arXiv subjects

Shuaishuai Guo

Publications and source records attributed to Shuaishuai Guo.

45 records · Page 3Linked to original sources

arXiv2020

Signal Shaping for Non-Uniform Beamspace Modulated mmWave Hybrid MIMO Communications

This paper investigates adaptive signal shaping methods for millimeter wave (mmWave) multiple-input multiple-output (MIMO) communications based on the maximizing the minimum Euclidean distance (MMED) criterion. In this work, we utilize the indices of analog precoders to carry information and optimize the symbol vector sets used for each analog precoder activation state. Specifically, we firstly propose a joint optimization based signal shaping (JOSS) approach, in which the symbol vector sets used for all analog precoder activation states are jointly optimized by solving a series of quadratically constrained quadratic programming (QCQP) problems. JOSS exhibits good performance, however, with a high computational complexity. To reduce the computational complexity, we then propose a full precoding based signal shaping (FPSS) method and a diagonal precoding based signal shaping (DPSS) method, where the full or diagonal digital precoders for all analog precoder activation states are optimized by solving two small-scale QCQP problems. Simulation results show that the proposed signal shaping methods can provide considerable performance gain in reliability in comparison with existing mmWave transmission solutions.

eess.SP↗

arXiv2020

Joint Reflecting and Precoding Designs for SER Minimization in Reconfigurable Intelligent Surfaces Assisted MIMO Systems

This paper investigates the use of a reconfigurable intelligent surface (RIS) to aid point-to-point multi-data-stream multiple-input multiple-output (MIMO) wireless communications. With practical finite alphabet input, the reflecting elements at the RIS and the precoder at the transmitter are alternatively optimized to minimize the symbol error rate (MSER). In the reflecting optimization with a fixed precoder, two reflecting design methods are developed, referred as eMSER-Reflecting and vMSER-Reflecting. In the optimization of the precoding matrix with a fixed reflecting pattern, the matrix optimization is transformed to be a vector optimization problem and two methods are proposed to solve it, which are referred as MSER-Precoding and MMED-Precoding. The superiority of the proposed designs is investigated by simulations. Simulation results demonstrate that the proposed reflecting and precoding designs can offer a lower SER than existing designs with the assumption of complex Gaussian input. Moreover, we compare RIS with a full-duplex Amplify-and-Forward (AF) relay system in terms of SER to show the advantage of RIS.

eess.SP↗

arXiv2020

Reflecting Modulation

Reconfigurable intelligent surface (RIS) has emerged as a promising technique for future wireless communication networks. How to reliably transmit information in a RIS-based communication system arouses much interest. This paper proposes a reflecting modulation (RM) scheme for RIS-based communications, where both the reflecting patterns and transmit signals can carry information. Depending on that the transmitter and RIS jointly or independently deliver information, RM is further classified into two categories: jointly mapped RM (JRM) and separately mapped RM (SRM). JRM and SRM are naturally superior to existing schemes, because the transmit signal vectors, reflecting patterns, and bit mapping methods of JRM and SRM are more flexibly designed. To enhance transmission reliability, this paper proposes a discrete optimization-based joint signal mapping, shaping, and reflecting (DJMSR) design for JRM and SRM to minimize the bit error rate (BER) with a given transmit signal candidate set and a given reflecting pattern candidate set. To further improve the performance, this paper optimizes multiple reflecting patterns and their associated transmit signal sets in continuous fields for JRM and SRM. Numerical results show that JRM and SRM with the proposed system optimization methods considerably outperform existing schemes in BER.

eess.SP↗

arXiv2020

Enhanced Huffman Coded OFDM with Index Modulation

In this paper, we propose an enhanced Huffman coded orthogonal frequency-division multiplexing with index modulation (EHC-OFDM-IM) scheme. The proposed scheme is capable of utilizing all legitimate subcarrier activation patterns (SAPs) and adapting the bijective mapping relation between SAPs and leaves on a given Huffman tree according to channel state information (CSI). As a result, a dynamic codebook update mechanism is obtained, which can provide more reliable transmissions. We take the average block error rate (BLER) as the performance evaluation metric and approximate it in closed form when the transmit power allocated to each subcarrier is independent of channel states. Also, we propose two CSI-based power allocation schemes with different requirements for computational complexity to further improve the error performance. Subsequently, we carry out numerical simulations to corroborate the error performance analysis and the proposed dynamic power allocation schemes. By studying the numerical results, we find that the depth of the Huffman tree has a significant impact on the error performance when the SAP-to-leaf mapping relation is optimized based on CSI. Meanwhile, through numerical results, we also discuss the trade-off between error performance and data transmission rate and investigate the impacts of imperfect CSI on the error performance of EHC-OFDM-IM.

cs.IT↗

arXiv2019

Optical Camera Communications: Survey, Use Cases, Challenges, and Future Trends

Recently, a camera or an image sensor receiver based optical wireless communications (OWC) techniques have attracted particular interest in areas such as the internet of things, indoor localization, motion capture, and intelligent transportation systems. As a supplementary technique of high-speed OWC based on photo-detectors, communications hinging on image sensors as receivers do not need much modification to the current infrastructure, such that the implementation complexity and cost are quite low. Therefore, in this paper, we present a comprehensive survey of optical camera communication (OCC) techniques, and their use in localization, navigation, and motion capture. This survey is distinguishable from the existing reviews on this topic by covering multiple aspects of OCC and its various applications. The first part of the paper focuses on the standardization, channel characterization, modulation, coding, and synchronization of OCC systems while the second part of the article presents the literature on OCC based localization, navigation, and motion capture. Finally, in the last part of the paper, we present the challenges and future research directions of OCC.

eess.IV↗

arXiv2019

MIMO Capacity with Reduced RF Chains

This paper presents a remarkable advance for the understanding of MIMO capacity limits with insufficient RF chains. The capacity is characterized by the maximum mutual information given any vector inputs subject to not only an average power constraint but also a sparsity constraint. It is proven that the Gaussian mixture input distribution is capacity-achieving in the high signal-to-noise-ratio (SNR) regime. The optimal mixture coefficients and the covariance matrices of the Gaussian mixtures are derived and also the corresponding achievable capacity. For the special case with a single RF chain, the optimal mixture coefficients are shown to be approximately proportional to channel gains. The capacity is approximately the maximum-ratio combining (MRC) of multiple channels in the high SNR regime. We investigate the superiority of capacity-achieving techniques: Non-Uniform Spatial Modulation (NUSM) and Non-Uniform Beamspace Modulation (NUBM) by comparing them with the best antenna/beamspace selection (BAS/BBS) and the uniform spatial/beamspace modulation (USM/UBM). The comparison results reveal that the information-guided NUSM/NUBM is optimal in the high SNR regime. Numerical results are presented to validate our analysis.

eess.SP↗

arXiv2019

Signal Shaping for Generalized Spatial Modulation and Generalized Quadrature Spatial Modulation

This paper investigates generic signal shaping methods for multiple-data-stream generalized spatial modulation (GenSM) and generalized quadrature spatial modulation (GenQSM) based on the maximizing the minimum Euclidean distance (MMED) criterion. Three cases with different channel state information at the transmitter (CSIT) are considered, including no CSIT, statistical CSIT and perfect CSIT. A unified optimization problem is formulated to find the optimal transmit vector set under size, power and sparsity constraints. We propose an optimization-based signal shaping (OBSS) approach by solving the formulated problem directly and a codebook-based signal shaping (CBSS) approach by finding sub-optimal solutions in discrete space. In the OBSS approach, we reformulate the original problem to optimize the signal constellations used for each transmit antenna combination (TAC). Both the size and entry of all signal constellations are optimized. Specifically, we suggest the use of a recursive design for size optimization. The entry optimization is formulated as a non-convex large-scale quadratically constrained quadratic programming (QCQP) problem and can be solved by existing optimization techniques with rather high complexity. To reduce the complexity, we propose the CBSS approach using a codebook generated by quadrature amplitude modulation (QAM) symbols and a low-complexity selection algorithm to choose the optimal transmit vector set. Simulation results show that the OBSS approach exhibits the optimal performance in comparison with existing benchmarks. However, the OBSS approach is impractical for large-size signal shaping and adaptive signal shaping with instantaneous CSIT due to the demand of high computational complexity. As a low-complexity approach, CBSS shows comparable performance and can be easily implemented in large-size systems.

eess.SP↗

arXiv2018

Ordered Sequence Detection and Barrier Signal Design for Digital Pulse Interval Modulation in Optical Wireless Communications

This paper proposes an ordered sequence detection (OSD) for digital pulse interval modulation (DPIM) in optical wireless communications. Leveraging the sparsity of DPIM sequences, OSD shows comparable performance to the optimal maximum likelihood sequence detection (MLSD) with much lower complexity. Compared with the widely adopted sample-by-sample optimal threshold detection (OTD), it considerably improves the bit error rate (BER) performance by mitigating error propagation. Moreover, this paper proposes a barrier signal-aided digital pulse interval modulation (BDPIM), where the last of every $K$ symbols is allocated with more power as an inserted barrier signal. BDPIM with OSD (BDPIM-OSD) can limit the error propagation between two adjacent barriers. To reduce the storing delay when using OSD to detect extremely large packets, we propose BDPIM with a combination of OTD and OSD (BDPIM-OTD-OSD), within which long sequences are cut into pieces and separately detected. Approximate upper bounds of the average BER performance of DPIM-OTD, DPIM-OSD, BDPIM-OSD and BDPIM-OTD-OSD are analyzed. Simulations are conducted to corroborate our analysis. Optimal parameter settings are also investigated in uncoded and coded systems by simulations. Simulation results show that the proposed OSD and BDPIM bring significant improvement in uncoded and coded systems over various channels.

eess.SP↗

arXiv2018

Generalized Beamspace Modulation Using Multiplexing: A Breakthrough in mmWave MIMO

Spatial multiplexing (SMX) multiple-input multiple-output (MIMO) over the best beamspace was considered as the best solution for millimeter wave (mmWave) communications regarding spectral efficiency (SE), referred as the best beamspace selection (BBS) solution. The equivalent MIMO water-filling (WF-MIMO) channel capacity was treated as an unsurpassed SE upper bound. Recently, researchers have proposed various schemes trying to approach the benchmark and the performance bound. But, are they the real limit of mmWave MIMO systems with reduced radio-frequency (RF) chains? In this paper, we challenge the benchmark and the corresponding bound by proposing a better transmission scheme that achieves higher SE, namely the Generalized Beamspace Modulation using Multiplexing (GBMM). Inspired by the concept of spatial modulation, besides the selected beamspace, the selection operation is used to carry information. We prove that GBMM is superior to BBS in terms of SE and can break through the well known `upper bound'. That is, GBMM renews the upper bound of the SE. We investigate SE-oriented precoder activation probability optimization, fully-digital precoder design, optimal power allocation and hybrid precoder design for GBMM. A gradient ascent algorithm is developed to find the optimal solution, which is applicable in all signal-to-noise-ratio (SNR) regimes. The best solution is derived in the high SNR regime. Additionally, we investigate the hybrid receiver design and deduce the minimum number of receive RF chains configured to gain from GBMM in achievable SE. We propose a coding approach to realize the optimized precoder activation. An extension to mmWave broadband communications is also discussed. Comparisons with the benchmark (i.e., WF-MIMO channel capacity) are made under different system configurations to show the superiority of GBMM.

eess.SP↗