arXiv subjects

Shu-Jen Han

Publications and source records attributed to Shu-Jen Han.

11 recordsLinked to original sources

arXiv2025

Single Flux Quantum Circuit Operation at Millikelvin Temperatures

As quantum computing processors increase in size, there is growing interest in developing cryogenic electronics to overcome significant challenges to system scaling. Single flux-quantum (SFQ) circuits offer a promising alternative to remote, bulky, and power-hungry room temperature electronics. To meet the need for digital qubit control, readout, and co-processing, SFQ circuits must be adapted to operate at millikelvin temperatures near quantum processors. SEEQC's SFQuClass digital quantum management approach proximally places energy-efficient SFQ (ERSFQ) circuits and qubits in a multi-chip module. This enables extremely low power dissipation, compatible with a typical dilution cryostat's limited cooling power, while maintaining high processing speed and low error rates. We report on systematic testing from 4 K to 10 mK of a comprehensive set of ERSFQ cells, as well as more complex circuits such as programmable counters and demultiplexers used in digital qubit control. We compare the operating margins and error rates of these circuits and find that, at millikelvin, bias margins decrease and the center of the margins (i.e., the optimal bias current value) increases by ~15%, compared to 4.2 K. The margins can be restored by thermal annealing by reducing Josephson junction (JJ) critical current Ic. To provide guidance for how circuit parameters vary from 4.2 K to millikelvin, relevant analog process control monitors (PCMs) were tested in the temperature range of interest. The measured JJ critical current (of the PCM JJ arrays) increases by ~15% when decreasing temperature from 4.2 K to millikelvin, in good agreement with both theory and the empirically measured change in the center of bias margins for the tested digital circuits.

quant-ph↗

arXiv2025

Quantum Computer Controlled by Superconducting Digital Electronics at Millikelvin Temperature

Current superconducting quantum computing platforms face significant scaling challenges, as individual signal lines are required for control of each qubit. This wiring overhead is a result of the low level of integration between control electronics at room temperature and qubits operating at millikelvin temperatures, which raise serious doubts among technologists about whether utility-scale quantum computers can be built. A promising alternative is to utilize cryogenic, superconducting digital control electronics that coexist with qubits. Here, we report the first multi-qubit system integrating this technology. The system utilizes digital demultiplexing, breaking the linear scaling of control lines to number of qubits. We also demonstrate single-qubit fidelities above 99%, and up to 99.9%. This work is a critical step forward in realizing highly scalable chip-based quantum computers.

quant-ph↗

arXiv2018

Intrinsically ultrastrong plasmon-exciton interactions in crystallized films of carbon nanotubes

In cavity quantum electrodynamics, optical emitters that are strongly coupled to cavities give rise to polaritons with characteristics of both the emitters and the cavity excitations. We show that carbon nanotubes can be crystallized into chip-scale, two-dimensionally ordered films and that this new material enables intrinsically ultrastrong emitter-cavity interactions: rather than interacting with external cavities, nanotube excitons couple to the near-infrared plasmon resonances of the nanotubes themselves. Our polycrystalline nanotube films have a hexagonal crystal structure, ~25 nm domains, and a 1.74 nm lattice constant. With this extremely high nanotube density and nearly ideal plasmon-exciton spatial overlap, plasmon-exciton coupling strengths reach 0.5 eV, which is 75% of the bare exciton energy and a near record for room-temperature ultrastrong coupling. Crystallized nanotube films represent a milestone in nanomaterials assembly and provide a compelling foundation for high-ampacity conductors, low-power optical switches, and tunable optical antennas.

cond-mat.mes-hall↗

arXiv2017

Strong and broadly tunable plasmon resonances in thick films of aligned carbon nanotubes

Low-dimensional plasmonic materials can function as high quality terahertz and infrared antennas at deep subwavelength scales. Despite these antennas' strong coupling to electromagnetic fields, there is a pressing need to further strengthen their absorption. We address this problem by fabricating thick films of aligned, uniformly sized carbon nanotubes and showing that their plasmon resonances are strong, narrow, and broadly tunable. With thicknesses ranging from 25 to 250 nm, our films exhibit peak attenuation reaching 70%, quality factors reaching 9, and electrostatically tunable peak frequencies by a factor of 2.3x. Excellent nanotube alignment leads to the attenuation being 99% linearly polarized along the nanotube axis. Increasing the film thickness blueshifts the plasmon resonators down to peak wavelengths as low as 1.4 micrometers, promoting them to a new near-infrared regime in which they can both overlap the S11 nanotube exciton energy and access the technologically important infrared telecom band.

physics.optics↗

arXiv2017

Photo-Chemically Directed Self-Assembly of Carbon Nanotubes on Surfaces

Transistors incorporating single-wall carbon nanotubes (CNTs) as the channel material are used in a variety of electronics applications. However, a competitive CNT-based technology requires the precise placement of CNTs at predefined locations of a substrate. One promising placement approach is to use chemical recognition to bind CNTs from solution at the desired locations on a surface. Producing the chemical pattern on the substrate is challenging. Here we describe a one-step patterning approach based on a highly photosensitive surface monolayer. The monolayer contains chromophopric group as light sensitive body with heteroatoms as high quantum yield photolysis center. As deposited, the layer will bind CNTs from solution. However, when exposed to ultraviolet (UV) light with a low dose (60 mJ/cm2) similar to that used for conventional photoresists, the monolayer cleaves and no longer binds CNTs. These features allow standard, wafer-scale UV lithography processes to be used to form a patterned chemical monolayer without the need for complex substrate patterning or monolayer stamping.

physics.chem-ph↗

arXiv2017

Coherent plasmon and phonon-plasmon resonances in carbon nanotubes

Carbon nanotubes provide a rare access point into the plasmon physics of one-dimensional electronic systems. By assembling purified nanotubes into uniformly sized arrays, we show that they support coherent plasmon resonances, that these plasmons enhance and hybridize with phonons, and that the phonon-plasmon resonances have quality factors as high as 10. Because coherent nanotube plasmonics can strengthen light-matter interactions, it provides a compelling platform for surface-enhanced infrared spectroscopy and tunable, high-performance optical devices at the nanometer scale.

physics.optics↗

arXiv2016

Black Phosphorus Mid-Infrared Photodetectors with High Gain

Recently, black phosphorus (BP) has joined the two dimensional material family as a promising candidate for photonic applications, due to its moderate bandgap, high carrier mobility, and compatibility with a diverse range of substrates. Photodetectors are probably the most explored BP photonic devices, however, their unique potential compared with other layered materials in the mid-infrared wavelength range has not been revealed. Here, we demonstrate BP mid infrared detectors at 3.39 um with high internal gain, resulting in an external responsivity of 82 A/W. Noise measurements show that such BP photodetectors are capable of sensing low intensity mid-infrared light in the picowatt range. Moreover, the high photoresponse remains effective at kilohertz modulation frequencies, because of the fast carrier dynamics arising from BPs moderate bandgap. The high photoresponse at mid infrared wavelengths and the large dynamic bandwidth, together with its unique polarization dependent response induced by low crystalline symmetry, can be coalesced to promise photonic applications such as chip-scale mid-infrared sensing and imaging at low light levels.

cond-mat.mtrl-sci↗

arXiv2015

Power dissipation and electrical breakdown in black phosphorus

We report operating temperatures and heating coefficients measured in a multi-layer black phosphorus device as a function of injected electrical power. By combining micro-Raman spectroscopy and electrical transport measurements, we have observed a linear temperature increase up to 600K at a power dissipation rate of 0.896K\mu m^3/mW. By further increasing the bias voltage, we determined the threshold power and temperature for electrical breakdown and analyzed the fracture in the black phosphorus layer that caused the device failure by means of scanning electron microscopy and atomic force microscopy. The results will benefit the research and development of electronics and optoelectronics based on novel two-dimensional materials.

cond-mat.mtrl-sci↗

arXiv2010

Multi-carrier Transport in Epitaxial Multi-layer Graphene

Variable-field Hall measurements were performed on epitaxial graphene grown on Si-face and C-face SiC. The carrier transport involves essentially a single-type of carrier in few-layer graphene, regardless of SiC face. However, in multi-layer graphene (MLG) grown on C-face SiC, the Hall measurements indicated the existence of several groups of carriers with distinct mobilities. Electrical transport in MLG can be properly described by invoking three independent conduction channels in parallel. Two of these are n- and p-type, while the third involves nearly intrinsic graphene. The carriers in this lightly doped channel have significantly higher mobilities than the other two.

cond-mat.mes-hall↗

arXiv2010

Wafer-scale Epitaxial Graphene Growth on the Si-face of Hexagonal SiC (0001) for High Frequency Transistors

Up to two layers of epitaxial graphene have been grown on the Si-face of two-inch SiC wafers exhibiting room-temperature Hall mobilities up to 1800 cm^2/Vs, measured from ungated, large, 160 micron x 200 micron Hall bars, and up to 4000 cm^2/Vs, from top-gated, small, 1 micron x 1.5 micron Hall bars. The growth process involved a combination of a cleaning step of the SiC in a Si-containing gas, followed by an annealing step in Argon for epitaxial graphene formation. The structure and morphology of this graphene has been characterized using AFM, HRTEM, and Raman spectroscopy. Furthermore, top-gated radio frequency field effect transistors (RF-FETs) with a peak cutoff frequency fT of 100 GHz for a gate length of 240 nm were fabricated using epitaxial graphene grown on the Si face of SiC that exhibited Hall mobilities up to 1450 cm^2/Vs from ungated Hall bars and 1575 cm^2/Vs from top-gated ones. This is by far the highest cut-off frequency measured from any kind of graphene.

cond-mat.mtrl-sci↗

arXiv2008

Nanoscale control of exchange bias with BiFeO3 thin films

We demonstrate a direct correlation between the domain structure of multiferroic BiFeO3 thin films and exchange bias of Co0.9Fe0.1/BiFeO3 heterostructures. Two distinct types of interactions, an enhancement of the coercive field (exchange enhancement) and an enhancement of the coercive field combined with large shifts of the hysteresis loop (exchange bias), have been observed in these heterostructures, which depend directly on the type and crystallography of the nanoscale (2 nm) domain walls in the BiFeO3 film. We show that the magnitude of the exchange bias interaction scales with the length of 109 degree ferroelectric domain walls in the BiFeO3 thin films which have been probed via piezoresponse force microscopy and x-ray magnetic circular dichroism.

cond-mat.mtrl-sci↗