism underlying subharmonic sound production, providing an avenue for further exploration of vibrational and oscillatory phenomena.

physics.class-ph↗

arXiv2023

Mid-infrared optical coherence tomography with MHz axial line rate for real-time non-destructive testing

Non-destructive testing (NDT) is crucial for ensuring product quality and safety across various industries. Conventional methods such as ultrasonic, terahertz, and X-ray imaging have limitations in terms of probe-contact requirement, depth resolution, or radiation risks. Optical coherence tomography (OCT) is a promising alternative to solve these limitations, but it suffers from strong scattering, limiting its penetration depth. Recently, OCT in the mid-infrared (MIR) spectral region has attracted attention with a significantly lower scattering rate than in the near-infrared region. However, the highest reported A-scan rate of MIR-OCT has been 3 kHz, which requires long data acquisition time to take an image, unsatisfying industrial demands for real-time diagnosis. Here, we present a high-speed MIR-OCT system operating in the 3-4 um region that employs the swept-source OCT technique based on time-stretch infrared spectroscopy. By integrating a broadband femtosecond MIR pulsed laser operating at a repetition rate of 50 MHz, we achieved an A-scan rate of 1 MHz with an axial resolution of 11.6 um and a sensitivity of 55 dB. As a proof-of-concept demonstration, we imaged the surface of substrates covered by highly scattering paint coatings. The demonstrated A-scan rate surpasses previous state-of-the-art by more than two orders of magnitude, paving the way for real-time NDT of industrial products, cultural assets, and structures.

physics.optics↗